最適な練習法には350-501問題集で素晴らしい350-501試験問題PDF
更新された検証済みの合格させる350-501試験リアル問題と解答があります
質問 # 52
An engineer is implementing MPLS to monitor within the MPLS domain.
Which must the engineer perform to prevent packets from being forwarded beyond the service provider domain when the LSP is down?
- A. Disable IP redirects on all ingress interfaces.
- B. Configure a private IP address as the destination address of the headend router of Cisco MPLS TE.
- C. Implement the destination address for the LSP echo request packet in the 127.x.y.z/8 network.
- D. Disable IP redirects only on outbound interfaces.
正解：C
解説：
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r7-
5/mpls/configuration/guide/b-mpls-cg-asr9000-75x/implementing-mpls-oam-74x.html
質問 # 53
Why do packet loops occur during the configuration of BlDlR-PIM?
- A. No interface for carrying traffic for multicast groups has been configured
- B. The router has not been configured to advertise itself
- C. The network is partially upgraded to support BIDlR-PIM
- D. The network does not support BIDIR-PIM
正解：C
質問 # 54
Refer to the exhibit. Which statement describes this configuration?
- A. Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only
- B. Router 1 can be remotely managed by the CLI using Telnet
- C. Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session
- D. Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration
正解：D
解説：
https://www.cisco.com/c/en/us/td/docs/ios-
xml/ios/prog/configuration/169/b_169_programmability_cg/configuring_yang_datamodel.html
質問 # 55
Refer to the exhibit.
Refer to the exhibit. The USER mat is connecting an application on an Internet connection in AS 100 is facing these issues:
The USER lost the connection to the application during a failure Between IG and R2.
Router R2 configuration a lost due to a power outage.
The application the USER is connecting to a hosted behind CE2.
What action resolves the issues on R3 and R4 routers?
- A. Apply low Local Preference on R4 toward R2.
- B. Set R4 as a route reflector for R3 and CE2
- C. Apply high Local Preference on R3 toward R1
- D. Set R3 as a route reflector for R4 and CE1
正解：A
質問 # 56
Refer to the exhibit:
Which command is used to complete this configuration for QoS class-based marking?
- A. PE-A(config -pmap-c)#priority
- B. PE-A(config-pmap-c)#fair-queue
- C. PE-A(config-pmap-c)#set dscp ef
- D. PE-A(config-pmap-c)#random-detect
正解：C
質問 # 57
Refer to the exhibit.
While troubleshooting a connectivity issue on router R2, a network engineer with an employee id:3876.13.497 notices that although it detects three OSPF links from R1, the OSPF prefixes are missing from the routing table. What is the reason for the problem?
- A. The serial interfaces have different MTUs
- B. The R2 Serial 1/0 interface is configured with an IP address, but the R1 Serial R1 Serial 1/0 interface in unnumbered.
- C. Both loopback interfaces on R1 are configured as stub
- D. The subnet masks on the serial interfaces are mismatched.
正解：B
質問 # 58
Refer to the exhibit.
An engineer applied a gRPC dial-in configuration on customer's router to provide connection multiplexing and two-way streaming. What does this configuration accomplish in a gRPC?
- A. It is the encoding requested by the gRPC client.
- B. It is the encoding requested by the gRPC server.
- C. IT is the encoding that is used for dial-in and dial-out.
- D. It is used for encoding with the default protocol buffers
正解：B
解説：
https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2019/pdf/BRKNMS-3537.pdf
https://xrdocs.io/telemetry/tutorials/2018-03-01-everything-you-need-to-know-about-pipeline/
https://community.cisco.com/t5/service-providers-documents/implementing-grpc-telemetry-on-xr-devices/ta-p/3393966
質問 # 59
Refer to the exhibit. Which condition must be met by the OSPF peer of router R1 before the two devices can establish communication?
- A. The interface on the OSPF peer must use the same key ID and key value as the configured interface
- B. The OSPF peer must use clear-text authentication
- C. The OSPF peer must be configured as an OSPF stub router
- D. The interface on the OSPF peer may have a different key ID, but it must use the same key value as the configured interface
正解：A
解説：
https://networklessons.com/ospf/how-to-configure-ospf-md5-authentication
質問 # 60
While implementing TTL security, you issue the PE(config-router-af)#neighbor 2.2.2.2 ttl-security hops 2 command.
After you issue this command, which BGP packets does the PE accept?
- A. to 2.2.2.2, with a TTL of 2 or more
- B. to 2.2.2.2, with a TTL of less than 253
- C. from 2.2.2.2, with a TTL ol 253 Of more
- D. from 2.2.2.2, with a TTL of less than 2
正解：D
質問 # 61
Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right
正解：
解説：
Explanation
Path Computation Element (Calculates paths through the network, keeps TE topology database information, sends path status updates) Path computation Client (sends path calculation request, sends path creation request) Path Computation Element (PCE) Represents a software module (which can be a component or application) that enables the router to compute paths applying a set of constraints between any pair of nodes within the router's TE topology database. PCEs are discovered through IGP.
Path Computation Client (PCC)
Represents a software module running on a router that is capable of sending and receiving path computation requests and responses to and from PCEs. The PCC is typically an LSR (Label Switching Router).
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r5-3/mpls/configuration/guide/b-mpls-cg53x-crs
質問 # 62
Refer to the exhibit:
Which command is used to complete this configuration for QoS class-based marking?
- A. PE-A(config -pmap-c)#priority
- B. PE-A(config-pmap-c)#fair-queue
- C. PE-A(config-pmap-c)#set dscp ef
- D. PE-A(config-pmap-c)#random-detect
正解：C
質問 # 63 
Refer to the exhibit. An engineer applied a gRPC dial-in configuration on customer's router to provide connection multiplexing and two-way streaming. What does this configuration accomplish in a gRPC?
- A. It is the encoding requested by the gRPC client
- B. It is the encoding requested by the gRPC server
- C. It is used for encoding with the default protocol buffers
- D. It is the encoding that is used for dial-in and dial-out
正解：A
解説：
Section: Automation and Assurance
質問 # 64 
Refer to the exhibit. Which configuration prevents the OSPF neighbor from establishing?
- A. duplex
- B. network statement
- C. default-metric
- D. mtu
正解：D
解説：
Section: Networking
質問 # 65
Refer to the exhibit:
Which statement about the neighbor statements for 192.168.1.1 is true?
- A. The router sends BGP labels for its prefixes to this peer
- B. The router sends only a label for the prefix for LoopbackO.
- C. The router must have TDP configured for the send-label command to operate
- D. The neighbor router receives at least four labels from this router
正解：A
質問 # 66
Refer to the exhibit:
Which purpose of implementing NSF with this configuration is true?
- A. The router uses NSF to load balance traffic on a routed EtherChannel
- B. The router uses NSF to handle RP switchover while allowing neighbor relationships to remain up
- C. The router uses NSF to reduce neighbor-relationship downtime during RP switchover
- D. The router uses NSF to load balance traffic between two links, with the primary link alternating every 90 seconds
正解：B
質問 # 67
Drag and drop the LDP features from the left onto the correct usages on the right.
正解：
解説：
質問 # 68
Refer to the exhibit:
An engineer wants to authenticate the OSPF neighbor between PEA and PE-B using MD5.
Which command on PE-B successfully completes the configuration?
A)
B)
C)
D)
- A. Option C
- B. Option A
- C. Option B
- D. Option D
正解：B
質問 # 69
Refer to the exhibit.
An engineer is updating this network to meet these conditions:
* Area 10 will receive inter-area routes and support mutual redistribution of external routes with the extranet.
* The ::/0 route is prohibited in Area 10.
* Area 11 will receive only the ::/0 route from the ABR.
* External route redistribution is not supported in Area 11.
* The ABR in Area 11 will advertise no interarea routes.
Which two configurations must be performed to meet the requirements? (Choose two.)
- A. Configure area 11 as nssa default-information-originate on R7 and as nssa on XR31.
- B. Configure area 10 as stub on R9 and XR32.
- C. Configure area 10 as nssa on R9 and XR32.
- D. Configure area 11 as nssa no-summary on R7 and as nssa on XR31.
- E. Configure area 11 as stub no-summary on R7 and as stub on XR31.
正解：C、E
質問 # 70
Refer to the exhibit.
A network engineer is implementing an OSPF configuration. What is the output of this implementation?
- A. In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
- B. OSPFv3 cannot be configured for IPv4. OSPFv3 works only for IPv6.
- C. IPv6 routing not enabled' Is just an Informational message and OSPFv3 runs for IPv4 on interface FastEihernet0/0 anyway.
- D. OSPFv3 does not run for IPv4 on FastEthernetO'O until IPv61 routing is enabled on the router and IPv6 Is enabled on interface FastEthernet0/0.
正解：D
質問 # 71 
Refer to the exhibit. R101 is peering with R102 and R103, and R201 is peering with R202 and R203 using iBGP Labeled Unicast address families. The OSPF area 0 border routers are in a full iBGP Labeled Unicast mesh, and VPNv4 routes are exchanged directly between PE routers R101 and R201 through iBGP. Which address family-level configuration must be applied on ABR R102 on ABR R102 to support a Unified MPLS routing architecture with partitioned IGP domains?
- A.
- B.
- C.
- D.
正解：C
解説：
Section: Services
質問 # 72
......
Cisco 350-501認定試験は、Cisco Service Provider Networksのコアテクノロジーの実装と運用のスキルと知識を検証したい専門家を対象としています。この試験は、ルーティングプロトコル、MPLS、QOS、ネットワーク自動化、セキュリティプロトコルを含むテクノロジーを構成、実装、トラブルシューティング、最適化する候補者の能力を評価するように設計されています。認定試験は、Cisco Certified Network Professional（CCNP）サービスプロバイダー認定トラックの一部です。
更新されたPDF（2023年最新）実際にある 350-501試験問題：https://jp.fast2test.com/350-501-premium-file.html
問題集返金保証付きの350-501公式問題集：https://drive.google.com/open?id=1CGv29rqA3qhaqNW8jq0_2jkS-iDWV5oL