HPE6-A72リアル試験問題解答は更新された[2023年11月08日]
お手軽に合格させる 最新HP HPE6-A72問題集には90問があります
HPE6-A72試験の準備には、さまざまなリソースを活用することができます。アルバは、試験でテストされる内容をカバーする公式のトレーニングコースを提供しています。さらに、書籍、練習問題、オンラインコースなど、多数のサードパーティの学習資料があります。
質問 # 39
What is Deep Packet Inspection?
- A. a function of Policy Based Routing that examines the entire IPv4 header to forward traffic based on factors other than destination address
- B. a firewall process of examining the packet header all the way to Layer 7 in order to determine if the packet should be permitted or denied
- C. a machine learning method of packet inspection for the purpose of choosing which dynamic routing protocol to automatically assign
- D. a concept that applies to firewalls, when examining packets only up through Layer 4
正解：B
質問 # 40
What are the benefits of a 3-Tier design over a 2-Tier? (Choose two.)
- A. Better scalability in a campus with a large number of buildings.
- B. Lowering the cost of a deployment due to needing less switches overall.
- C. Gaining the flexibility to connect the Data-Center to any Access layer switch.
- D. Offloading processing from the Core without routing at the Access layer.
- E. Can use lower speed links between Core to Aggregation and Aggregation to Access given the use of an Aggregation layer.
正解：A、D
質問 # 41
Which command can be used to find the serial number of an Aruba OS-CX switch?
- A. The command show system
- B. The command inventory
- C. The command show running-configuration
- D. The command version
正解：A
解説：
Explanation/Reference:
質問 # 42
Refer to the exhibit.
Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.
Which configuration will correct the issue?
- A. Core-2(config)# ip route 0.0.0.0/0 10.1.1.1 vrf GREEN Host-B: assign the default-gateway address 10.1.20.181
- B. Host-B: assign the default-gateway address 10.1.20.181
- C. Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN Host-B: assign the default-gateway address 10.1.20.181
- D. Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN Host-B: assign the default-gateway address 10.1.20.1
正解：C
質問 # 43
Interface 1/1/1 is up
Admin state is up
Link transitions: 1
Description: TO_PC-1
Hardware: Ethernet, MAC Address: 00:11:22:33:44:55
MTU 1500
Type 1GbT
Full-duplex
qos trust none
Speed 1000 Mb/s
Auto-negotiation is on
Flow-control: off
Error-control: off
MDI mode: MDIX
VLAN Mode: access
Access VLAN: 1111
Which command will produce the above output?
- A. show vlan 1111
- B. show interface gigabit 1/1/1
- C. show interface vlan 1111
- D. show interface 1/1/1
正解：D
質問 # 44
Refer to the exhibit.
The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?
- A. The command page
- B. The command more
- C. The command less
- D. The command terminal length 30
正解：A
質問 # 45
Match each network protocol to the correct server listening port. Not all answers will be used.
正解：
解説：
質問 # 46
Refer to the exhibit.
What VSF command produces the above output?
- A. show vsf topology
- B. show vsf member
- C. show vsf link
- D. show vsf detail
正解：A
質問 # 47
Match the term to the correct description.
正解：
解説：
質問 # 48
Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)
- A. operates only in the 5GHz similar to 802.11ac
- B. is the first WLAN standard to no longer use electromagnetic signals to transmit data
- C. operates in both the 2.4GHz and 5GHz radios bands
- D. is an emerging satellite connection standard to allow wireless access anywhere in the world
- E. allows transmissions of up to 4.8Gbps
正解：C、E
解説：
Explanation/Reference:
質問 # 49
Refer to the exhibit.
The above output is the result of issuing the command show system resource-utilization.
What command should be used to enable terminal output line by line or page by page?
- A. The command page
- B. The command more
- C. The command less
- D. The command terminal length 30
正解：A
質問 # 50
Refer to the exhibit.
What commands will successfully enable the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the command show ip interface brief in the exhibit below?
- A. Access-1(config)# interface 1/1/1
Access-1(config-if)# routing
Access-1(config-if)# interface vlan 100
Access-1(config-if-vlan)# ip address 10.1.1.1/24 - B. Access-1(config-if)# vlan 100
Access-1(config-vlan)# ip address 10.1.1.1/24 - C. Access-1(config)# interface 1/1/1
Access-1(config-if)# vlan trunk permit vlan 100
Access-1(config-if)# interface vlan 100
Access-1(config-if-vlan)# ip address static 10.1.1.1/24 - D. Access-1(config)# interface vlan 100
Access-1(config-if-vlan)# ip address 10.1.1.1/24
正解：D
質問 # 51
Refer to the exhibit.
Switch-1 is not the root bridge. The ports shown are all the connected pointtopoint interfaces. What Role (hidden by the blue rectangle) will be assigned to the Lag 1 interface?
- A. Designated
- B. Root
- C. Alternate
- D. Backup
正解：B
質問 # 52
Refer to the exhibit
Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?
- A. Access-2 (config-if-1/1/4)# vlan access 20
- B. Access-2 (config-if-1/1/4)# vlan access 1, 10, 20, 255
- C. Access-2 (config-if-1/1/4)# vlan 20 untag 1/1/4
- D. Access-2 (config-if-1/1/4)# vlan trunk allow 1, 10, 255
正解：A
質問 # 53
Refer to the exhibit.
Using the static IP address configured above, what is the converted binary value of the third octet assigned to the local interface?
- A. 0
- B. 1
- C. 01001011
- D. 2
正解：A
質問 # 54
Aruba Access Points tunnel traffic in a campus to the Mobility Controller using which protocol?
- A. Control and Provisioning of Wireless Access Points (CAPWAP)
- B. Process Application Programming Interface (PAPI)
- C. Lightweight Access Point Protocol (LWAPP)
- D. Generic Routing Encapsulation (GRE)
正解：D
質問 # 55
Refer to the exhibit
What is true regarding VLAN 50 according to the diagram above?
- A. VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.
- B. VLAN 50 was never added to the vlan-database and therefore is in a down state.
- C. VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.
- D. Since VLAN 50 has not been assigned to any enabled physical port, the status is down.
正解：D
質問 # 56
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?
- A.
- B.
- C.
- D.
正解：C
質問 # 57
Which command will suppress LLDP messages from egressing on a given port while still allowing LLDP to be enabled on the switch?
- A. switch(config-if)# no lldp interface (port) transmit
- B. switch(config-if)# no lldp receive
- C. switch(config)# no lldp
- D. switch(config-if)# no lldp transmit
正解：D
質問 # 58
What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)
- A. routing loops
- B. multiple frame copies leading to instability of the MAC address table
- C. security issues with a redundant loop indicating to hackers that a back-door exists
- D. costs associated with upgrading from copper to fiber
- E. broadcast storms
正解：B、C
質問 # 59
Which command can be used to find the serial number of an Aruba OS-CX switch?
- A. The command show system
- B. The command inventory
- C. The command show running-configuration
- D. The command version
正解：A
質問 # 60
......
最新のHPE6-A72学習ガイド2023年最新の- 提供するのはテストエンジンとPDF：https://jp.fast2test.com/HPE6-A72-premium-file.html
最新版を今すぐ試そうHPE6-A72練習テスト問題解答：https://drive.google.com/open?id=1pX0cZ2yK6QlY2COhpCDlyidFnrYtc0rt