テスト資料D-PEMX-DY-23テストエンジン試験問題はここにある[2024年11月]
合格突破受験者シミュレーションされたD-PEMX-DY-23試験PDF問題を試そう
質問 # 75
What are the correct CLI commands to configure the management IP Address on either the MX9116n or the MX5108n switches running SmartFabric OS10?
- A. interface vlan 4020
no ip address
ip address 192.168.1.10/24
no shutdown
exit
management route 0.0.0.0/0 192.168.1.1 - B. interface vlan 4020
no ip address
ip address 192.168.1.10/24
no shutdown
exit
interface mgmt 1/1/1
no ip address
ip address 192.168.1.10/24
no shutdown
exit
management route 0.0.0.0/0 192.168.1.1 - C. interface vlan 4020
no ip address
ip address 192.168.10.10/24
no shutdown
exit
interface mgmt 1/1/1
no shutdown
exit
management route 0.0.0.0/0 192.168.10.1 - D. interface mgmt 1/1/1
no ip address
ip address 192.168.10.10/24
no shutdown
exit
management route 0.0.0.0/0 192.168.10.1
正解：B
質問 # 76
Which section of the PowerEdge MX7000 chassis provides a structure for mounting PSUs and sleds?
- A. Rear Tub
- B. Main Chassis
- C. Management Module slot
- D. Main Distribution Board
正解：B
質問 # 77
The MX9116n FSE has two single-density QSFP28 port groups, and the default setting for these two ports is 1x 100GbE.
What other Ethernet breakout configurations are supported?
- A. 4x 10GbE
1x 40GbE
4x 8 Gb
4x 32 Gb - B. 4x 16 Gb
2x 32 Gb
4x 25GbE
2x 50GbE - C. 4x 10GbE
1x 40GbE
4x 25GbE
2x 50GbE - D. 4x 10GbE
1x 40GbE
8x 25GbE
2x 50GbE
正解：C
質問 # 78
What is the minimum OME-M version required to use ATMOS?
- A. 2.10.00
- B. 1.40.00
- C. 2.00.00
- D. 1.60.50
正解：C
質問 # 79
What can be used as the firmware update source for OME-M within an MX chassis?
- A. Dell Update package
System Live Image (SLI) - B. Dell Update Package
Baseline from a Catalog - C. Server Update Utility
System Live Image (SLI) - D. Server Update Utility
Baseline from a Catalog
正解：B
質問 # 80
Refer to the exhibit.
What is shown?
- A. MX5016s
- B. MXG610s
- C. MX5108n
- D. MX5000s
正解：A
質問 # 81
Which two main components comprise a Scalable Fabric?
- A. MX9116n and the 25GbE PTM
- B. MX9116n and the MX5108n
- C. MX7116n and the MX5108n
- D. MX9116n and the MX7116n
正解：D
質問 # 82
Which MX7000 feature allows an administrator to virtualize network WWN and MAC addresses?
- A. MX Scalable Architecture
- B. Virtual Top of Rack
- C. FlexAddress
- D. Identity Pool
正解：D
質問 # 83
Which network fabric connects directly to the chassis midplane?
- A. Fabric D
- B. Fabric A
- C. Fabric B
- D. Fabric C
正解：D
質問 # 84
Which ports will be active in an MX9116n FSE if there are dual-port NICs in all the server sleds?
- A. even-numbered server-facing ports
- B. odd-numbered server-facing ports
- C. server-facing ports 9-16
- D. server-facing ports 1-8
正解：B
質問 # 85
An administrator has installed the iDRAC Service Module in the OS on a compute sled, they are unable to use its features in the iDRAC web GUI.
What is the likely cause of this issue?
- A. iDRAC Express license is installed
- B. OS and iDRAC are configured on different networks
- C. Installed OS is not supported
- D. OS to iDRAC pass-through feature is not enabled in the iDRAC
正解：D
質問 # 86
Which MX7000 chassis components does the Vertical Power Distribution Board power?
- A. IOMs
Compute sleds
Rear fans - B. Compute sleds
Right and Left Control Panels
Rear fans - C. IOMs
Rear fans
Front fans
正解：C
質問 # 87
A network administrator must implement a 100 GbE network in their MX7000 chassis group.
Which two components satisfy this requirement?
(Select 2)
- A. Z9332F-ON
- B. MX9116n
- C. MX7116n
- D. MX8116n
- E. Z9432F-ON
正解：B、D
質問 # 88
An administrator needs to start collecting detailed data points on the PowerEdge MX7000 power usage.
What is the minimum requirement?
- A. OpenManage Enterprise
- B. OME-M Advanced
- C. OpenManage Essentials
- D. OME-M Basic
正解：B
質問 # 89
A customer is implementing a clustered three-chassis solution.
Which two components are required?
(Select 2)
- A. MX9116n
- B. Pass-Through module
- C. MXG610s
- D. MX7116n
正解：A、D
質問 # 90
A system administrator is designing a solution for a customer who will be purchasing a large number of PowerEdge MX7000 chassis. For ease of management, they would like to have the least number of chassis management groups as possible.
What is the maximum number of MX7000 chassis that are supported in a multi-chassis management group?
- A. 0
- B. 1
- C. 2
- D. 3
正解：C
質問 # 91
What are two requirements to achieve 100 GbE network speeds for a compute sled?
(Select 2)
- A. MX9116n
- B. Quad-port NIC
- C. MX7116n
- D. Dual-port NIC
- E. Z9432F-ON
正解：A、B
質問 # 92
In SmartFabric mode, what is the recommended maximum number of VLANs per server port on an MX7000 switch?
- A. 0
- B. 1
- C. 2
- D. 3
正解：D
質問 # 93
An administrator has been tasked with specifying hardware for a deployment having the following requirements:
4 node cluster within a single MX7000 chassis
Each node needs a minimum of 6x 2.5" drives
3 TB of memory and 64 physical CPU cores per node
What is the maximum hardware configuration that meets the requirements?
- A. MX840c with no storage sleds
- B. MX 840c with MX5016s storage sleds
- C. MX740c with no storage sleds
- D. MX740c with MX5016s storage sleds
正解：B
質問 # 94
The iSM is available under which license(s)?
- A. iDRAC Enterprise only
- B. iDRAC Express only
- C. iDRAC Express and iDRAC Enterprise
- D. OpenManage Enterprise-Modular
正解：C
質問 # 95
Which SmartFabric Services Engine component is responsible for managing requested changes for the specific switching node?
- A. SFS Controller
- B. Fabric Agent
- C. External Fabric Manager
正解：B
質問 # 96
Which statement describes L2 Multicast as implemented on the PowerEdge MX7000 IOM?
- A. MLD snooping controls the flooding of IPv6 multicast traffic on VLANs while the IGMP limits the flooding of IPv4 multicast traffic.
- B. MLD snooping and IGMP control or limit the flooding of IPv6 multicast traffic on VLANs.
- C. MLD snooping and IGMP control or limit the flooding of IPv4 multicast traffic on VLANs.
- D. MLD snooping controls the flooding of IPv4 multicast traffic on VLANs while the IGMP limits the flooding of IPv6 multicast traffic.
正解：A
質問 # 97
What are the port specifications of the MX8116n FEM?
- A. Two QSFP56-DD interfaces 16 internal 100 GbE server-facing or 8 internal 25 GbE server-facing
- B. Four QSFP56-DD interfaces 16 internal 100 GbE server-facing or 8 internal 25 GbE server-facing
- C. Four QSFP56-DD interfaces 8 internal 100 GbE server-facing or 16 internal 25 GbE server-facing
- D. Two QSFP56-DD uplink ports 8 internal 100 GbE server-facing or 16 internal 25 GbE server-facing
正解：D
質問 # 98
A server administrator wants to configure RAID on drives that are assigned to a compute sled.
Which interface can be used to complete the task?
- A. OIDC
- B. Storage sled assignment
- C. RAID Controller settings
- D. iDRAC
正解：D
質問 # 99
When performing "A1 the Box" management, what must be done to successfully connect to the Management Module?
- A. Configure PuTTY for a serial connection
- B. Attach standard A-to-A USB cable to a laptop
- C. Connect cables to the KVM
- D. Change the baud rate to 128000
正解：A
質問 # 100
......
正真正銘で最適なD-PEMX-DY-23オンライン練習試験資料：https://jp.fast2test.com/D-PEMX-DY-23-premium-file.html