[2024年11月10日] 心強い300-615のPDF問題集は300-615問題
正真正銘の300-615問題集で無料PDF問題で合格させる
質問 # 42
You have an ACI environment with three APICs, two spine switches, and four-leaf switches. You wipe and reboot all APICs first then leaf and spine switches one- by-one and successfully go through the Initial Setuo dialogue on the APIC 1 CIMC KVM console. When you log in to the APIC1 WebGUI, you notice that you do not see any directly connected leaf switches being discovered under Fabric > Inventory > Fabric Membership. What is the cause of the issue?
- A. Rebooting the APICs and the leaf and spine switches after wiping them is not required.
- B. The leaf nodes were not erased properly, which caused a fabric parameters mismatch with the APIC1.
- C. You forgot to enter the TEP Pool value during the Initial Setup dialogue on APIC1.
- D. The same Fabric Name value should be used before after wiping all devices.
正解：B
解説：
TEP pool has default values.
https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c11-737909.html
質問 # 43
Refer to the exhibit.
The FCoE traffic fails to traverse the vfc2 interface. The VSAN 102 is configured for vfc2. Which action resolves the issue?
- A. Activate DCBX on the interface e101/1/2
- B. Enable LLDP on the interface vfc2
- C. Activate DCBX on the N9K switch
- D. Enable LLDP on the neighbor switch
正解：D
質問 # 44
Refer to the exhibit. An engineer troubleshoots an OSPF neighborship problem between Router R2 and Router R10. Which action resolves the problem?
- A. Change area ID on Router R10
- B. Resolve authentication type on Router R10
- C. Change router ID on Router R10
- D. Resolve unicast reply from Router R2
正解：D
質問 # 45
Refer to the exhibit.
The FCoE traffic fails to traverse the vfc2 interface. The VSAN 102 is configured for vfc2. Which action resolves the issue?
- A. Activate DCBX on the interface e101/1/2
- B. Enable LLDP on the interface vfc2
- C. Activate DCBX on the N9K switch
- D. Enable LLDP on the neighbor switch
正解：D
質問 # 46
An engineer must upgrade all components in a Cisco UCS domain to the same package version, but the upgrade process fails to complete. Which set of Auto Install actions resolves the problem?
- A. Install infrastructure Firmware, then Install Hypervisor Firmware.
- B. Install Server Firmware, then Install Infrastructure Firmware
- C. Install Infrastructure Firmware, then Install Server Firmware.
- D. Install Hypervisor Firmware, then Install Infrastructure Firmware
正解：C
解説：
Explanation
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/firmware-mgmt/gui/2-5/b_GUI_Firmware_Ma
質問 # 47
Refer to the exhibit.
An engineer deploys SAN environment with two interconnected Cisco MDS 9000 Series switches. When the engineer attempts a zone merge, it fails with the error that is presented in the exhibit. Which action resolves the issue?
- A. Import or export a zone set between the switches to synchronize the switches.
- B. Ensure that the zone members have different names.
- C. Set the distribute policy of the zone to full.
- D. Change the name of one of the zones to match the other zone set.
正解：B
解説：
https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/troubleshooting/guide/ts_guide.pdf
質問 # 48
Refer to the exhibit.
A network engineer configures OSPF protocol between two Cisco Nexus 7000 Series Switches. The OSPF neighbors fail to synchronize OSPF databases. Which action resolves the issue?
- A. Configure the IP addresses of the interface in the same subnet.
- B. Match the OSPF area between the two devices.
- C. Set the same MTU values on both sides of the link.
- D. Change the OSPF area type to 2 on n7k-1.
正解：C
質問 # 49
Refer to the exhibit.
A network engineer has connected the Nexus switch management port to the Internet using DHCP to allow the Guest shell running on the switch to download Python packages. The engineer can ping google.com successfully from the Nexus switch, but the Guest shell failed to download any Python packages. Which action resolves the problem?
- A. Connect Guest shell to data plane interfaces to be able to connect to the networks outside the Cisco Nexus switch.
- B. Manually configure DNS in the Guest shell, even if it is claimed on the Cisco Nexus switch through DHCP.
- C. Manually configure NTP in the Guest shell.
- D. Update the Python packages on the Cisco Nexus switch directly.
正解：B
質問 # 50
A network engineer troubleshoots an issue at a Cisco data center environment with these conditions:
- The data center has Cisco Nexus 9000 Series Switches running the vPC
setup.
- The gateway of the servers is an HSRP IP address between the VLAN
interfaces configured on both Cisco Nexus switches.
- Some of the client application servers are implementing fast-path
forwarding for the return traffic.
- Those servers are sending the return traffic to the VLAN interface
MAC address instead of the HSRP MAC address.
The network engineer discovers that some traffic is dropped because it passes the vPC peer link to be forwarded out the vPC interface.
What must be configured on the vPC switches to resolve the issue?
- A. spanning-tree
- B. peer-gateway
- C. peer-switch
- D. arp synchronize
正解：B
質問 # 51
Refer to the exhibit.
A network engineer is implementing a Cisco UCS environment. The environment consists of eight servers configured with the same service profile template and Windows 2012 installed. The VFC interfaces of five of these servers are showing the error shown in the exhibit. Which action resolves the issue?
- A. Modify the boot order in the boot policy
- B. Modify the vHBAs name in the storage connectivity policy
- C. Decommission and recommission the servers
- D. Configure upstream zoning
正解：B
質問 # 52
Refer to the exhibit.
After the configuration is performed, guestshell continues to use 2%CPU. Which action resolves the issue?
- A. Resync the database
- B. Recreate the guestshell
- C. Reboot the guestshell
- D. Reboot the switch
正解：C
質問 # 53
Refer to the exhibit. A network engineer is implementing a pair of Cisco Nexus 9000 Series Switches. During the OSPF configuration, the engineer discovers unstable routing in the network.
The investigation shows flapping routes after the new switches were introduced. Which set of actions resolves the issue?
- A. Configure a new IP address on the Ethernet interface toward the OSPF neighbor.
Clear the OSPF process. - B. Configure a new IP address on the Loopback interface for the OSPF process.
Clear the OSPF process - C. Configure a new OSPF priority on the Ethernet interface toward the OSPF neighbor.
Clear the OSPF neighbor. - D. Configure a new IP address on the Ethernet interface toward the OSPF neighbor.
Clear the OSPF neighbor.
正解：C
質問 # 54
Refer to the exhibits.
An engineer troubleshoots switch N5K1, which fails to receive traffic from the file server Which set of actions resolves this problem?
- A. Assign native VLAN 10withvfc111 and allow VLAN 1101 in trunk configuration.
- B. Bind native VLAN 10 with Ethemet1/10 and allow VSAN 101 in trunk configuration.
- C. Assign native VLAN 10 with fc2.'l - 2 and allow VLAN 10 in trunk configuration.
- D. Bind native VLAN 10 with Ethemet10/1/1 and allow VLAN 10 in trunk configuration
正解：B
質問 # 55
Refer to the exhibit.
Partial configuration from N9K-1 and N9K-2 is included. The client has two WANs connected.
* WAN-1 is for normal business-day activities.
* WAN-2 is for server backups during nonworking hours of 1:00 a.m. to 5:00 a.m. daily.
The client says that at the scheduled time for backup, the data center server failed to use the WAN-2 link to back up the servers to the cloud backup system. What is the solution to this problem?
- A. The Cron entry must be configured without double quotes.
- B. The applet called "Backup" must include an action to remove the current static route.
- C. The Cisco Nexus switch must be configured with one applet because a configuration with two applets will fail.
- D. The event timer must be written in epoch time format.
正解：B
質問 # 56
Drag and drop the Cisco UCS SNMP fault types from the left onto the correct issues on the right.
正解：
解説：
質問 # 57
......
Cisco 300-615試験に備えるためには、候補者はCiscoデータセンター技術とプロトコルについての強固な理解を持ち、プロダクション環境で複雑な問題のトラブルシューティングの経験が必要です。試験は60-70問から成り、90分以内に完了する必要があり、合格点は1000点中825点です。試験は英語と日本語で利用可能であり、Pearson VUEテストセンターで受験することができます。
結果を保証するには最新2024年11月無料：https://jp.fast2test.com/300-615-premium-file.html
有効な問題最新版を無料で試そう300-615試験問題集解答：https://drive.google.com/open?id=1KoOQX0TKqxNTCskkB0iYY7g0bcVpv5pK