[Q225-Q250] 100%合格率リアルD-VXR-DY-23試験成功を掴み取れ！[2026年05月]

100%合格率リアルD-VXR-DY-23試験成功を掴み取れ！[2026年05月]

EMC D-VXR-DY-23のPDF問題格別な練習Dell VxRail Deploy 2023

質問 # 225
Which step of the VxRail Initialization wizard may time out if the user does not proceed to the next step within 20 minutes?

A. Review expected nodes list
B. Review and validate
C. Build complete screen
D. Configuration of the VxRail Manager IP address

正解：B

質問 # 226
A failure occurs during the deployment of a VxRail cluster. You need to look through the marvin.log file to see what could be causing the error.
Where is this file located?

A. var/log/vmware
B. var/log/mystic
C. var/log/vmware/marvin
D. var/log/vmware/marvin/tomcat/logs

正解：D

質問 # 227
You have determined that you need to execute a RASR factory upgrade of a VxRail v4.7.1xx node You download the RASR ISO from the Dell Support site.
What is the correct order of steps to finish the upgrade?

正解：

解説：

質問 # 228
You are configuring a VxRail to connect to an existing, external SRS VE. The customer's support account is associated with the Site ID/Party ID where VxRail is installed. A validation error is issued when you attempt to register VxRail in SRS.
What is the possible cause for the error?

A. Status of VxRail in Install Base is Shipped
B. SRS traffic goes through a proxy server
C. Wrong IP address was used for SRS VE gateway
D. Number of deployed devices on SRS gateway has exceeded the maximum

正解：A

質問 # 229
What is the first step when preparing for a VxRail deployment using the VxRail configuration portal?

A. Create the JSON file
B. Enter configuration information using a wizard
C. Initiate BOM using the Dell Support Portal
D. Create the YAML file

正解：B

質問 # 230
A VxRail cluster is being deployed with an existing vCenter Server.
Which role needs to be assigned to the new VxRail Management User account within vCenter Server?

A. No role needs to be assigned
B. Trusted Infrastructure Administrator role
C. Administrator role
D. Read-only role

正解：A

質問 # 231
You are in the validation phase of a VxRail deployment with two Top of Rack (ToR) switches and four V570F VxRail nodes.
Which command should you issue on each of the ToR switches to validate that Link Aggregation has not been configured for VxRail interfaces?

A. show spanning tree
B. show running config mld
C. show interfaces port-channel brief
D. show vlan

正解：C

質問 # 232
A company has a two chassis G Series cluster and wants to change the setup. This will require a reset of the chassis.
What is the correct procedure?

A. Reset the secondary chassis first, followed by the primary chassis, through the reset script.
B. Reset both chassis simultaneously with the mobile build server
C. Reset both chassis simultaneously through the reset script
D. Reset the primary chassis first, followed by the secondary chassis, through the reset script.

正解：A

質問 # 233
What is the correct CLI command to collect only the iDRAC logs for node HL2S8N2?

A. generateLogBundle.py --nodes HL2S8N2 -i
B. generateFullBundle.py --nodes HL2S8N2 -i
C. vm-support.sh --nodes HL2S8N2 -i
D. vc-support-bundle.sh --nodes HL2S8N2 -i

正解：A

質問 # 234
What does vSAN use to make metadata available to each host in the VxRail cluster?

A. CMMDS
B. Loudmouth
C. IPv6 Multicast
D. MLD Snooping and Querier

正解：A

質問 # 235
An implementation engineer places a VxRail node into maintenance mode using the Ensure accessibility setting.
What is the engineer likely planning to do?

A. Permanent removal of host from cluster
B. Extensive maintenance
C. Temporary maintenance
D. Shutdown of an entire cluster

正解：C

質問 # 236
A customer requires a Stretched VxRail Cluster with S570 nodes in its minimal configuration.
Which setup will fulfill the requirement?

A. 2+2 nodes
B. 6+6 nodes
C. 4+4 nodes
D. 3+3 nodes

正解：D

質問 # 237
An implementation engineer has just finished connecting a multi-rack VxRail cluster over a Layer 3 network. When attempting to migrate System VMs from the first rack to the second rack, they receive an error.
What is a possible reason for the error?

A. System VMs must be on different subnets
B. vSphere DRS must be enabled
C. Only Layer 2 networking is supported
D. System VMs must be on the same subnet

正解：D

質問 # 238
An implementation engineer is configuring the network firewall to support a VxRail installation. Where can they find the necessary firewall rules?

A. As-Built Configuration Report
B. VxRail Configuration Portal
C. Network Validation Tool
D. Rack worksheet of the Network PEQ

正解：D

解説：
Graphical user interface, text, application, email Description automatically generated

質問 # 239
Match each VxRail API request with the information to be retrieved.

正解：

解説：

質問 # 240
What is the recommended way to power up VxRail E, V, P, and S Series nodes?

A. Ensure the System Health indicator blinks amber for 10 minutes after power on
B. Use the power button on the rear panel to power on each node
C. Wait at least 30 seconds between powering up each node
D. Use the iDRAC interface to power on each node

正解：B

質問 # 241
A Dell EMC solutions architect has updated the VxRail PEQ with Customer Top-of-Rack (ToR) switch details.
On which worksheet would they need to be to generate a new NVT JSON file?

A. VxRail Cluster
B. Engagement Details
C. Customer
D. Networking Details

正解：A

質問 # 242
Refer to the exhibit, which shows a red box around a node name.

What is a characteristic of the node marked by the red box?

A. There are three VxRail nodes that can be discovered by the VxRail Deployment Wizard.
B. The selected VxRail is Node 3 and VxRail Manager VM is running on this node.
C. The selected VxRail is Node 1 and VxRail Manager VM is running on this node.
D. The VxRail node is running DNS and NTP.

正解：C

質問 # 243
Use the VxRail simulator to explore the system.

What is the presented configuration? Note: It fs necessary to close (x) the simulator window before you can select a response to this question.

A. Internal vCenter and Internal DNS
B. External vCenter and internal DNS
C. External vCenter and external DNS
D. Internal vCenter and external DNS

正解：D

質問 # 244
From what environment must a network administrator run VxRail network validation?

A. VxRail Deployment Wizard
B. Top of Rack switches
C. Same subnet as VxRail Management Network
D. Windows PowerShell command prompt

正解：C

質問 # 245
Which log files are related to a VxRail upgrade?

A. lcm-web.log, lcm-migration.log, and lcm-do.log
B. dayone.log, short.term.log, and long.term.log
C. loudmouth.log and marvin.log
D. platform_svc.log and localhost_access_log.txt

正解：A

質問 # 246
A systems engineer is deploying a VxRail cluster. They want to ensure that configuration issues can be avoided when expanding this cluster.
Which actions need to be performed?

A. Validate that the latest updates and patches are installed in the system Validate that no pending and unfinished jobs are running on the servers
B. Verify VxRail nodes are racked and connected to the ToR switches
Validate the network environment
C. Validate that no pending and unfinished jobs are running on the servers Verify that the server and storage components are working properly
D. Verify the configuration settings initially captured in PEQ Validate the storage environment

正解：B

解説：
Graphical user interface, text, application, email Description automatically generated

質問 # 247
Refer to the exhibit.

You have received the attached PEQ for an upcoming VxRail implementation. However, you have no additional supporting documents.
Who should be your first point of contact for additional information?

A. Project Manager
B. Solutions Architect
C. Customer
D. Systems Engineer

正解：A

質問 # 248
What must be used when deploying VxRail with a customer-supplied VDS?

A. VxRail PowerShell SysBringUp Module
B. Deployment Wizard using the step-by-step method
C. Deployment Wizard using the configuration file method
D. VxRail API with configuration file

正解：B

質問 # 249
An implementation engineer is expanding an existing VxRail S Series cluster with an additional node. The version of the node is not at the current cluster level but is compatible.
What procedure would result in the quickest node addition?