お手軽に合格させる 最新Fortinet NSE7_SDW-6.4問題集には82問があります
最新のNSE7_SDW-6.4学習ガイド2023年最新の- 提供するのはテストエンジンとPDF
Fortinet NSE7_SDW-6.4試験は、ITプロフェッショナルがSD-WAN技術のスキルと知識を向上させることを目的として設計されており、今日のデジタル時代にますます重要性が高まっています。認定は、ITプロフェッショナルにとって求人市場での競争力を高め、キャリアを進めることを支援します。さらに、認定は、候補者が組織のビジネス要件を満たす安全なSD-WANソリューションを設計・展開するために必要な専門知識を持っていることを示しています。
質問 # 40
Refer to the exhibit.
Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)
- A. The measured bandwidth is less than 100 KBps.
- B. The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.
- C. The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.
- D. The traffic shaper drops packets if the bandwidth is less than 2500 KBps.
正解：A、B
質問 # 41
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link neighbor.
- B. diagnose sys virtual-wan-link service
- C. diagnose sys virtual-wan-link route-tag-list
- D. diagnose sys virtual-wan-link member.
正解：D
質問 # 42
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
- B. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
- C. The dead member interface stays unavailable until an administrator manually brings the interface back.
- D. Check interval is the time to wait before a packet sent by a member interface considered as lost.
正解：A
質問 # 43
Which diagnostic command can you use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys sdwan intf-sla-log
- B. diagnose sys sdwan log
- C. diagnose sys sdwan sla-log
- D. diagnose sys sdwan health-check
正解：C
解説：
diagnose sys sdwan intf-sla-log -> shows only bandwidth utilization
diagnose sys sdwan sla-log -> shows packet-loss, latency, jitter, MOS
質問 # 44
What is the lnkmtd process responsible for?
- A. Processing performance SLA probes
- B. Flushing route tags addresses
- C. Logging interface quality information
- D. Monitoring links for any bandwidth saturation
正解：D
質問 # 45
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify incoming interfaces in SD-WAN rules.
- B. Configure SD-WAN rules interface preference.
- C. Select SD-WAN balancing strategy.
- D. Specify outgoing interface routing cost.
正解：B
質問 # 46
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology
Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )
- A. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
- B. London generates an IKE information message that contains the Toronto public IP address.
- C. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- D. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
正解：A、C
解説：
SD-WAN_6.4_Study_Guide page 207
質問 # 47
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- B. It acts as a policy compliance entity to review all managed FortiGate devices.
- C. It improves SD-WAN performance on the managed FortiGate devices.
- D. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- E. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
正解：B、D
質問 # 48
Which statement is correct about SD-WAN and ADVPN?
- A. You must use OSPF.
- B. SD-WAN can steer traffic to ADVPN shortcuts established over IPsec overlays configured as SD-WAN members.
- C. Routes for ADVPN shortcuts must be manually configured.
- D. SD-WAN does not monitor the health and performance of ADVPN shortcuts.
正解：B
質問 # 49
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. Changes have been made on firewall policy ID 1 on FortiGate.
- B. FortiGate has terminated the session after a change on policy ID 1.
- C. Firewall policy ID 1 has source NAT disabled.
- D. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
正解：A
質問 # 50
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. The reverse shaper option must be enabled and a traffic shaper must be selected
- B. The guaranteed-10mbps option must be selected as the reverse shaper option.
- C. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- D. The guaranteed-10mbps option must be selected as the per-IP shaper option
正解：A
質問 # 51
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set source 100.64.1.1.
- B. Set cost 15.
- C. Set priority 10.
- D. Set load-balance-mode source-ip-ip-based.
正解：A
質問 # 52
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. ADVPN should only be enabled on unmanaged FortiGate devices.
- B. On the hub VPN, only the device needs additional phase one settings.
- C. Each VPN device has a unique pre-shared key configured separately on phase one.
- D. The protected subnets should be set to address object to all (0.0.0.0/0).
正解：C
解説：
Explanation/Reference:
質問 # 53
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
- B. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- C. A single user uses the allocated bandwidth divided by total number of users.
- D. The 10 Mbps bandwidth is shared equally among the IP addresses.
正解：A
解説：
Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
質問 # 54
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. FortiGate created a single IPsec virtual interface that is shared by all clients.
- B. 100.64.3.1 is one of the remote IP address that comes through index interface 1.
- C. There are separate virtual interfaces for each dial-up client.
- D. VPN static routes are prevented from populating the FortiGate routing table.
正解：A、B
質問 # 55
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link intf-sla-log
- C. diagnose sys virtual-wan-link sla-lcg
- D. diagnose sys virtual-wan-link log
正解：A
質問 # 56
......
フォーティネット NSE 7 - SD-WAN 6.4 認定試験に特定の前提条件はありませんが、フォーティネットの SD-WAN ソリューションについての知識と経験を持つことが推奨されます。フォーティネットはまた、試験の準備を支援するトレーニングコースを提供しています。
フォーティネット NSE 7 - SD-WAN 6.4 認定を取得することにより、個人のフォーティネットの SD-WAN ソリューションを実装および管理する能力が認められます。この認定は、ネットワークセキュリティの専門家がキャリアを進め、収益性を向上させるのに役立ちます。また、認定保有者は、フォーティネットの NSE トレーニングおよびリソースにアクセスできるため、ネットワークセキュリティの最新のトレンドやテクノロジについて常に情報を得ることができます。
NSE7_SDW-6.4問題集と試験テストエンジン：https://jp.fast2test.com/NSE7_SDW-6.4-premium-file.html
最新版を今すぐ試そうNSE7_SDW-6.4練習テスト問題解答：https://drive.google.com/open?id=1z_p2PV6tpBWEgSx4RIn_GECgHHz_VIrM