最新版無料体験を掴み取れ！HP HPE6-A72問題集PDFは更新されたのは2023年
最新リリースのHPE6-A72問題集はAruba Certified Switching Associate (ACSA) V1認証済みです
質問 # 46
Refer to the exhibit.
The above output is the result of issuing the command show system resource-utilization.
What command should be used to enable terminal output line by line or page by page?
- A. The command more
- B. The command terminal length 30
- C. The command less
- D. The command page
正解：D
質問 # 47
Which statement is correct regarding powering an Aruba Access Point?
- A. PoE or PoE+ enabled switchports are rarely used given concerns about causing electrical interference, with the data also carried over Ethernet cabling.
- B. Using switchports for this reason is unnecessary, because Aruba Access Points typically use an AC to DC power adapter to draw power.
- C. PoE or PoE+ is only used with Ethernet that is carried over multi-mode fiber cabling.
- D. Most administrators use PoE or PoE+ enabled switchports to provide both Ethernet connectivity and power to the AP.
正解：D
質問 # 48
Match each description to the correct term.
正解：
解説：
質問 # 49
Match each description to the correct management tool for Aruba AOS-CX.
正解：
解説：
質問 # 50
What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?
- A. Better Core router performance by offloading processing
- B. Connecting WAN/MPLS and Data center access to the Aggregation layer
- C. Shifting endpoint access to the Aggregation layer from the Access layer
- D. Using access control lists (ACLs) at the Core to improve performance
正解：A
質問 # 51
Refer to the exhibit.
The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?
- A. The command more
- B. The command terminal length 30
- C. The command less
- D. The command page
正解：D
質問 # 52
Match each description to the correct term.
正解：
解説：
質問 # 53
Refer to the exhibit.
You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.
What is a valid configuration for Access-2 to join the VSF stack?
- A. Access-2# configure
Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2 2/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - B. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - C. Access-2# configure
Access-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit Access-2(config)# vsf renumber-to 2 This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - D. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
正解：B
質問 # 54
What is the correct description of a Multi-Layer Switch?
- A. any switch that supports PoE, LLDP-MED and Flow Control
- B. multi-Layer refers specifically to using chassis switches with several line cards over stack port switches
- C. a switch with Layer 3 routing capabilities but lacks any Layer 1 features as a consequence
- D. has all the functionality of a Layer 2 switch and most of the functionality of a Layer 3 router
正解：D
質問 # 55
Refer to the exhibit.
What VSF command produces the above output?
- A. show vsf link
- B. show vsf member
- C. show vsf detail
- D. show vsf topology
正解：D
質問 # 56
Review the exhibit.
As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.
Click on the interface (circled in green) where the VLAN tag will be removed.
正解：
解説：
質問 # 57
Refer to the exhibit
Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?
- A. Access-2 (config-if-1/1/4)# vlan access 20
- B. Access-2 (config-if-1/1/4)# vlan access 1, 10, 20, 255
- C. Access-2 (config-if-1/1/4)# vlan trunk allow 1, 10, 255
- D. Access-2 (config-if-1/1/4)# vlan 20 untag 1/1/4
正解：A
質問 # 58
Match the switching term to the correct definition.
正解：
解説：
質問 # 59
What is the process where a compute device converts logical data bits into the correct physical representation depending on the media?
- A. Encapsulation
- B. Modulation
- C. Demodulation
- D. Propagation
正解：A
質問 # 60
Refer to the exhibit.
All switches are running Aruba OS-CX. While working in the terminal of Access-2, you are unable to reach Server-1 using SSH.
What is the correct command to ping Server-1 from Access-2 to test reachability?
- A. Access-2# ping 172.16.1.97 vrf mgmt
- B. Access-2# ping 172.16.1.97 vrf default
- C. Access-2# ping6 172.16.1.97 vrf mgmt.
- D. Access-2# ping 172.16.1.97
正解：A
質問 # 61
Match the available stacking feature to the correct AOS-CX switch model. Stacking features may be used more than once.
正解：
解説：
質問 # 62
What are two features in a 2-Tier design that are implemented at the Access layer? (Choose two.)
- A. Deep packet inspection
- B. WAN/MPLS connectivity
- C. Endpoint Access
- D. VPN access
- E. Power over Ethernet
正解：C、E
質問 # 63
What are two methods for remotely managing an Aruba AOS-CX switch? (Choose two.)
- A. Telnet
- B. HTTPS
- C. SNMPv2c
- D. USB-C console
- E. SSH
正解：B、E
質問 # 64
Match the switching term to the correct definition.
正解：
解説：
質問 # 65
......
最新のHPE6-A72試験問題集でHP試験問題にトレーニング：https://jp.fast2test.com/HPE6-A72-premium-file.html
更新された検証済みのHPE6-A72問題集と解答で100%合格させる：https://drive.google.com/open?id=1pX0cZ2yK6QlY2COhpCDlyidFnrYtc0rt