最新F5 201一発合格！試験リアル問題集最新の[2025年05月]
良質な201問題集はここFast2test問題はあなたの合格させて見せます。明るい未来はクリックから始まる！
質問 # 28
Refer to the exhibit.
During a planned upgrade lo a BIG-IP HA pair running Active/Standby, an outage to application traffic is reported shortly after the Active unit is forced to Standby Reverting the flower resolves the outage. What should the BIG-IP Administrator modify to avoid an outage during the next for over event?
- A. The Tag voice on the Standby device
- B. The interface on the Active device to 1.1
- C. The Interface on the Standby device to 1.1
- D. The Tag value on the Active device
正解：A
質問 # 29
Which two statements are true about SNATs. (Choose two.)
- A. SNATs are enabled on all VLANs, by default.
- B. SNAT's are enabled only on the VLAN where origin traffic arrives, by default
- C. SNATs can be configured within a Profile definition.
- D. SNATs can be configured within a Virtual Server definition.
正解：A、D
質問 # 30
A 8IG-IP Administrator configures a node with a standard icmp Health Monitor. The Node shows as DOWN although the Backend Server is configured to answer ICMP requests. Which step should the administrator take next to find the root cause of this issue?
- A. Run a qkview
- B. Run a curl Run a qkview
- C. Runatcpdump
- D. Runanssldump
正解：C
質問 # 31
How is persistence configured?
- A. Persistence is an option for each pool member. When a pool is defined, each member's definition includes the option for persistence.
- B. Persistence is a profile type; an appropriate profile is created and associated with virtual server.
- C. Persistence is a global setting; once enabled, loadbalancing choices are superceded by the persistence method that is specified.
- D. Persistence is an option within each pool's definition.
正解：B
質問 # 32
Some users who connect to a busy Virtual Server have connections reset by the BIG-IP system. Pool member resources are NOT a factor in this behavior. What is a possible cause for this behavior?
- A. The Connection Limit is set too low.
- B. The Rewrite Profile has NOT been configured.
- C. The server SSL Profile has NOT been reconfigured.
- D. The Connection Rate Limit is set too high
正解：A
解説：
The topic explains that the connection reset behavior is caused by the vs configuration rather than the server resource problem. The answers B C are all configuration at the service forwarding level. If there is a problem with the configuration, it is all a problem rather than some users. Answer C's Connection Limit will cause a reset behavior when the connection reaches the threshold.
質問 # 33
A BIG-IP Administrator plans to upgrade a BIG-IP device to the latest TMOS version.
Which two tools could the administrator leverage to verify known issues for the target versions?
(Choose two.)
- A. F5 University
- B. FSiHealth
- C. F5 Bug Tracker
- D. F5 Downloads
- E. F5 End User Diagnostics (EUD)
正解：B、C
解説：
Explanation
F5 University -- F5 learning materials
F5 Downloads - iso download page
F5 End User Diagnostics (EUD) -- Hardware detection
質問 # 34
Refer to the exhibit.
A BIG-IP Administrator needs to fall over the active device. The administrator logs into the Configuration Unity and navigates to Device Management > Traffic Group. However, Force to Standby is greyed out What is causing this issue?
- A. The BIG-IP Administrator is on the Standby Device
- B. The BIG-IP Administrator is logged in as root
- C. The BIG-IP Administrator is NOT logged into command line to tail over
- D. The BIG-IP Administrator is logged in as administrator
正解：A
質問 # 35
If a client's browser does not accept cookies, what occurs when the client connects to a virtual server using cookie persistence.
- A. The connection request is sent to an
pology.server.The connection request is sent to an .pology.server. - B. The connection request is not processed.
- C. The connection request is refused and the client is sent a "server not available" message.
- D. The connection request is loadElbalanced to an available pool member.
正解：D
質問 # 36
A BIG-IP Administrator receives an RMA replacement for a failed F5 device. The BIG-IP Administrator tries to restore a UCS taken from the previous device, but the restore fails. The following error appears inthe/var/log/itm.
mcpd [****J: ******;0; License is not operational (expired or digital signature does not match contents.) What should the BIG-IP Administrator do to avoid this error?
- A. Reactivate the license on the new device using the manual activation method
- B. Use the appropriate tmsh command with the no-license option
- C. Remove the license information from the UCS archive
- D. Revoke the license prior to restoring
正解：B
質問 # 37
Where is connection mirroring configured.
- A. It is an optional feature of each virtual server.
- B. It is not configured; it is default behavior.
- C. It is an optional feature of each pool.
- D. It an option within a TCP profile.
正解：A
質問 # 38
An LTM device has a virtual server mapped to www.f5.com with a pool assigned. Users report that when browsing, they are periodically required to re-login to /resources/201.1.7.b.2_l.com. The objects are defined as follows:
Virtual server. Destination 192.168.245.100:443 netmask 255.255.255.0
Persistence: SSL session persistence
Profiles: HTTP/TCP
Which persistence method should the BIG-IP Administrator apply to resolve this issue?
- A. SIP
- B. Destination address affinity
- C. hexadecimal
- D. Source address affinity
正解：D
質問 # 39
Refer to the exhibit.
The BIG-IP Administrator is investigating disk utilization on the BIG-IP device.
What should the BIG-IP Administrator check next?
- A. Results from the EUD test
- B. Large files on /usr file system
- C. Results from the platform diagnostics test
- D. Large files on the / file system
正解：D
質問 # 40
A BIG-IP Administrator is setting up a new BIG-IP device. The network administrator reports that the interface has an incompatible media speed. The BIG-IP Administrator needs to change this setting manually.
From which location should the BIG-IP Administrator perform this task?
- A. In the Configuration Utility, Network > Interface
- B. In the Configuration Utility, System > Configuration
- C. On the Front Console
- D. In the TMOS Shell Command line
正解：A
質問 # 41
Refer to the exhibit.
A
user notifies the BIG-IP Administrator that http://remote company.com is NOT accessible. Remote access to company resources must be encrypted.
What should the BIG-IP Administrator do to fix the issue?
- A. Change the Type of the Virtual Server remote.company.com_vs to Forwarding
- B. Add an iRule to remote.company.com_vs to redirect Traffic to HTTPS
- C. Add a Pool to the Virtual Server remote.company.com_VS
- D. Change the Listening Port on remote.company.com_vs to Port 80
正解：B
解説：
Explanation
Requiring all traffic to be HTTPS access requires HTTP requests to be redirected directly to HTTPS.
質問 # 42
Refer to the exhibit.
A BIG-IP Administrator creates a new Virtual Server to load balance SSH traffic. Users are unable to log on to the servers.
What should the BIG-IP Administrator do to resolve the issue?
- A. Set Source Address to 10.1.1.2
- B. Set Protocol to UDP
- C. Set Destination Addresses/Mask to 0.0.0.0/0
- D. Set HTTP Profile to None
正解：D
質問 # 43
As a part of the Setup Utility, the administrator sets the host name for the BEl IGP.
What would be the result if the two systems in a redundant pair were set to the
same host name.
- A. The first
time
the systems
are synchronized
the receiving
system will be assigned the same selfElIP addresses as the source system. - B. In a redundant pair, the two systems will always have the same host name. The parameter is synchronized between the systems.
- C. When the administrator attempts to access the configuration utility using the host name, they will always connect to the active system.
- D. Host names do not matter in redundant pair communication.
正解：A
質問 # 44
A development team needs to apply a software fix and troubleshoot one of its servers. The BIG-IP Administrator needs to immediately remove all connections from the BIG-IP system to the back end server. The BIG-IP Administrator checks the Virtual Server configuration and finds that a persistence profile is assigned to it. What should the 8IG-IP Administrator do to meet this requirement?
- A. Set the pool member to a Disabled state and manually delete existing connections through the command line.
- B. Set the pool member to a Forced Offline state and manually delete easting connections through the command line.
- C. Set the pool member to a Disabled state.
- D. Set the pool member to a Forced Offline state.
正解：B
質問 # 45
Which two statements
describe differences
between the active and standby systems. (Choose two.)
- A. FailElover triggers only cause changes on the active system.
- B. Floating selfElIP addresses are hosted only by the active system.
- C. Virtual server addresses are hosted only by the active system.
- D. Configuration changes can only be made on the active system.
- E. Monitors are performed only by the active system.
正解：B、C
質問 # 46
In the BIG-IP Configuration Utility, a user requests a single screen view to determine the status of all Virtual Servers and associated pool members, as well as any iRules in use. Where should the BIG-IP Administrator instruct the user to find this view?
- A. Local Traffic > Virtual Servers
- B. Local Traffic > Network Map
- C. Statistics
- D. Local Traffic > Monitors
正解：B
解説：
Network Map can display vs and its associated pool, pool member, and irule, can be retrieved, and can be quickly linked.
質問 # 47
......
F5練習テストエンジン201問題：https://drive.google.com/open?id=1vMszc3k1eCmbWGsGmosHHM-0pC4UmNO4
試験合格保証有効なF5 201問題集：https://jp.fast2test.com/201-premium-file.html