2023年最新のNetwork Appliance NS0-184試験問題には60問があります
無料で使えるNS0-184別格な問題集をダウンロード2023年03月08日に更新された60問があります
Network Appliance NS0-184 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
質問 33
Your customer currently has a 4-node AFF A400 cluster that runs ONTAP 9.8, with two NS224 shelves that are connected to each HA pair. The customer needs to add additional capacity to the cluster.
Which two actions would enable the customer to accomplish this task? (Choose two.)
- A. Deploy a new AFF A400 to the cluster.
- B. Deploy new, dedicated, storage switches for the new NS224 shelves.
- C. Connect the new NS224 shelves to the existing NS224 shelves and adjust the shelf IDs.
- D. Connect the new NS224 shelves to the existing Cisco Nexus 3232C switches.
正解: A,C
質問 34
You are setting up a new AFF A400 that will serve iSCSI LUNs. You will have four iSCSI SVMs that each need to connect to an Internet Storage Name Service (iSNS) for discovery and management purposes.
In this scenario, which network interface is needed for each SVM to register with the name service?
- A. SVM data LIF
- B. SVM management LIF
- C. intercluster LIF
- D. node management LIF
正解: C
質問 35
You have an AFF All SAN Array (ASA) cluster that is running ONTAP 9.7. The cluster is configured for Active Directory domain controller access using a domain tunnel.
In this scenario, which two licenses are enabled on the cluster? (Choose two.)
- A. CIFS
- B. NVMe
- C. FCP
- D. iSCSI
正解: A,C
質問 36
Which two switch operating system are supported on ONTAP cluster switches? (Choose two.)
- A. Broadcom EFOS
- B. Cisco IOS
- C. Brocade FOS
- D. Cisco NX-OS
正解: A,D
質問 37
What should you do to change the data protocol of a LIF?
- A. Add the new data protocol to the LIF.
- B. Delete and re-recreate the LIF.
- C. Put the LIF in another broadcast domain.
- D. Shut down the assigned port.
正解: B
質問 38
You are preparing to add a 2-node AFF A250 system to an existing 4-node AFF A800 cluster with Cisco Nexus 3232C switches. The cluster switches are currently running the Cluster-HA RCF.
In this scenario, which two steps are required to install the AFF A250 system? (Choose two.)
- A. Cable the AFF A250 nodes to the next free ports on the switch.
- B. Load the Cluster-HA-Breakout RCF.
- C. Load the Storage RCF.
- D. Cable the AFF A250 nodes to the breakout ports on the switch.
正解: B,D
質問 39
Click the Exhibit button.
Referring to the exhibit, what information is forwarded to syslog after you enter the scripted install commands? (Choose two.)
- A. SNMP traps
- B. AutoSupport messages
- C. command history
- D. EMS messages
正解: B,C
質問 40
You are installing a new AFF A400 cluster that is running ONTAP 9.7 software. You are asked to attach an Amazon S3 cloud tier for FabricPool technology.
In this scenario, which two NetApp License File (NLF) types are supported for cloud tiering? (Choose two.)
- A. term-based
- B. master
- C. perpetual
- D. base
正解: A,C
質問 41
You want to ensure the highest path resilience and performance increase to the storage stack on your FAS8700 cluster.
In this scenario, which two types of stack cabling are available to use? (Choose two.)
- A. single path
- B. mixed-mode
- C. multipath HA
- D. quadpath HA
正解: B,C
質問 42
A customer wants to enable SnapMirror Synchronous across their environment. The customer must ensure that SnapMirror Synchronous will work across the environment.
In this scenario, which two statements are true? (Choose two.)
- A. A SnapMirror license is required on both the source cluster and the destination cluster.
- B. A SnapMirror Synchronous license is required on both the source and destination clusters.
- C. A SnapMirror Synchronous license is required on the source cluster.
- D. A SnapMirror license is not required on both the source cluster and the destination cluster.
正解: B,D
質問 43
Click the Exhibit button.
You are installing a 2-node AFF A400 switchless cluster. You have cabled the management network to the e0M port. NetApp also recommends cabling to a redundant management network switch.
Referring to the exhibit, to which port should the redundant management network be cabled?
- A. 0
- B. 1
- C. 2
- D. 3
正解: A
質問 44
You want to disconnect a DS224C shelf with 3.8 TB NetApp Storage Encryption (NSE) SSDs to an AFF A300 HA pair with two DS224C shelves with 3.8 TB SSDs without NSE in one stack.
In this scenario, how would you add the shelf?
- A. Create a new stack on the HA pair to add the shelf.
- B. Connect the shelf to an HA pair with NSE drives.
- C. License NSE and add the shelf to this HA pair as a new stack.
- D. Add the shelf to the existing stack.
正解: D
質問 45
Click the Exhibit button.
You want to add a FAS2750 HA pair to an existing 6-node cluster.
Referring to the exhibit, which action would you perform to begin adding the node?
- A. Use the back command to begin the Cluster Setup wizard.
- B. Reboot the node and enter maintenance mode and run the Cluster Setup wizard.
- C. Use the node setup wizard and select 0a as the management interface.
- D. Use the exit or quit commands then run the cluster setup command.
正解: C
質問 46
An administrator issued the cluster setup command and configured a 2-node ONTAP 9.8 cluster.
In this scenario, which tool would the administrator use to validate the configuration?
- A. Interoperability Matrix Tool
- B. NetAppDocs
- C. Active IQ Config Advisor
- D. Active IQ Upgrade Advisor
正解: B
質問 47
You are preparing to install a new 2-node AFF A250 system at a customer site with an existing cluster that uses NetApp CN1610 cluster interconnect switches.
In this scenario, what are two valid actions for this installation? (Choose two.)
- A. Create a new 2-node switchless cluster.
- B. Create a new 2-node switched cluster that uses the CN1610 cluster switches.
- C. Add the new nodes to the existing cluster and switches.
- D. Migrate the existing cluster to new switches and add the new nodes.
正解: B,D
解説:
Reference:
https://kb.netapp.com/Advice_and_Troubleshooting/Flash_Storage/AFF_Series/Controller_Hardware_Upgrade3A_Adding_AFF_A250_nodes_to_existing_cluster_report_HA_interconnect_errors_and_c
annot_perform_takeover
質問 48
After the installation of a new ONTAP 9.8 cluster, you have to verify if AutoSupport works.
In this scenario, which two commands would you use to accomplish this task? (Choose two.)
- A. system node autosupport invoke
- B. system node autosupport check show
- C. system node autosupport history show
- D. system node autosupport destination show
正解: B,C
質問 49
After moving a new AFF A400 cluster into production, the administrator notices error events in ONTAP System Manager regarding SAS HA issues.
In this scenario, which NetApp tool would have identified these errors after the installation process?
- A. Active IQ Config Advisor
- B. Cloud Manager
- C. Active IQ Unified Manager
- D. ONTAP System Manager
正解: D
質問 50
While testing a recently installed FAS8700 cluster, a node fails. You now need to replace the impaired node.
In this scenario, which two statements are true? (Choose two.)
- A. You must move the boot device from the impaired node to the replacement node.
- B. The boot device must remain intact and must not be removed from the impaired node.
- C. A controller model of the same type must be used to replace the impaired node.
- D. You can change any drives or disk shelves as part of this replacement procedure.
正解: A,C
質問 51
You are installing a new FAS2750 cluster with 24 HDDs for a customer to run a NAS workload. The customer requests that the HA pair have only a single aggregate that is located on Node 1. Maximum capacity is required.
Which action must be performed to ensure that the customer's requests are satisfied?
- A. Assign all data LIFs to Node 1.
- B. Assign all the data partitions from Node 2 to Node 1, and create a single aggregate.
- C. Perform a takeover of Node 2 to ensure that it does not run.
- D. Assign all the partitioned disks from Node 2 to Node 1, and create a single aggregate.
正解: A
質問 52
......
Network Appliance NS0-184試験実践テスト問題：https://jp.fast2test.com/NS0-184-premium-file.html
最新の認定試験NS0-184問題集-実践テスト問題：https://drive.google.com/open?id=1ems23gcX2lLgKnYMOjHRhqNXMSku3Xnb