有効な2V0-41.20テスト解答VMware 2V0-41.20試験PDF問題を試そう
VMware 2V0-41.20認定リアル2023年最新の模擬試験合格させます
質問 # 12
Which two choices are prerequisites to configure NSX-T on VDS? (Choose two.)
- A. vSphere Distributed Switch 7.0
- B. MTU 1400
- C. MTU 1600
- D. MTU 1500
- E. vSphere Distributed Switch 6.5
正解：A、C
解説：
Explanation
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/installation/GUID-BA34FB2A-6780-41C5-B895
質問 # 13
Which two commands are used to query the arp-table of a logical switch? (Choose two.)
- A. get logical-switch arp-table <logical-switch-uuid>
- B. get logical-switch arp-table <vni>
- C. get logical-switch arp-table
- D. get logical-switch <vni> arp-table
- E. get logical-switch <logical-switch-uuid> arp-table
正解：D、E
質問 # 14
An NSX administrator has configured a KVM hypervisor as a transport node.
Which kernel module on KVM implements a N-VDS?
- A. nsx-vswitch
- B. etherswitch
- C. dyswitch
- D. openvswitch
正解：D
質問 # 15
An NSX administrator is configuring the KVM hypervisor host as a transport node and wants to apply the Failover Order as a NIC teaming policy.
Which profile allows the administrator to configure the NIC Teaming policy as Failover Order?
- A. Transport Node Profile
- B. Host Switch Profile
- C. Uplink Profile
- D. N-VDS/VDS Profile
正解：C
質問 # 16
What needs to be configured on a Tier-0 Gateway to make NSX Edge Services available to a VM on a VLAN- backed logical switch?
- A. VLAN Uplink
- B. Loopback Router Port
- C. Service interface
- D. Downlink interface
正解：C
解説：
"The service interface is a special-purpose port to enable services for mainly VLAN-based networks. North-south service insertion is another use case that requires a service interface to connect a partner appliance and redirect north-south traffic for partner services. Service interfaces are supported on both active-standby Tier-0 logical routers and Tier-1 routers. Firewall, NAT, and VPNs are supported on this interface. The service interface is also a downlink"
質問 # 17
Which two tools are used to configure centralized logging in NSX-T Data Center? (Choose two.)
- A. vRealize Automation
- B. vRealize Log Insight
- C. vRealize Operations
- D. vRealize Network Insight
- E. Syslog Server
正解：B、E
質問 # 18
An NSX administrator is creating a Tier-1 Gateway configured in Active-Standby High Availability Mode. In the event of node failure, the failover policy should not allow the original failed node to become the Active node upon recovery.
Which failover policy meets this requirement?
- A. Disable Preemptive
- B. Enable Preemptive
- C. Non-Preemptive
- D. Preemptive
正解：C
質問 # 19
How is the RouterLink port created between a Tier-1 Gateway and Tier-0 Gateway?
- A. Automatically created when Tier-1 is connected with Tier-0 from NSX UI.
- B. Manually create a Logical Switch and connect to bother Tier-1 and Tier-0 Gateways.
- C. Automatically created when Tier-1 is created.
- D. Manually create a Segment and connect to both Tier-1 and Tier-0 Gateways.
正解：A
解説：
Explanation
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/administration/GUID-3F163DEE-1EE6-4D80-BE
質問 # 20
Which CLI command would an administrator use to allow syslog on an ESXi transport node when using the esxcli utility?
- A. esxcli network firewall ruleset set -a -e false
- B. esxcli network firewall ruleset -e syslog
- C. esxcli network firewall ruleset set -r syslog -e true
- D. esxcli network firewall ruleset set -r sysloq -e false
正解：C
解説：
Reference: https://docs.vmware.com/en/VMware-NSX-T-Data-Center/2.2/nsxt_22_troubleshoot.pdf
質問 # 21
Which three protocols could an NSX administrator use to transfer log messages to a remote log server? (Choose three.)
- A. UDP
- B. SSL
- C. SSH
- D. TLS
- E. HTTPS
- F. TCP
正解：A、D、F
質問 # 22
Which CLI command would an administrator use to allow syslog on an ESXi transport node when using the esxcli utility?
- A. esxcli network firewall ruleset set -a -e false
- B. esxcli network firewall ruleset -e syslog
- C. esxcli network firewall ruleset set -r sysloq -e false
Reference: https://docs.vmware.com/en/VMware-NSX-T-Data-Center/2.2/nsxt_22_troubleshoot.pdf - D. esxcli network firewall ruleset set -r syslog -e true
正解：D
質問 # 23
Which three services are compatible with VRF Lite? (Choose three.)
- A. VPN
- B. NAT
- C. Intrusion Detection
- D. Load Balancer
- E. DHCP
VRF Lite is not compatible with the following services:
-VPN
-Load Balancer
Taken from NSX-T ICM 3.0 Lecture Manual.
正解：B、C、E
質問 # 24
Which tool could be used to inspect the path of a packet in the data plane?
- A. Netflow
- B. Port Mirroring Session
- C. Traceflow
- D. Port Connection
正解：C
質問 # 25
Which statement is true about an alarm in a Suppressed state?
- A. An alarm can be suppressed for a specific duration in minutes.
- B. An alarm can be suppressed for a specific duration in days.
- C. An alarm can be suppressed for a specific duration in seconds.
- D. An alarm can be suppressed for a specific duration in hours.
正解：B
質問 # 26
Which CLI command shows syslog on NSX Manager?
- A. get log-file auth.log
- B. /var/log/sysloq/syslog.log
- C. get log-file syslog
- D. show log manager follow
正解：C
質問 # 27
An NSX administrator has configured a KVM hypervisor as a transport node. Which kernel module on KVM implements a N-VDS?
- A. nsx-vswitch
- B. etherswitch
- C. dyswitch
- D. openvswitch
正解：D
質問 # 28
Which tool could be used to configure BGP on a Tier-0 Gateway?
- A. ESX CLI
- B. PowerShell
- C. API
- D. NSX CLI
正解：D
質問 # 29
A NSX-T Data Center administrator wants to ensure that any machine on a public network can communicate with a Web VM running in a NSX-T Data Center environment.
Which NAT type must be created on the Tier-0 or Tier-1 Gateway to achieve this?
- A. SNAT
- B. Reverse NAT
- C. 1:1 NAT
- D. DNAT
正解：D
質問 # 30
......
2V0-41.20試験問題と有効な2V0-41.20問題集PDF：https://jp.fast2test.com/2V0-41.20-premium-file.html
2V0-41.20ブレーン問題集学習ガイドにはヒントとコツで試験合格を目指そう：https://drive.google.com/open?id=1x1p8GXA9G23Q1aAeE2idfn7YPQ830nTP