[2022年10月04日] NACE-CIP2-001のPDF問題とテストエンジンには100問があります
更新された試験エンジンはNACE-CIP2-001試験無料お試しサンプル365日更新されます
質問 60
External coatings applied to buried pipelines are generally tested for:
- A. Chalking resistance
- B. Cathodic disbondment
- C. Gloss level
- D. Solvent resistance
正解: B
質問 61
A single component water borne acrylic coating cures by:
- A. Oxidation
- B. Coalescence
- C. Solvent Evaporation
- D. Co-Reaction
正解: B
質問 62
You are working as an inspector in a galvanizing plant for the first time.
What are some of the hazards you need to be aware of:
- A. Risk of chemical exposure
- B. a), b), and c)
- C. Risk of acid or caustic splashes
- D. Risk of skin
正解: B
質問 63
Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.
- A. False
- B. True
正解: A
質問 64
The cost of qualified Coating Inspection is normally offset by:
- A. Lower Application Costs
- B. Lower Supervision Costs
- C. Lower Safety Enforcement Costs
- D. Lower Coating Life Cycle Costs
正解: D
質問 65
You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3 rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:
- A. Request a re-blast of the item in question
- B. Verbally challenge the NCR
- C. Consult your supervisor
- D. Review the NCR with the other Inspector
正解: C
質問 66
You are the new NACE Level 2 Inspector on a job which had been very problematic. The previous Inspector was fired duo to personality conflicts with the Contractor's supervisor. Upon arriving onsite the Contractor's supervisor advises you in no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action is to:
- A. Challenge the supervisor's authority
- B. Suggest to the Owner that the supervisor should be removed from site
- C. Express a willingness to work with the site team and follow the specification
- D. Defend the previous inspector
正解: C
質問 67
An Inspection and Test Plan is required when:
- A. When the Coating Applicator requests one
- B. When the Owner specifies one
- C. It is always required
- D. When the Inspector requests one
正解: C
質問 68
The Concrete Repair Institute's comparators can be used to assess:
- A. Compressive and tensile strength prior to coating
- B. Contamination levels prior to coating
- C. Surface profile prior to coating
- D. Surface cleanliness prior to coating
正解: C
質問 69
When performing an adhesion test in accordance with ASTM D 3359 where the Dry Film Thickness is approximately 10 mils, the Inspector should use:
- A. Method B - X cut
- B. Method A - Cross Hatch
- C. Method B - Cross Hatch
- D. Method A - X Cut
正解: D
質問 70
Inspectors perform tests on linings that they may not perform on exterior coatings because
- A. coatings are more durable than linings.
- B. linings protect the contents and the container.
- C. linings are more durable than coatings.
- D. coatings are expected to degrade over time.
正解: B
質問 71
The number of air turns in an enclosure can be affected by all of these EXCEPT
- A. manufacturer of the equipment.
- B. type of dehumidification equipment (refrigerant or desiccant).
- C. coating type.
- D. time of the year (winter/summer).
正解: C
質問 72
You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner's representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?
- A. SP 1 followed by acid etching
- B. SP 1 followed by SP 3
- C. SP 1 followed by SP 2
- D. SP 1 followed by caustic etching
正解: C
質問 73
A reinforced coating is
- A. less resistant to movement, abrasion, and impact than a non-reinforced coating.
- B. more resistant to movement, abrasion, and impact than a non-reinforced coating.
- C. equally resistant to abrasion and impact as a non-reinforced coating.
- D. equally resistant to movement and impact as a non-reinforced coating.
正解: B
質問 74
As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.
- A. True
- B. False
正解: A
質問 75
Which is used to calibrate a pH meter?
- A. Standard buffer solution
- B. Deionized water
- C. Distilled water
- D. Standard solvent solution
正解: A
質問 76
The Inspectors' goal at the Pre-Job Conference is to:
- A. Take accurate meeting minutes for distribution
- B. Manage the meeting so it doesn't go off topic
- C. Obtain a clear understanding of the Specification
- D. Discuss contractual requirements
正解: C
質問 77
When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:
- A. Tooke Gauge
- B. Ultra Sonic DFT Gauge
- C. Magnetic Gauge
- D. Eddy Current Gauge
正解: A
質問 78
In which type of concrete are laitance commonly encountered?
- A. Poured (wet cast)
- B. Concrete block (poured with a form)
- C. Glass fiber cement
- D. Gunite
正解: A
質問 79
When environmental enclosures are being used an inspector needs to be concerned about:
- A. Structural integrity
- B. a), b), and c)
- C. Air changes
- D. Lighting
正解: B
質問 80
You have just your NACE CIP Level 2 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:
- A. Accept assignment without hesitation
- B. Review the NACE Attestation prior to making a decision
- C. Advise the prospective employer that you cannot accept the position
- D. Meet with the prospective employer to scope of your role
正解: B
質問 81
......
試験合格保証NACE-CIP2-001試験には正確な問題解答付き：https://jp.fast2test.com/NACE-CIP2-001-premium-file.html
テストエンジンの練習テストならこれNACE-CIP2-001有効で更新された問題集：https://drive.google.com/open?id=1Dek76PiTzVjl4kDh2PBspIYIj6nJIq-o