更新された2022年06月公式問題HPE6-A72認定にはHPE6-A72問題集PDF
2022年最新のに更新された最新HPE6-A72問題集を掴み取れ！
HP HPE6-A72 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
| トピック 5 |
|
| トピック 6 |
|
| トピック 7 |
|
| トピック 8 |
|
| トピック 9 |
|
質問 27
Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)
- A. operates only in the 5GHz similar to 802.11ac
- B. is an emerging satellite connection standard to allow wireless access anywhere in the world
- C. allows transmissions of up to 4.8Gbps
- D. operates in both the 2.4GHz and 5GHz radios bands
- E. is the first WLAN standard to no longer use electromagnetic signals to transmit data
正解: C,D
解説:
Explanation/Reference:
質問 28
Refer to the exhibit
What is true regarding VLAN 50 according to the diagram above?
- A. VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.
- B. VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.
- C. Since VLAN 50 has not been assigned to any enabled physical port, the status is down.
- D. VLAN 50 was never added to the vlan-database and therefore is in a down state.
正解: C
質問 29
Which statement is true regarding modern switching requirements?
- A. Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.
- B. While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.
- C. Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.
- D. Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today's power-over-Ethernet needs.
正解: A
質問 30
Refer to the exhibit.
Switch-1 is not the root bridge. The ports shown are all the connected pointtopoint interfaces. What Role (hidden by the blue rectangle) will be assigned to the Lag 1 interface?
- A. Root
- B. Alternate
- C. Backup
- D. Designated
正解: A
質問 31
Match the terms to the correct layer of the OSI model.
正解:
解説:
質問 32
What is the binary conversion of the hexadecimal value 0x2001?
- A. 0011 0000 0000 0001
- B. 0002 0000 0000 0001
- C. 0010 0001
- D. 0010 0000 0000 0001
正解: D
質問 33
Which statement is correct regarding powering an Aruba Access Point?
- A. PoE or PoE+ is only used with Ethernet that is carried over multi-mode fiber cabling.
- B. Using switchports for this reason is unnecessary, because Aruba Access Points typically use an AC to DC power adapter to draw power.
- C. PoE or PoE+ enabled switchports are rarely used given concerns about causing electrical interference, with the data also carried over Ethernet cabling.
- D. Most administrators use PoE or PoE+ enabled switchports to provide both Ethernet connectivity and power to the AP.
正解: D
質問 34
Refer to the exhibit
What is true regarding VLAN 50 according to the diagram above?
- A. VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.
- B. VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.
- C. Since VLAN 50 has not been assigned to any enabled physical port, the status is down.
- D. VLAN 50 was never added to the vlan-database and therefore is in a down state.
正解: C
質問 35
Match each network protocol to the correct default listening port and transport protocol. Not all answers will be used.
正解:
解説:
質問 36
The following command is issued:
Switch# checkpoint rollback start
What is the result?
- A. The switch will revert the running-configuration to the checkpoint called 'start1 without a reboot.
- B. The command will fail because it is incomplete.
- C. The switch will use the checkpoint 'rollback1 as the starting configuration on next reboot.
- D. The command will fail because rollback commands must be issued from global-config mode.
正解: A
質問 37
Match each description to the correct management tool for Aruba AOS-CX.
正解:
解説:
質問 38
Which field in the IPv4 header indicates whether the IP packet carries TCP or UDP traffic?
- A. Protocol
- B. IHL
- C. TTL
- D. Identification
正解: A
質問 39
Which switches support Aruba Virtual Switching Extension (VSX)? (Choose two.)
- A. Aruba 6405
- B. Aruba 5406R
- C. Aruba 8400
- D. Aruba 8350
- E. Aruba 2930F
正解: A,C
質問 40
Which two types of routes can be found in the IP routing table of an Aruba AOS-CX switch? (Choose two.)
- A. Local
- B. RIPng
- C. EIGRP
- D. ISIS
- E. BGP
正解: A,E
質問 41
Refer to the exhibit.
The above scenario shows a packet from the Server destined for the Firewall. Switch-A and Switch-B are bundled as VSF stack. The LAG between the VSF stack and the firewall indicates a hash function to forward the packet on port 2/1/2.
Which statement is true regarding how Switch-A will forward the packet?
- A. Switch-A will forward the packet along the VSF link to Switch-B so that it will egress on port 2/1/2 per the hash function.
- B. Switch-A will forward the packet on port 1/1/2. VSF will override the typical LAG hash function used for the physical interface selection.
- C. Switch-A will drop the packet. Multi-Chassis lag to multi-chassis lag is not a supported feature of VSF.
- D. Switch-A will encapsulate the packet using GRE to forward to Switch-B in order for the packet to egress on port 2/1/2 per the hash function.
正解: A
質問 42
Which security benefit does SNMPv3 offer that SNMPv2 does not offer?
- A. Scopes
- B. Data confidentially
- C. RADIUS groups
- D. SSL encryption
正解: B
質問 43
Match the term to the correct description.
正解:
解説:
質問 44
What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?
- A. Using access control lists (ACLs) at the Core to improve performance
- B. Shifting endpoint access to the Aggregation layer from the Access layer
- C. Connecting WAN/MPLS and Data center access to the Aggregation layer
- D. Better Core router performance by offloading processing
正解: D
質問 45
What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)
- A. Management interface split detection
- B. Peer switch-based detection
- C. Loopback keepalives
- D. BFD
- E. ARP-based
正解: A,E
質問 46
......
最新のHPE6-A72試験問題集でHP試験にはトレーニング：https://jp.fast2test.com/HPE6-A72-premium-file.html
最新を提供していますHPE6-A72問題集でAruba Certified Switching Associate (ACSA) V1認定：https://drive.google.com/open?id=1pX0cZ2yK6QlY2COhpCDlyidFnrYtc0rt