FCSS_NST_SE-7.4問題集最新の2025年03月25日練習テスト42リアル解答があります
2025年最新の100%試験高合格率FCSS_NST_SE-7.4問題集PDF
Fortinet FCSS_NST_SE-7.4 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
| トピック 5 |
|
質問 # 20
Refer to the exhibits.
An administrator Is expecting to receive advertised route 8.8.8.8/32 from FGT-A. On FGT-B, they confirm that the route is being advertised and received, however, the route is not being injected into the routing table.
What is the most likely cause of this issue?
- A. FGT-B is configured with a prefix list denying the 8.8.8.8/32 network to be injected into the routing table.
- B. FGT-8 is configured with a distribution list denying the 8.8.8.8/32 network to be injected into the routing table.
- C. The administrator has misconfigured redistribution of routes on FGT-A.
- D. A batter route to the 8.8.8.8/32 network exists in the routing table.
正解：A
質問 # 21
Which statement aboutprotocol options is true?
- A. Protocol options allow administrators to configure the Any setting for all enabled protocols, which provides the most efficient use of system resources.
- B. Protocol options allow administrators to configure a maximum number of sessions for each configured protocol.
- C. Protocol options allow administrators to configure which Layer 4 port numbers map to upper-layer protocols, such as HTTP, SMTP, FTP, and so on.
- D. Protocol options give administrators a streamlined method to instruct FortiGate to block all sessions corresponding to disabled protocols.
正解：C
質問 # 22
Refer to the exhibit.
Which three pieces of information does the diagnose sys top command provide? (Choose three.)
- A. The miglogd daemon is running on CPU core ID 0.
- B. The miglogd daemon would be on top of the list, if the administrator pressed m on the keyboard.
- C. The cmdbsvr process is occupying 2.4% of the total user memory space.
- D. The diagnose sys top command has been running for 18 minutes.
- E. If the neweli daemon continues to be in the R state, it will need to be manually restarted.
正解：A、C、D
質問 # 23
Refer to the exhibit.
Assuming a default configuration, which three statements are true? (Choose three.)
- A. User A: Pass. The default static route through wan1 passes the RPF check regardless of the source IP address.
- B. User C: Fail. There is no route to 10.0.4.63 using port1 in the touting table.
- C. User B: Fail. There is no route to 95.56.234.24 using wan2 in the routing table.
- D. Strict RPF is enabled by default.
- E. User B: Pass. FortiGate will use asymmetric routing using wan1 to reply to traffic for 95.56.234.24.
正解：B、C、E
質問 # 24
In IKEv2, which exchange establishes the first CHILD_SA?
- A. INFORMATIONAL
- B. IKE_Auth
- C. IKE_SA_INIT
- D. CREATE_CHILD_SA
正解：D
質問 # 25
Refer to theexhibit,which shows the output of getrouter info ospf neighbor.
What can you conclude from the command output?
- A. The local FortiGate is not a DROther.
- B. All neighbors are in area 0.0.0.0.
- C. The local FortiGate is the BDR.
- D. The network type connecting the local Fortigate and OSPF neighbor 0.0.0.10 is point-to-point.
正解：D
質問 # 26
Exhibit.
Refer to the exhibit, which contains a screenshot of some phase 1 settings.
The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:
However, the IKE real-time debug does not show any output. Why?
- A. The log-filter setting is incorrect. The VPN traffic does not match this filter.
- B. The administrator must also run the command diagnose debug enable.
- C. The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.
- D. Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.
正解：B
質問 # 27
Exhibit.
Refer to the exhibit, which shows two entries that were generated in theFSSO collectoragent logs.
What three conclusions can you draw from these log entries? {Choose three.)
- A. The FortiGate firmware version is not compatible with that of the collector agent.
- B. A firewall is blocking traffic to port 139 and 445.
- C. DNS resolution is unable to resolve the workstation name.
- D. The user's status shows as "not verified" in the collector agent.
- E. Remote registry is not running on the workstation.
正解：B、D、E
質問 # 28
Refer to the exhibit, which shows the output o! the BGP database.
Which two statements are correct? (Choose two.)
- A. The advertised prefix of 10.20.30.0'24 was configured using the network command.
- B. The first four prefixes are being advertised using a legacy route advertisement.
- C. The advertised prefix of 10.20.30.0'24 is being advertised through the redistribution of another routing protocol.
- D. The output shows all prefixes advertised by all neighbors as well as the local router.
正解：A、D
質問 # 29
Refer to the exhibit, which contains the output ofdiagnose vpn tunnellist.
Which command will capture ESP traffic for the VPN named DialUp_0?
- A. diagnose sniffer packet any 'port 4500'
- B. diagnose sniffer packet any 'esp and host 10.200.3.2'
- C. diagnose sniffer packet any 'ip proto 50'
- D. diagnose sniffer packet any 'host 10.0.10.10'
正解：A
質問 # 30
Exhibit.
Refer to the exhibit, which contains partial output from an IKE real-time debug.
Which two statements about this debug output are correct? (Choose two.)
- A. The initiator provided remote as its IPsec peer ID.
- B. It shows a phase 2 negotiation.
- C. Perfect Forward Secrecy (PFS) is enabled in the configuration.
- D. The local gateway IP address is 10.0.0.1.
正解：A、B
質問 # 31
Refer to the exhibit, which shows partial outputs from two routing debug commands.
Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?
- A. Set the priority of the static default route using port1 to 10.
- B. Set snat-route-change to enable.
- C. Set preserve-session-route to enable.
- D. Set the priority of the static default route using port2 to 1.
正解：A
質問 # 32
Refer to the exhibit, which shows the output of a policy route table entry.
Which type of policy route does the output show?
- A. A regular policy route
- B. An ISDB route
- C. AnSD-WAN rule
- D. A regular policy route, which is associated with an active static route in the FIB
正解：B
質問 # 33
Which two statements about Security Fabric communications are true? (Choose two.)
- A. FortiTelemetry must be manually enabled on the FortiGate interface.
- B. The default port for Neighbor Discovery can be modified.
- C. FortiTelemetry and Neighbor Discovery both operate using TCP.
- D. By default, the downstream FortiGate establishes a connection with the upstream FortiGate using TCP port 8013.
正解：A、D
質問 # 34
Which two statements about an auxiliary session ate true? (Choose two.)
- A. With the auxiliary session setting enabled. Iwo sessions are created in case of routing change.
- B. With the auxiliary session selling disabled, only auxiliary sessions are offloaded.
- C. With the auxiliary session setting enabled. ECMP traffic is accelerated to the NP6 processor.
- D. With the auxiliary session setting disabled, for each traffic path. FortiGate uses the same auxiliary session.
正解：A、C
質問 # 35
Exhibit.
Refer to theexhibit,which shows the output of getsystem ha status.
NGFW-1 and NGFW-2 have been up for a week.
Which two statements about the output are true? (Choose two.)
- A. If FGVM...649 is rebooted. FGVM...650 will become the primary and retain that role, even after FGVM...649 rejoins the cluster.
- B. If port 7 becomes disconnected on the secondary, both FortiGate devices will elect itself as primary.
- C. If a configuration change is made to the primary FortiGate at this time, the secondary will initiate a synchronization reset.
- D. If no action is taken, the primary FortiGate will leave the cluster because of the current sync status.
正解：A、B
質問 # 36
......
検証済みFCSS_NST_SE-7.4問題集と解答100%合格はFast2test：https://jp.fast2test.com/FCSS_NST_SE-7.4-premium-file.html
合格試験完全版合格させる FCSS_NST_SE-7.4問題集42解答：https://drive.google.com/open?id=1bfx5S6-H58OLSDDyB774k6OEQLoRK-sk