200-301練習試験と学習ガイドは厳密検証された最新な970問題 [Q271-Q293]

Share

200-301練習試験と学習ガイドは厳密検証されたFast2test最新な970問題

2024年最新のな厳密検証された合格させる200-301学習ガイドベズトお試しセット


シスコ認定ネットワークアソシエイト(CCNA)認定資格は、IT業界で最も広く認知され尊重される資格の1つです。この認定は、小規模から中規模の企業ネットワークをインストール、構成、運用、トラブルシューティングするために必要な基本的な知識とスキルをテストするために設計されています。最新版のCCNA認定試験は、2020年2月に導入されたCisco 200-301です。


Cisco 200-301試験では、あらゆるネットワークエンジニアまたは技術者に不可欠なさまざまなトピックをカバーしています。これらのトピックには、ネットワークの基礎、ネットワークアクセス、IP接続、IPサービス、セキュリティの基礎、自動化とプログラマ性が含まれます。また、この試験では、ネットワークデバイスの構成、トラブルシューティング、管理機能、およびワイヤレスネットワーキングとネットワークアーキテクチャに関する知識について候補者をテストします。

 

質問 # 271
Drag and drop the statements about AAA from the left onto the corresponding AAA services on the right. Not all options are used.

正解:

解説:

Explanation:


質問 # 272
Refer to the exhibit.

If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?

  • A. PC
  • B. router
  • C. DHCP client
  • D. access point

正解:C


質問 # 273
Refer to the exhibit.

On R1 which routing protocol is in use on the route to192.168.10.1?

  • A. RIP
  • B. EIGRP
  • C. OSPF
  • D. IGRP

正解:B


質問 # 274
A Cisco engineer at a new branch office is configuring a wireless network with access points that connect to a controller that is based at corporate headquarters Wireless client traffic must terminate at the branch office and access-point survivability is required in the event of a WAN outage Which access point mode must be selected?

  • A. OfficeExtend with high availability disabled
  • B. Lightweight with local switching disabled
  • C. Local with AP fallback enabled
  • D. FlexConnect with local switching enabled

正解:A


質問 # 275
Refer to the exhibit.

A packet is being sent across router R1 to host 172.16.0.14. What is the destination route for the packet?

  • A. 209.165.200.250 via Serial0/0/0
  • B. 209.165.200.254 via Serial0/0/1
  • C. 209.165.200.246 via Serial0/1/0
  • D. 209.165.200.254 via Serial0/0/0

正解:B


質問 # 276
Refer to the exhibit.

All interfaces are in the same VLAN. All switches are configured with the default STP priorities. During the STP electronics, which switch becomes the root bridge?

  • A. MDF-DC-4:08:E0:19: 08:B3:19
  • B. MDF-DC-08:0E:18:22:05:97
  • C. MDF-DC-3:08:0E:18::1A:3C:9D
  • D. MDF-DC-1:DB:E:44:02:54:79

正解:B


質問 # 277
Refer to the exhibit.

Rapid PVST+ mode is on the same VLAN on each switch. Which switch becomes the root bridge and why?

  • A. SW1, because its priority is the lowest and its MAC address is higher
  • B. SW2, because its MAC address is the highest
  • C. SW3, because its priority is the highest
  • D. SW4, because its priority is highest and its MAC address is lower

正解:C


質問 # 278
Drag and drop the characteristics of networking from the left onto the networking types on the right.

正解:

解説:


質問 # 279
Refer to the exhibit.

Each router must be configured with the last usable IP address in the subnet. Which configuration fulfills this requirement?

  • A. Option C
  • B. Option D
  • C. Option A
  • D. Option B

正解:A


質問 # 280
Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?

  • A. Bronze
  • B. Silver
  • C. Platinum
  • D. Gold

正解:C

解説:
Reference:
Cisco Unified Wireless Network solution WLANs support four levels of QoS: Platinum/Voice, Gold/Video, Silver/Best Effort (default), and Bronze/Background.


質問 # 281
Which resource is able to be shared among virtual machines deployed on the same physical server?

  • A. operating system
  • B. applications
  • C. disk
  • D. VM configuration file

正解:C


質問 # 282
An engineer must configure a/30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?

  • A.
  • B.
  • C.
  • D.

正解:D


質問 # 283
In software-defined architecture, which place handles switching for traffic through a Cisco router?

  • A. Control
  • B. Data
  • C. Management
  • D. application

正解:B

解説:
Data plane-Handles all the data traffic. The basic functionality of a Cisco NX-OS device is to forward packets from one interface to another. The packets that are not meant for the switch itself are called the transit packets. These packets are handled by the data plane


質問 # 284
An engineer is configuring router R1 with an IPv6 static route for prefix
2019:C15C:0CAF:E001::/64.
The next hop must be 2019:C15C:0CAF:E002::1. The route must be reachable via the R1 Gigabit
0/0 interface.
Which command configures the designated route?

  • A. R1(config-if)#ip route 2019:C15C:0CAF:E001::/64 GigabitEthernet0/0
  • B. R1(config-if)#ipv6 route 2019:C15C:0CAF:E001::/64 2019:C15C:0CAF:E002::1
  • C. R1(config)#ip route 2019:C15C:0CAF:E001::/64 GigabitEthernet0/0
  • D. R1(config)#ipv6 route 2019:C15C:0CAF:E001::/64 2019:C15C:0CAF:E002::1

正解:D


質問 # 285
Refer to the exhibit.
Traffic from R1 to the 10.10.2.0/24 subnet uses 192.168.1.2 as its next hop. An network engineer wants to update the R1 configuration so that traffic with destination 10.10.2.1 passes through router R3, and all other traffic to the 10.10.20/24 subnet passes through r2. Which command must be used?

  • A. Ip route 10.10.2.0 255.255.255.0 192.168.1.4 100
  • B. Ip route 10.10.2.1 255.255.255.255 192.168.1.4 100
  • C. Ip route 10.10.2.1 255.255.255.255 192.168.1.4 115
  • D. Ip route 10.10.2.0 255.255.255.0 192.168.1.4 115

正解:B


質問 # 286
On a corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?

  • A. a router with subinterfaces configured on the physical interface that is connected to the switch
  • B. a router with an IP address on the physical interface connected to the switch
  • C. a switch with an access link that is configured between the switches
  • D. a switch with a trunk link that is configured between the switches

正解:A

解説:
Different VLANs can't communicate with each other , they can communicate with the help of Layer3 router. Hence , it is needed to connect a router to a switch , then make the sub-interface on the router to connect to the switch, establishing Trunking links to achieve communications of devices which belong to different VLANs.


質問 # 287
Refer to the exhibit.

Give this output for SwitchC, what should the network administrator's next action be?

  • A. Check the trunk encapsulation mode for SwitchA's fa0/2 port.
  • B. Check the duplex mode for SwitchC's fa0/1 port.
  • C. Check the trunk encapsulation mode for SwitchC's fa0/1 port.
  • D. Check the duplex mode for SwitchA's fa0/2 port.

正解:D


質問 # 288
A router running EIGRP has learned the same route from two different paths Which parameter does the router use to select the best path?

  • A. cost
  • B. adminstrative distance
  • C. as-path
  • D. metric

正解:D

解説:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric. For example, RIP uses hop counts as a metric, while OSPF uses cost.


質問 # 289
Which prompt dose a Cisco switch display when it is running in privileged exec mode?

  • A. switch#
  • B. switch (config)#
  • C. switch (config-if)#
  • D. switch>

正解:A


質問 # 290
What is the primary purpose of private address space?

  • A. conserve globally unique address space
  • B. simplify the addressing in the network
  • C. limit the number of nodes reachable via the Internet
  • D. reduce network complexity

正解:D


質問 # 291
Drag and drop the DHCP snooping terms from the left onto the descriptions on the right.

正解:

解説:


質問 # 292
Refer to the exhibit.

The DHCP server and clients are connected to the same switch. What is the next step to complete the DHCP configuration to allow clients on VLAN 1 to receive addresses from the DHCP server?

  • A. Configure the ip dhcp snooping trust command on the interface that is connected to the DHCP server.
  • B. Configure the Ip dhcp relay information option command on the interface that is connected to the DHCP server.
  • C. Configure the ip dhcp relay information option command on the interface that is connected to the DHCP client.
  • D. Configure the ip dhcp snooping trust command on the interlace that is connected to the DHCP client.

正解:A


質問 # 293
......

究極のガイドは200-301最新時間限定今すぐダウンロード!:https://jp.fast2test.com/200-301-premium-file.html

2024年最新のな厳密検証された合格できる200-301試験にはリアル問題と解答:https://drive.google.com/open?id=1udQ6TUV9TG7gUKkVIlWH321U7oht77w3


弊社を連絡する

我々は12時間以内ですべてのお問い合わせを答えます。

我々の働いている時間: ( GMT 0:00-15:00 )
月曜日から土曜日まで

サポート: 現在連絡 

English Deutsch 繁体中文 한국어