良質な200-301のPDF問題集で200-301試験問題を試せます
一番最新のCisco 200-301試験問題集PDF2024年更新
シスコ200-301認定試験は、複数の言語で提供され、世界中で利用可能です。コンピュータベースの試験であり、複数選択問題と実世界シナリオをシミュレートしています。試験時間は120分で、合格点は1000点中825点です。試験料金は、候補者の場所と通貨によって異なり、変更される場合があります。
質問 # 506 
Refer to the exhibit. An administrator must configure interfaces GM/1 and GM/3 on switch SW11. PC-1 and PC-2 must be placed in the Data VLAN, and Phone-1 must be placed in the Voice VLAN. Which configuration meets these requirements?
- A. Option C
- B. Option B
- C. Option A
- D. Option D
正解：D
質問 # 507
Refer the exhibit.
What is the cause of poor performance on router R19?
- A. speed and duplex mismatch
- B. excessive collisions
- C. port oversubscription
- D. excessive CRC errors
正解：B
質問 # 508
Refer to the exhibit.
If OSPF Is running on this network, how does Router2 handle traffic from Site B to 10.10.13.128/25 at Site A?
- A. It sends packets out of interface Fa0/1.
- B. It sends packets out of interface FaO/2.
- C. It load-balances traffic out of Fa0/1 and Fa0/2.
- D. It is unreachable and discards the traffic.
正解：D
質問 # 509
Which component of an Ethernet frame is used to notify a host that traffic is coming?
- A. preamble
- B. start of frame delimiter
- C. Type field
- D. Data field
正解：A
解説：
Preamble is a 7 Byte field in the Ethernet frame which helps to receiver to know that it is an actual data ( Ethernet Frame) and not some random noise in the transmission medium. It acts like a doorbell telling about the incoming data.
質問 # 510 
Refer to the exhibit Which route type does the routing protocol Code D represent in the output?
- A. statically assigned route
- B. internal BGP route
- C. /24 route of a locally configured IP
- D. route learned through EIGRP
正解：D
質問 # 511
Refer to the exhibit.
How many JSON objects are represented?
- A. 0
- B. 1
- C. 2
- D. 3
正解：B
質問 # 512 
Refer to the exhibit. An engineer must translate the PC1 IP address to 10.199.77.100 and permit PC1 to ping the loopback 0 on router R2. What command set must be used?
- A.
- B.
- C.
- D.
正解：B
質問 # 513
Refer to Exhibit.
An engineer is configuring the NEW York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)
- A. ipv6 router 2000::1/128 2012::2
- B. ipv6 router 2000::1/128 2012::1 5
- C. ipv6 router 2000::1/128 2023::3 5
- D. ipv6 router 2000::1/128 2012::1
- E. ipv6 router 2000::1/128 2023::2 5
正解：C、D
解説：
Explanation
Floating static routes are static routes that have an administrative distance greater than the administrative distance (AD) of another static route or dynamic routes. By default a static route has an AD of 1 then floating static route must have the AD greater than 1. Floating static route has a manually configured administrative distance greater than that of the primary route and therefore would not be in the routing table until the primary route fails.
質問 # 514
What is a function of MAC address learning?
- A. lt increases security on the management VLAN
- B. It is disabled by default on all interfaces connected to trunks
- C. It is enabled by default on all VLANs and interfaces
- D. It increases the potential for MAC address flooding.
正解：A
質問 # 515
Drag and drop the REST API call method for HTTP from the left onto the action they perform on the right.
正解：
解説：
質問 # 516
Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right
正解：
解説：
質問 # 517
Which spanning-tree enhancement avoids the learning and listening states and immediately places ports in the forwarding state?
- A. BPDUguard
- B. Backbonefast
- C. PortFast
- D. BPDUfilter
正解：C
解説：
Section: Network Access
質問 # 518
Refer to the exhibit.
An engineer configured NAT translations and has verified that the configuration is correct.
Which IP address is the source IP?
- A. 172.23.104.4
- B. 10.4.4.5
- C. 172.23.103.10
- D. 10.4.4.4
正解：A
質問 # 519
Refer to the exhibit An engineer must configure GigabitEthemet1/1 to accommodate voice and data traffic. Which configuration accomplishes this task?
- A. Option B
- B. Option A
- C. Option D
- D. Option C
正解：D
質問 # 520
Refer to the exhibit.
Traffic sourced from the loopback0 Interface is trying to connect via ssh to the host at 10.0.1.15. What Is the next hop to the destination address?
- A. 192.168.0.7
- B. 192.168.0.4
- C. 192.168.3.5
- D. 192.168.0.40
正解：B
質問 # 521
Which configuration register value can you set on a Cisco device so that it ignores the NVRAM when it boots?
- A. 0x2102
- B. 0x2124
- C. 0x2142
- D. 0x2120
正解：C
質問 # 522
Drag and drop the AAA features from the left onto the corresponding AAA security services on the right. Not all options are used.
正解：
解説：
Explanation
質問 # 523
Drag and drop the facts about wireless architectures from the left onto the types of access point on the right. Not all options are used.
正解：
解説：
質問 # 524
Drag and drop the SNMP components from the left onto the descriptions on the right.
正解：
解説：
質問 # 525
Refer to the exhibit.
To which device does Router1 send packets that are destined to host 10.10.13.165?
- A. Router3
- B. Router5
- C. Router2
- D. Router4
正解：A
質問 # 526
Drag and drop the SNMP components from the left onto the descriptions on the right.
正解：
解説：
質問 # 527
......
Cisco 200-301 資格試験は、ネットワーク業界でキャリアを確立したい人や、この分野での知識とスキルを肯定したい人に最適です。この試験は、ルーター、スイッチ、ファイアウォールなどのさまざまなネットワークデバイスを構成、トラブルシューティング、管理する能力を試験します。この試験に合格することは、候補者がネットワークの概念をしっかりと理解し、複雑なネットワークソリューションを設計、実装することができることを示し、ネットワーク業界でネットワーク管理者、ネットワークエンジニア、ネットワークアーキテクトなどの役割を担うことができる広範なキャリア機会を開くことができます。
Cisco 200-301は、ネットワークエンジニアのための入門レベルの認定試験であり、ネットワークの基礎知識に関する知識と技能を検証することを目的としています。この試験は、以前のCCNA認定試験の代替となり、ネットワーク技術に関連する幅広いトピックをカバーしており、ネットワークアクセス、IP接続、IPサービス、セキュリティの基礎、自動化およびプログラマビリティなどが含まれます。
100%無料CCNA 200-301問題集PDFお試しサンプル認定ガイドカバー率：https://jp.fast2test.com/200-301-premium-file.html
PDF試験材料は2024年最新の実際に出る200-301問題集：https://drive.google.com/open?id=1lFhK8HKTIJestTg_ex7Bja8KiYw4JLQn