[2023年07月] 最新のCompTIA N10-008テスト問題集とオンライン試験エンジン
CompTIA N10-008問題を提供していますCompTIA Network+問題集と完璧な解答付き
CompTIA N10-008試験は、ネットワークアーキテクチャ、プロトコルとサービス、ネットワークオペレーション、ネットワークセキュリティ、トラブルシューティングなど、幅広いトピックをカバーしています。実際のシナリオでネットワークを構成、管理、トラブルシューティングする能力をテストする、パフォーマンスベースの試験です。試験は、多肢選択問題、ドラッグアンドドロップ問題、シミュレーション問題で構成され、90分間の試験時間があります。
CompTIA N10-008は、CompTIA Network+認定試験としても知られており、有線および無線ネットワークを設計、構成、管理、トラブルシューティングするために必要なスキルと知識を検証する広く認知され、尊敬される認定です。この試験は、情報技術分野でのネットワークスキルを向上させ、キャリアを進めたいITプロフェッショナルを対象としています。この認定はベンダー中立であり、特定のメーカーやプラットフォームに結びついていないため、さまざまな産業や組織のプロフェッショナルにとって貴重な資格です。
質問 # 233
Which of the following would be BEST to use to detect a MAC spoofing attack?
- A. Internet Message Access Protocol
- B. Dynamic Host Configuration Protocol
- C. Internet Control Message Protocol
- D. Reverse Address Resolution Protocol
正解：D
質問 # 234
Which of the following connector types would be used to connect to the demarcation point and provide network access to a cable modem?
- A. RJ11
- B. F-type
- C. LC
- D. RJ45
正解：B
解説：
An F-type connector is a type of coaxial connector that is commonly used to connect a cable modem to the demarcation point, which is the point at which the cable provider's network ends and the customer's network begins. The F-type connector is a threaded connector that is typically used for television, cable modem, and satellite antenna connections.
質問 # 235
A branch of a company recently switched to a new ISP. The network engineer was given a new IP range to assign. The ISP assigned 196.26.4.0/26, and the branch gateway router now has the following configurations on the interface that peers to the ISP:
The network engineer observes that all users have lost Internet connectivity. Which of the following describes the issue?
- A. The incorrect interface was configured
- B. The incorrect IP address was configured
- C. The incorrect subnet mask was configured
- D. The incorrect gateway was configured
正解：C
質問 # 236
While setting up a new workstation, a technician discovers that the network connection is only 100 full duplex (FD), although it is connected to a gigabit switch.
While reviewing the interface information in the switch CLI, the technician notes the port is operating at IOOFD but Shows many RX and TX errors. The technician moves the computer to another switchport and experiences the same issues.
Which of the following is MOST likely the cause of the low data rate and port errors?
- A. Incorrect pinout
- B. Duplex issues
- C. Cable length
- D. Bad switch ports
正解：B
質問 # 237
An office area contains two PoE-enabled WAPs. After the area was remodeled, new cable uplinks were installed in the ceiling above the fluorescent lights. However, after the WAPs were reconnected, users reported slowness and application errors. An intern reviewed the network and discovered a lot of CRC errors. A network engineer reviewed the intern's work and realized UTP cabling was used. Which of the following is the MOST likely cause of the CRC errors?
- A. Electromagnetic interference
- B. Wrong cable pinout
- C. Insufficient power at the antennas
- D. PoE and UTP incompatibility
正解：A
解説：
"EMI is a problem when cables are installed near electrical devices, such as air conditioners or fluorescent light fixtures. If a network medium is placed close enough to such a device, the signal within the cable might become corrupt. Network media vary in their resistance to the effects of EMI. Standard unshielded twisted-pair (UTP) cable is susceptible to EMI, whereas fiber cable, with its light transmissions, is resistant to EMI. When deciding on a particular medium, consider where it will run and the impact EMI can have on the installation."
質問 # 238
A network administrator is designing a wireless network. The administrator must ensure a rented office space has a sufficient signal. Reducing exposure to the wireless network is important, but it is secondary to the primary objective. Which of the following would MOST likely facilitate the correct accessibility to the Wi-Fi network?
- A. MU-MIMO
- B. Channel utilization
- C. Polarization
- D. Antenna type
- E. Channel bonding
正解：C
質問 # 239
A network technician is investigating an issue with a desktop that is not connecting to the network. The desktop was connecting successfully the previous day, and no changes were made to the environment. The technician locates the switchport where the device is connected and observes the LED status light on the switchport is not lit even though the desktop is turned on Other devices that arc plugged into the switch are connecting to the network successfully Which of the following is MOST likely the cause of the desktop not connecting?
- A. Transceiver mismatch
- B. Damaged cable
- C. VLAN mismatch
- D. Duplex mismatch
- E. Port security
正解：B
解説：
A damaged cable is most likely the cause of the desktop not connecting to the network. A damaged cable can cause physical layer issues such as loss of signal, attenuation, interference, or crosstalk. These issues can prevent the desktop from establishing a link with the switch and result in the LED status light on the switchport being off. Other possible causes of physical layer issues are faulty connectors, ports, or transceivers. Reference: https://www.cisco.com/c/en/us/support/docs/lan-switching/ethernet/14119-37.html
質問 # 240
A network technician is investigating an IP phone that does not register in the VoIP system Although it received an IP address, it did not receive the necessary DHCP options The information that is needed for the registration is distributes by the OHCP scope All other IP phones are working properly. Which of the following does the technician need to verify?
- A. Transceiver mismatch
- B. DHCP exhaustion
- C. VLAN mismatch
- D. Latency
正解：C
解説：
A VLAN mismatch is the most likely reason why an IP phone does not receive the necessary DHCP options for registration. A VLAN mismatch occurs when a device is connected to a switch port that belongs to a different VLAN than the device's intended VLAN. This can cause communication problems or prevent access to network resources. For example, if an IP phone is connected to a switch port that belongs to the data VLAN instead of the voice VLAN, it may not receive the DHCP options that contain information such as the TFTP server address, the NTP server address, or the default gateway address for the voice VLAN. These DHCP options are essential for the IP phone to register with the VoIP system and function properly. Reference: https://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-callmanager/13979-dhcp-option-150-00.html
質問 # 241
A company wants to set up a backup data center that can become active during a disaster. The site needs to contain network equipment and connectivity. Which of the following strategies should the company employ?
- A. Warm
- B. Cloud
- C. Cold
- D. Active-active
正解：A
質問 # 242
A network is experiencing a number of CRC errors during normal network communication. At which of the following layers of the OSI model will the administrator MOST likely start to troubleshoot?
- A. Layer 3
- B. Layer 4
- C. Layer 5
- D. Layer 6
- E. Layer 7
- F. Layer 2
- G. Layer 1
正解：G
解説：
CRC errors are cyclic redundancy check errors that occur when data is corrupted during transmission. CRC errors are usually caused by physical layer issues such as faulty cables, connectors, ports, or interference. The network administrator will most likely start to troubleshoot at layer 1 of the OSI model, which is the physical layer that deals with the transmission of bits over a medium. Reference: CompTIA Network+ Certification Exam Objectives Version 2.0 (Exam Number: N10-006), Domain 4.0 Network Troubleshooting and Tools, Objective 4.1 Given a scenario, implement network troubleshooting methodology.
質問 # 243
Users are reporting poor wireless performance in some areas of an industrial plant The wireless controller is measuring a tow EIRP value compared to me recommendations noted on me most recent site survey. Which of the following should be verified or replaced for the EIRP value to meet the site survey's specifications? (Select TWO).
- A. Channel utilization
- B. AP association time
- C. Antenna gain
- D. AP transmit power
- E. Update ARP tables
- F. Signal loss
正解：C、D
解説：
AP transmit power: You should check if your APs have sufficient power output and adjust them if needed. You should also make sure they are not exceeding regulatory limits for your region.
Antenna gain: You should check if your antennas have adequate gain for your coverage area and replace them if needed. You should also make sure they are aligned properly and not obstructed by any objects.
In the scenario described, the wireless controller is measuring a low EIRP value compared to the recommendations noted in the most recent site survey. EIRP is the combination of the power transmitted by the access point and the antenna gain. Therefore, to increase the EIRP value to meet the site survey's specifications, the administrator should verify or replace the AP transmit power (option A) and the antenna gain (option E). This can be achieved by adjusting the transmit power settings on the AP or by replacing the AP's antenna with one that has a higher gain
質問 # 244
A network attack caused a network outage by wiping the configuration and logs of the border firewall. Which of the following sources, in an investigation to determine how the firewall was compromised, can provide the MOST detailed data?
- A. MIB of the attacked firewall
- B. Syslog server messages
- C. Network baseline reports
- D. NetFlow aggregate data
正解：B
質問 # 245
A network administrator is configuring logging on an edge switch. The requirements are to log each time a switch port goes up or down. Which of the following logging levels will provide this information?
- A. Alert
- B. Warnings
- C. Notifications
- D. Errors
正解：C
解説：
Explanation
Notifications are the lowest logging level and will provide the desired information regarding switch port up/down activity. According to the CompTIA Network+ Study Manual, notifications "are used for logging normal activities, such as port up/down events, link changes, and link flaps."
質問 # 246
A technician is installing a cable modem in a SOHO. Which of the following cable types will the technician MOST likely use to connect a modem to the ISP?
- A. Cat 6e
- B. Coaxial
- C. Single-mode fiber
- D. Multimode fiber
正解：B
解説：
Coaxial cable is a type of cable that consists of a central copper conductor surrounded by an insulating layer and a braided metal shield. Coaxial cable is commonly used to connect a cable modem to an ISP by transmitting data over cable television networks. Coaxial cable can support high bandwidth and long distances with minimal interference or attenuation. Reference: https://partners.comptia.org/docs/default-source/resources/comptia-network-n10-008-exam-objectives-(2-0), https://www.techopedia.com/definition/4027/coaxial-cable
質問 # 247
Which of the following is used to prioritize Internet usage per application and per user on the network?
- A. Border Gateway Protocol
- B. Administrative distance
- C. Bandwidth management
- D. Load balance routing
正解：C
解説：
Bandwidth management is used to prioritize Internet usage per application and per user on the network. This allows an organization to allocate network resources to mission-critical applications and users, while limiting the bandwidth available to non-business-critical applications. Reference: Network+ Certification Study Guide, Chapter 2: Network Operations
質問 # 248
An organization is interested in purchasing a backup solution that supports the organization's goals. Which of the following concepts would specify the maximum duration that a given service can be down before impacting operations?
- A. RTO
- B. MTTR
- C. MTBF
- D. RPO
正解：A
解説：
Explanation
The maximum duration that a given service can be down before it impacts operations is often referred to as the Recovery Time Objective (RTO). RTO is a key consideration in any backup and disaster recovery plan, as it determines how quickly the organization needs to be able to recover from a disruption or failure. It is typically expressed in terms of time, and it helps to inform the design and implementation of the backup solution. For example, if an organization has a critical service that must be available 24/7, it may have a very low RTO, requiring that the service be restored within a matter of minutes or even seconds. On the other hand, if the service can be down for a longer period of time without significantly impacting operations, the organization may have a higher RTO. When selecting a backup solution, it is important to consider the organization's RTO requirements and ensure that the solution is capable of meeting those needs. A solution that does not meet the organization's RTO requirements may not be sufficient to ensure the availability of critical services in the event of a disruption or failure.
質問 # 249
Which of the following uses the destination IP address to forward packets?
- A. A router
- B. A Layer 2 switch
- C. A bridge
- D. A repeater
正解：A
質問 # 250
Which of the following transceiver types can support up to 40Gbps?
- A. SFP+
- B. QSFP+
- C. QSFP
- D. SFP
正解：B
質問 # 251
......
2023年最新のN10-008テスト解説（更新されたのは496問があります)：https://jp.fast2test.com/N10-008-premium-file.html
信頼され続けるN10-008試験のコツがあるPDF試験材料：https://drive.google.com/open?id=1YER7qCbpQxe272VBUTo_gtazDsg4JadM