[2023年05月] 学習材料には有効なHPE0-J58効率的問題集！ [Q53-Q71]

[2023年05月] 学習材料には有効なHPE0-J58効率的問題集！

最新のHPE0-J58テストエンジンPDF無料問題集保証！

質問 53
Refer to the exhibit.

A customer requests a solution for two 3PAR 8450 storage arrays using synchronous replication. The customer wants the array configured to...
A junior architect you are coaching created the configuration shown for each array What should you add to me configuration for each array to meet customer performance requirements?

A. 32 additional SSD drives
B. SAS bus multiplexers
C. 4 additional disk enclosures
D. 1 additional pair of nodes

正解: D

質問 54
A customer established a remote site with an HPE 3PAR 2O0O0 array and wants to implement Remote Copy tor data protection The environment has these specifications
* Two locations of arrays are less than 1 km apart
* The locations are limited to an existing shared link that cannot be upgraded
* Data only changes on a weekly basis, but needs to be available if the primary site fails.
Based on this information. which type of replication mode meets all these needs?

A. Synchronous Long Distance
B. Synchronous
C. Asynchronous Periodic
D. Asynchronous Streaming

正解: B

質問 55
Click and drag the steps on the left into the appropriate order on the right to set up an HPE 3PAR array in InfoSight.

正解:

解説:

質問 56
A customer configured the RCIP ports on two HPE 3PAR arrays, and cabled them to the respective networks. The remote copy links between the arrays are established, and the remote copy service Is started successfully. The customer wants to ensure they have a latency lower than 5 ms and can support a throughput of 8 Gb/s.
What should you do to verify the links are correctly sized to support the replication bandwidth required?

A. Check the relink statistics reported in InfoSight
B. Use the relink status check from the 3PAR SSMC
C. Ask the network administrator to check the latency
D. Use the checkrclink command from the 3PAR CLI.

正解: D

質問 57
A customer has a primary site with an HPE Nimble Storage array and a secondary site with another HPE Nimble Storage array. The customer had a planned power outage at their primary site, and now needs to switch back to the primary array.
Place the steps into the order they must be performed to switch back the primary array.

正解:

解説:

質問 58
A customer has a pair of HPE 3PAR arrays with Synchronous Replication enabled. They need recommendations for deploying the Quorum Witness when implementing Peer Persistence.
What should you recommend to the customer?

A. The Quorum Witness should be in the secondary data center, with IP connectivity to the HPE 3PAR there
B. The Quorum Witness should be in a third data center, with IP connectivity to both HPE 3PARs
C. The Quorum Witness should be in a third data center, with FC connectivity to both HPE 3PARs
D. The Quorum Witness should be in the primary data center, with FC connectivity to the HPE 3PAR there

正解: C

解説:
Explanation/Reference:
Reference: https://h20195.www2.hpe.com/v2/GetPDF.aspx/4AA5-8914ENW.pdf

質問 59
A customer experienced data loss due to a cybersecurity attack. The data could not be restored because the snapshots and backups of the data were also affected.
The customer currently uses HPE 3PAR and RMC as a backup strategy You propose HPE StoreOnce Cloud Bank as an additional backup target.
How can this help mitigate the risk of future cybersecurity attacks?

A. by providing instantaneous recovery from Azure with RMC Express
B. by providing an offsite copy of the customer's data
C. by providing support as an alternate replication target for 3PAR arrays
D. by providing support to hosting of VMware Datastores for fast recovery

正解: B

質問 60
A customer needs to new storage solution, including replication. The replication solution does not need to provide an RTO or RPO of zero.
The customer suffers from severe VM sprawl and has experienced unidentified storage service-level degradations.
What should you point out during your presentation of the solution?

A. InfoSight and VM details would help in identifying misbehaving VMs putting a high load on the array
B. VMs are always individually visible to the array with automatic enablement of VVOL technology
C. When a storage system is being overloaded, the replication software will automatically move the workload
D. Hardware-assisted parity generation and deduplication mitigate the changing performance requirements

正解: B

質問 61
Refer to the exhibit, which reflects the Bill of Materials (BOM) configuration for one datacenter.

A customer needs a new storage solution of two HPE 3PAR 8440 arrays. The customer's environment consists of eight physical servers in each data center attached to the SAN and one StoreOnce 3540 system with two FC I/O cards. The distance between data centers is less than 75 meters.
What should you add the BOM to meet the customer needs?

A. one HPE 3PAR StoreServ 8000 Direct Connect Cabling Option for Drive Enclosure for each HPE
3PAR 8440
B. one HPE SN3000B SAN Switch 12-port Upgrade E-LTU per switch, appropriate number of SFPs and cables
C. one HPE 25m Mini SAS High Density Active Optical Cable for each HPE 3PAR 8440
D. one HPR 3PAR StoreServ AC RPS Service Processor

正解: D

質問 62
Refer to the exhibit.

A customer asks you to design an HPE 3PAR 9450 solution with 64 3 84 TB SSDs using RAID 6 (6+2). The customer does not want to lose data It an entire drive enclosure Is lost
What must be added to the Bill of Materials shown to meet these requirements?

A. 8 HPE External 2.0m(6ft) Mini-SAS HD 4x to Mini-SAS HD 4x Cable
B. 1 HPE 3PAR Policy Manager Software E-LTU
C. 4 HPE 3PAR 9000 24-disK 2U SFF (2 5ln) SAS Drive Enclosure
D. 1 HPE 3PAR StoreServ RPS Service Processor

正解: C

質問 63
A customer needs to replace outdated storage arrays.
Which resource provides the necessary information to properly size a solution?

A. HPE Ninja Stars for Nimble
B. HPE Storage Assessment Foundry
C. HPE Storage Sizer
D. HPE NinjaCrawler

正解: C

質問 64
A customer attempts to test HPE 3PAR Peer Persistence automated failover by disconnecting the Quorum Witness (QW) link at the source 3PAR. then disconnecting the Remote Copy <RC) link at the source 3PAR one minute later However, failover does not occur What should you do differently to test Peer Persistence automated failover?

A. The QW and RC links should be disabled at the source array more than 1 minute apart
B. The QW and RC links should be disabled at the source array within 10 seconds of each other
C. The RC links should be disconnected from both arrays more than 1 minute apart
D. The RC links should be disconnected from both arrays within 10 seconds or each other.

正解: B

質問 65
A customer is considering an upgrade. The company currently uses host-based data replication .You propose an HPE 3PAR multi-site solution, including RCIP and Peer Persistence.
Which advantage of the HPE 3PAR based replication solution should you emphasize?

A. It uses a full-mesh network topology to distribute the data
B. it can duplicate the data on the HBA and networking layer
C. It can increase the available bandwidth for the replication solution
D. It will free host CPU cycles, which are then available to applications.

正解: D

質問 66
A customer requires an all-flash solution that will scale out, with multiple arrays for replication. The customer also needs the solution to provide more data per terabyte of flash storage than competing solutions.
Which HPE program should you leverage in your solution to help meet the customer's requirements?

A. HPE Store More Guarantee
B. HPE Get 6-Nines Guarantee
C. HPE Nimble Timeless Storage
D. HPE Get Thin Guarantee

正解: C

質問 67
A customer has two sites. The link between sites is Fibre Channel, and the distance between sites is less than
1km. The link latencies are within HPE recommended tolerances.
The customer asks you to design a Peer Persistent solution using HPE servers running physical Windows
2016 servers and HPE 3PAR storage.
What are characteristics of the Quorum Witness? (Select two.)

A. A Peer Persistence Quorum Witness is required for normal HPE 3PAR Peer Persistence operation
B. Quorum Witness becomes relevant only during 3PAR Peer Persistence failover
C. A physical implementation of the Peer Persistence Quorum Witness is required on a third site
D. A virtual implementation of the Peer Persistence Quorum Witness is required on a third site
E. The Quorum Witness initiates the fail-over, passing control to the standby array

正解: A,D

質問 68
A customer has standardized on Windows Server. They need to ensure that application and storage will move between sites as one during automated or manual failover. Which HPE 3PAR integrated solution should you recommend to the customer as a preventative measure?

A. Site Recovery Manager
B. Serviceguard Metrocluster
C. Peer Persistence
D. Cluster Extension (CLX)

正解: B

解説:
Reference:
20Paper_HPE%20ConvergedSystem%20700.pdf?epslanguage=en

質問 69
A customer needs to analyze performance and capacity of their storage environment. Their environment consists of HPE 3PAR, EMC VNX, and Pure Systems.
Which tool should you use to begin your assessment of their environment?

A. SAF Collect
B. HPE Infosight
C. DD Analyzer
D. NinjaCrawler

正解: D

質問 70
Refer to the exhibit.

A customer is considering a new HPE 3PAR for the purpose of implementing deduplication and compression.
Based on the output returned from the NinjaCrawler tool, what do you know about the customer data?