HPE6-A75問題集でリアル試験問題でテストエンジン問題集でトレーニング
HP HPE6-A75テスト問題集とオンライン試験エンジン
HPE6-A75試験に合格すると、Aruba Technologiesの習熟度が実証され、Aruba製品を使用する組織にとって貴重な資産になります。この認定試験は、他のITプロフェッショナルから際立っており、収益の可能性を高めるのに役立ちます。さらに、Aruba Certified Edge Professional認定は、Aruba Certified Mobility ProfessionalやAruba Certified ClearPass Professional認定など、高度な認定の前提条件です。
質問 # 19
An administrator wants to implement bandwidth limits for guest users to restrict their Internet usage. On the Mobility Master (MM), where would the administrator define these limits?
- A. Firewall policy
- B. 802.1X policy
- C. User role
- D. AAA policy
正解：A
質問 # 20
A network administrator can set the OSPF metric-type on an AOS-Switch to Type 1 or Type 2. What is the difference?
- A. A Type 2 metric marks external routes that can be advertised in NSSAs, while a Type 1 metric marks external routes that can only be advertised in normal areas.
- B. A Type 2 metric stays the same as the external route is advertised, while a Type 1 metric increments with internal OSPF link costs.
- C. A Type 2 metric is assigned to multiple external routes that are aggregated together, while a Type 1 metric does not permit external route aggregation.
- D. A Type 2 metric assigns cost 1 to a 100 Gbps link, while a Type 1 metric assigns cost 1 to all links of 100 Mbps or higher.
正解：B
質問 # 21
Refer to the exhibit.
A network administrator sets up 802.1X authentication to a RADIUS server on an AOS-Switch.
The RADIUS server and user devices are both set up to use REAP MSCHAPv2. The administrator tests the authentication and sees the output shown in the exhibit.
Which issue could cause this output?
- A. The administrator entered the wrong password for the test account.
- B. The RADIUS shared secret does not match on the switch and the server.
- C. The switch port is set for user mode 801. IX. but the RADIUS server is set for port mode.
- D. The switch does not have a certificate tor port-access installed on the switch.
正解：B
質問 # 22
A company requires AOS-Switches at the campus core. The switches:
Will act as the default gateways for several campus VLANs Must provide redundancy for their services and tolerate the loss of a link or an entire switch Must recover from the failure of one of the switches within a second or less VRRP and MSTP are proposed to meet these requirements. What is an issue with this proposal?
- A. VRRP provides routing redundancy but not default gateway redundancy.
- B. VRRP does not interoperate with MSTP.
- C. VRRP takes longer than a second to fail over.
- D. VRRP provides redundancy against lost links but not a failed switch.
正解：C
質問 # 23
An administrator configures the MultiZone feature for a company network, where a mobility cluster is the primary zone and a standalone controller in the company's DMZ represents a secondary data zone. The administrator configures two AP Groups and respective VAPs for the zones on the Mobility Master (MM) in the primary zone. When the APs boot up and establish connections to both zones, the administrator notices that no data connections are established to the data zone.
What must the administrator do to fix this problem?
- A. Configure the same AP Group in the data zone as it is in the primary zone, and configure the VAPs in the data zone.
- B. Have the MultiZone APs initially boot from the standalone controller in the data zone.
- C. Configure the same AP Groups and VAPs on the standalone controller, and associate the MultiZone APs to both groups.
- D. Create different AP groups and VAPs on the Mobility Master and standalone controllers, and associate the MultiZone APs to both groups.
正解：D
質問 # 24
Refer to the exhibit.
The network administrator wants to reduce failover time If a switch link m VIAN 100 goes down.
What should the administrator do?
- A. Configure graceful restart on all of the OSPF routing devices on VLAN 100.
- B. Lower the dead timer on the BDR of VLAN 100.
- C. Configure echo mode BFD on VLAN 100 on all OSPF routing devices on VLAN 100.
- D. Lower the hello timer only on the BDR of VLAN 100.
正解：C
質問 # 25
An administrator mistakenly configures the wrong VLAN setting on a managed controller's interface. This causes the controller to lose management access to the Mobility Master (MM).
Which mechanism will then attempt to restore the previous working configuration on the managed controller?
- A. disaster recovery
- B. auto-rollback
- C. restore config
- D. bulk configuration
正解：B
質問 # 26
Refer to the exhibit.
A network administrator sets up 802.1X authentication to a RADIUS server on an AOS-Switch. The RADIUS server and user devices are both set up to use REAP MSCHAPv2. The administrator tests the authentication and sees the output shown in the exhibit. Which issue could cause this output?
- A. The administrator entered the wrong password for the test account.
- B. The RADIUS shared secret does not match on the switch and the server.
- C. The switch port is set for user mode 801. IX. but the RADIUS server is set for port mode.
- D. The switch does not have a certificate tor port-access installed on the switch.
正解：B
質問 # 27
Refer to the exhibit.
Which statements accurately describe the status of the Onboarded devices in the configuration tor the network settings shown? (Select two.)
- A. They will connect to secure_emp SSID after provisioning.
- B. They will use WPA2-PSK with AES when connecting to the SSID.
- C. They will perform 802.1X authentication when connecting to the SSID.
- D. They will connect to Employee_Secure SSID after provisioning.
- E. They will connect to Employee_Secure SSID for provisioning their devices.
正解：A、C
質問 # 28
An AOS-Switch has type of service disabled on it globally. The administrator enters:
AOS-Switch(config)# interface 1 qos trust device aruba-ap
What is the effect of this command?
- A. if interface connects to an Aruba AP, the switch marks all traffic received on the interface with a higher than default priority value
- B. if interface 1 connects to an Aruba AP, it uses the incoming DSCP and a global DSCP map to prioritize traffic received on this interface
- C. if the AOS-Switch is integrated with an Aruba Mobility Controller, it uses QoS settings sent by the controller to classify traffic received on interface 1
- D. if the AOS-Switch is integrated with an Aruba Mobility Controller, it uses QoS settings send by the controller to prioritize traffic sent on interface 1
正解：D
質問 # 29
Refer to the exhibit.
- A. We can't know this from the screenshot above.
- B. mike
- C. Employee
- D. john
正解：A
質問 # 30
Refer to the exhibit.
Based on the Attribute configuration shown, which statement accurately describes the status of attribute values?
- A. Only the attribute values of title, telephoneNumber, and mail can be used in role mapping policies.
- B. Only the attribute value of company can be used in role mapping policies, not the other attributes.
- C. The attribute values of department, title, memberOf, telephoneNumber, and mail are directly applied as ClearPass.
- D. The attribute values of department and memberOf are directly applied as ClearPass roles.
- E. Only the attribute values of department and memberOf can be used in role mapping policies.
正解：D
質問 # 31
Refer to the exhibit.
- A. We can't know this from the screenshot above.
- B. mike
- C. Employee
- D. john
正解：A
解説：
The role field in the local user repository is not the role derived from role maping.
質問 # 32
Refer to the exhibit.
A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated (ink should forward the packet?
- A. The standby sends the packet to the commander over a VSF link, and the commander decides the correct port.
- B. The standby selects the port on the designated forwarder for the aggregation.
- C. The standby uses its own port in the link aggregation to forward the fabric.
- D. The standby uses the typical load sharing algorithm, and it might select either its port or the commander's port.
正解：C
質問 # 33
A network administrator needs to configure VRRP on VLAN 2 on two AOS-Switches. Which two settings must match on both switches?
- A. the virtual IP address and the physical IP address
- B. the physical IP address and priority
- C. the VRID and the virtual IP address
- D. the VRID and priority
正解：C
質問 # 34
Refer to the exhibit.
Based on the configuration of me create_user form shown, which statement accurately describes the status?
- A. The email field will be visible to guest users when they access the web login page.
- B. The visitor_phone field will be visible to operators creating the account.
- C. The visitor_company field will be visible to the guest users when they access the web login page.
- D. The visitor_company field will be visible to operators creating the account.
- E. The visitor_phone field will be visible to the guest users in the web login page.
正解：A
質問 # 35
Refer to the exhibit.
An administrator implements AP licensing on a Mobility Master (MM).
* Each campus is responsible to purchase its own AP licenses.
* There are 900 AP licenses deployed in the global pool
* There are three dedicated pools.
* From the global pool, 300 AP licenses are assigned to each dedicated pool.
Network engineers at CampusA want to deploy an additional 100 APs. Currently all of the AP licenses in CampusA and CampusB are allocated, but only 200 of the AP licenses m CampusC are allocated.
What can the administrator do to add capacity for CampusA in alignment with campus policies?
- A. Add 100 more AP licenses to the global pool.
- B. Allow CampusA to share from the CampusC pool.
- C. Move 100 licenses from the CampusC pool to the global pool.
- D. Add 100 more AP licenses and assign them to the CampusA pool.
正解：D
質問 # 36
Refer to the exhibit.
Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?
- A. a hardware issue, such as a broken cable
- B. mismatched IP addresses on the VLAN for the link
- C. asymmetric routing introduced by a routing configuration error
- D. an issue with queuing, caused by mismatched QoS settings
正解：A
質問 # 37
......
HPE6-A75認定試験を受けるには、候補者は有効なHPE6-A70（Aruba Certified Mobility Associate）認定を取得するか、Aruba Certified Mobility Associate（ACMA）認定試験に合格する必要があります。この試験は、90分以内に完了する必要がある60の質問で構成される複数選択試験です。試験は英語と日本語で利用できます。
HP HPE6-A75（Aruba Certified Edge Professional）試験は、Aruba Networking Solutionsで働くIT専門家の知識とスキルをテストするために設計されています。この試験では、アクセスポイント、スイッチ、コントローラーなど、アルバネットワークインフラストラクチャに関連するさまざまなトピックをカバーしています。また、さまざまなネットワーク環境のArubaソリューションを構成およびトラブルシューティングする候補者の能力もテストします。
HP HPE6-A75問題を提供していますHPE ACEP問題集と完璧な解答付き：https://jp.fast2test.com/HPE6-A75-premium-file.html