[2023年10月29日] トップクラスのNS0-183練習試験問題 [Q11-Q34]

[2023年10月29日] トップクラスのNS0-183練習試験問題

実際問題を使ってNS0-183無料問題集サンプル問題と練習テストエンジン

質問 # 11
You are performing an automated upgrade of a 2-node cluster. Node-01 upgrades successfully. But during the node-02 upgrade, there is a power outage at the site. When power is restored and the nodes are booted, you receive this message: Warning: The Cluster is in a mixed version state. Update all of the nodes to the same version as soon as possible.
In this scenario, which command provides information that will help you understand the problem?

A. system node image package show
B. system node upgrade show-task-status
C. system node image show
D. system node upgrade-revert show

正解：D

質問 # 12
During handover, a customer asks you how to obtain support from NetApp after installation.
What are two responses in this scenario? (Choose two.)

A. Send an AutoSupport message from the system.
B. Contact Global Support by telephone.
C. Visit mysupport.netapp.com
D. Visit.

正解：B、C

質問 # 13
You finished a new installation and executed Config Advisor successfully. You review the physical racking and cabling on one of the controllers, and notice an amber light that was not previously on.
Which two actions should you perform before you turn over the cluster for production? (Choose two.)

A. Remove cables connected to the controller until you find the one responsible for the controller issue.
B. Execute Config Advisor again to check for new errors.
C. Let the customer know the cluster is operating normally while the amber LED is on.
D. Review AutoSupport messages which could explain the controller state.

正解：B、D

質問 # 14
Your customer regularly schedules disaster recovery tests to ensure the high availability capabilities of the ONTAP cluster.
In this scenario, which two commands would you use to perform this test? (Choose two.)

A. system node run -node NetApp-Cluster-02 -command cf giveback
B. storage failover giveback -of-node NetApp-Cluster-02
C. storage failover takeover -of-node NetApp-Cluster-02
D. system node run -node NetApp-Cluster-02 -command cf takeover

正解：B、C

質問 # 15
Which hot-swappable transceiver is required to obtain full performance from a Cisco Nexus 3232C cluster-interconnect switch?

A. QSFP28
B. SFP
C. SFP+
D. QSFP+

正解：A

質問 # 16
You are setting up a new AFF A400 that will serve iSCSI LUNs. You will have four iSCSI SVMs that each need to connect to an Internet Storage Name Service (iSNS) for discovery and management purposes.
In this scenario, which network interface is needed for each SVM to register with the name service?

A. SVM management LIF
B. intercluster LIF
C. node management LIF
D. SVM data LIF

正解：B

質問 # 17
Before installing an 8-node cluster for a customer, you want to validate compatibility with existing hardware.
Which two tools would you use to validate the configuration? (Choose two.)

A. Active IQ System Manager
B. Active IQ Config Advisor
C. Interoperability Matrix Tool
D. Hardware Universe

正解：B、C

質問 # 18
You install a 4-node cluster with an AFF A400 HA pair and a FAS8300 HA pair. After setup, you are asked to review the audit logs on each controller from a Web browser.
In this scenario, which method provides access to the logs from a Web browser?

A. ADP
B. ACP
C. SPI
D. DNS

正解：C

質問 # 19
A 4-node cluster has connectivity for both block and file access. Nodes 1 and 3 are used for file access, and nodes 2 and 4 are used for block access. During routine maintenance, node 4 is switched off and the LIFs are migrated to other nodes. Upon investigation, you see that the LIFs that serve file traffic have moved to alternative ports.
However, LIFs that serve the block have not migrated. In this scenario, what is happening?

A. The fiber switch is configured incorrectly.
B. The failover group is configured incorrectly.
C. There is a faulty SFP.
D. The LIFs that serve the block protocol do not failover.

正解：D

質問 # 20
Before installing an 8-node cluster for a customer, you want to validate compatibility with existing hardware.
Which two tools would you use to validate the configuration? (Choose two.)

A. Hardware Universe
B. Active IQ System Manager
C. Active IQ Config Advisor
D. Interoperability Matrix Tool

正解：A、D

質問 # 21
Your customer wants a newly installed AFF C190 cluster to send SNMP notifications to a trap host called OVERWATCH01.
In this scenario, which two statements are correct? (Choose two.)

A. Configure an SNMP community string on the cluster.
B. Configure DNS on the cluster.
C. Configure a trap host on the cluster.
D. Configure a firewall policy and allow SNMP.

正解：B、C

質問 # 22
You are installing a new AFF A400 cluster and need to access the cluster management LIF from a remote subnet with the fully qualified domain name (FQDN) a400.lab.netapp.com.
In this scenario, which two network components must be configured to log in to ONTAP System Manager from the remote subnet? (Choose two.)

A. DNS
B. VLAN
C. route
D. NTP

正解：A、C

質問 # 23
After properly cabling the NetApp CN1610 cluster switches, you see that joining the second node to a cluster fails because the node is not able to communicate with the other node.
In this scenario, what is causing this problem?

A. CN1610 is unsupported in newer ONTAP versions.
B. The NTP server is not set.
C. The RCF file is not loaded properly.
D. The cluster switches must be Cisco for more than two nodes in a cluster.

正解：C

質問 # 24
You use the system health subsystem show command to troubleshoot your newly installed ONTAP cluster.
In this scenario, which two health outputs would this command show you? (Choose two.)

A. shelf connectivity
B. data switch cabling
C. cluster switch cabling
D. node CPU utilization

正解：A、D

質問 # 25
A customer wants you to add a new AFF A700 HA pair to an existing 4-node AFF8080 EX cluster. The existing cluster uses NetApp CN1610 switches for the cluster connection and is using the recommended port count.
Which statement is true in this scenario?

A. You cannot mix different AFF models in the same cluster.
B. The AFF A700 is not supported with NetApp CN1610 switches/
C. There are not enough ports available on the cluster switch.
D. You cannot have more than four nodes with AFF.

正解：A

質問 # 26
Which statement about LIFs is true?

A. Cluster LIFs and data LIFs can share a port.
B. One port can host multiple data LIFs.
C. A data LIF can be associated with multiple SVMs.
D. One cluster-management LIF exists per node.

正解：B

質問 # 27
You want to create a new intercluster LIF for cross-cluster replication and use the CLI. After you create the nac101_intercluster_lif_icl LIF, you are not able to see the LIF in the list of local intercluster LIFs.

Referring to the exhibit, what is the problem?

A. The home node of the new intercluster LIF has reached the maximum of four intercluster LIFs.
B. The LIF that was created has the wrong role type.
C. The intercluster LIF has assigned an IP address that is not in the intercluster VLAN.
D. The assigned port for the intercluster e1c LIF is in the down admin state.

正解：B

質問 # 28
You are asked to add a new HA pair to an existing 2-node switchless AFF A220 cluster. You must first convert to a 2-node switched cluster using Broadcom BES-53248 cluster switches.
Which two conditions must be fulfilled before you start the migration? (Choose two.)

A. The 2-node switchless configuration must be properly set up and functioning.
B. All cluster LIFs must be in the up state and on their home ports.
C. All cluster LIFs must have an MTU size of 1500.
D. The "Enabled Switchless Cluster" option must be manually set to "false".

正解：A、B

質問 # 29
You have just finished installing and configuring an ONTAP cluster for a customer.
In this scenario, which product collects information and produces site documentation?

A. Active IQ OneCollect
B. Inventory Collect Tool
C. SnapGathers
D. NetAppDocs

正解：D

解説：
Explanation/Reference: http://197.253.9.244/ontap%209-5/Cluster%20Admin/2_Student%20Guide/STRSW-ILT- ONTAPADM_StudentGuide.pdf

質問 # 30
A customer wants to expand their 10-node AFF A700s SAN cluster on Cisco Nexus 3132Q-V interconnect switches. The customer has six AFF A700s nodes available.
In this scenario, what should you do to expand the cluster?

A. Add an expansion module to each switch and then add the six nodes.
B. Replace the switches with Cisco Nexus 5596T switches and then add the six nodes.
C. Add six nodes to the existing cluster.
D. Add two nodes to the existing cluster without exceeding the SAN cluster limit.

正解：D

質問 # 31
You just installed two nodes into an existing ONTAP cluster.

When running date on the CLI you notice that the cluster1-03 node is running behind time. You confirmed that you can reach the node management LIF of each node.
Referring to the exhibit, which statement is true?

A. The NTP is adjusting in small increments.
B. No NTP server is configured for this node.
C. The node-management LIF has to be on e0M for NTP to work.
D. The DNS is not configured for this node.

正解：D

質問 # 32
You have just installed a new AFF A220 4-node cluster with ONTAP 9.5 for a customer.
Which two cluster switches are supported in this scenario? (Choose two.)

A. Cisco Nexus 5596UP
B. NetApp CN1610
C. Cisco MDS 9148S
D. Brocade 6510

正解：A、B

質問 # 33
Click the Exhibit button.

Referring to the exhibit, what information is forwarded to syslog after you enter the scripted install commands? (Choose two.)