2022年最新の実際に出ると確認された 無料HP HPE6-A71試験問題
HPE6-A71リアル試験問題解答は無料
質問 57
Which VPN component must be configured on the Mobility Master (MM) to allow a RAP to use the built-in certificate to successfully connect to a Mobility Controller (MC)?
- A. IPSec pre-shared key
- B. IP Address pool
- C. VPN username and password
- D. CPSec auto-whitelist
正解: D
質問 58
Refer to the exhibit.
Controllers are configured in a cluster as shown in the exhibit. These are the network details.
-A Mobility Master (MM) managers the cluster.
-The cluster contains two controllers: C1 and C2.
-AP1 and AP2 use C1 as their Active AP Anchor Controller (A-AAC), with C2 as their Standby AAC (S-AAC).
-AP3 and AP4 use C2 as their A-AAC with, C1 as their S-AAC.
User1 establishes a wireless connection via AP1, where the Active User Controller (U-UAC) assigned is C1, with C2 as the standby. What happens when User1 roams the wireless network and eventually their session is handled by AP3?
- A. The AP3's A-AAC switches to C1, and the user's A-UAC remains on C1.
- B. The AP3's A-AAC switches to C1, and the user's A-UAC remains on C2.
- C. The AP3's A-AAC switches to C2, and the user's A-UAC remains on C1.
- D. The AP3's A-AAC switches to C2, and the user's A-UAC remains on C2.
正解: C
質問 59
An administrator mistakenly configures the wrong VLAN setting on a managed controller's interface. This causes the controller to lose management access to the Mobility Master (MM).
Which mechanism will then attempt to restore the previous working configuration on the managed controller?
- A. restore config
- B. auto-rollback
- C. bulk configuration
- D. disaster recovery
正解: B
質問 60
Refer to theexhibit.
An administrator configures a policy for an AP Group. Port 3 of a RAP is a trunk that connects to a switch at a branch office. VLAN 1 is untagged and VLANs 10 (for data) and 11 (for voice) are tagged. The administrator applies an ACL inbound on Port 3 of the RAP.
How does this configuration affect traffic on Port 3?
- A. It filters traffic from VLAN 10 and 11, but allows traffic from VLAN1.
- B. It filters traffic form VLAN 1, but allows traffic from VLANs 10 and 11.
- C. It filters traffic from VLANs 1, 10, and 11.
- D. It allows all traffic formVLANs 1, 10, and 11.
正解: A
質問 61
An administrator creates new pre-and post-authentication roles for a new WLAN. For which profile should the administrator assign these new roles under the Managed Network section?
- A. 802.1X
- B. Server Groups
- C. Virtual AP
- D. AAA profile
正解: D
質問 62
An administrator deploys Aruba Mobility Controller 7005s to a company's branch offices. The administrator wants to disable the console port to prevent unauthorized access to the controllers.
Which controller command should the administrator use to implement this policy?
- A. no console enable
- B. mgmt-user console-block
- C. no mgmt-user console
- D. console disable
正解: B
質問 63
An administrator configures Unified Communications and Collaboration (UCC) heuristics mode on an Aruba Mobility Master (MM). What should be modified in order to send items such as VoIP sessions and monitored information about adds, updates, deletions, and periodic snapshots of those VoIP sessions on the MM or the Aruba Mobility Controller (MC)?
- A. OpenFlow Controller profile
- B. OpenFlow profile
- C. Mgmt Config profile
- D. Skype ALG Configuration profile
正解: A
質問 64
An administrator wants to implement 802.1X authentication on Ethernet ports on branch office controllers.
What must the administrator do to implement this policy?
- A. Define the port as trusted, and assign an AAA policy tothe VLAN.
- B. Define theport an untrusted, and assign an AAA policy to the port.
- C. Define the port as trusted, and assign an AAA policy to the port.
- D. Define the port as untrusted, and assign an AAA policy to the VLAN.
正解: A
質問 65
An administrator implements the Aruba AitGroup feature to accommodate the Apple Bonjour service. In this implementation, which protocol advertises devices such as printers, computers, and their services?
- A. Multicast DHCP
- B. Broadcast DNS
- C. Multicast DNS
- D. LLDP
正解: C
質問 66
Refer to the exhibit.
An administrator sets up a cluster of Aruba Mobility Controllers (MCs). What can the administrator determine about the cluster from the command output shown in the exhibit?
- A. This is an L3-connected cluster.
- B. User load balancing is enabled.
- C. AP load balancing is enabled.
- D. This is an L2-connected cluster.
正解: B
質問 67
Refer to the exhibit.
What is true about the operation of the Aruba Mobility Controller (MC) shown in the exhibit?
- A. The disaster recovery mode is disabled, and changes will be sent to the Mobility Master.
- B. The disaster recovery mode is enabled, and no changes will be forwarded to the Mobility Master.
- C. The disaster recovery mode is enabled, and changes will be sent to the Mobility Master.
- D. The Mobility master is in disaster recovery mode and will push changes to a Managed Controller.
正解: B
質問 68
Refer to the exhibit.
Controllers are configured in a cluster as shown in the exhibit. These are the network details.
* A Mobility Master (MM) manages the cluster.
* The cluster contains two controllers C1 and C2.
* AP1 and AP2 use C1 as their Active AP Anchor Controller (A-AAC), with C2 as their Standby AAC (S-AAC).
* AP3 and AP4 use C2 as their A-AAC, with C1 as their S-AAC.
User1 establishes a wireless connection via AP1, where the Active User Anchor Controller (A-UAC) assigned is C1, with C2 as the standby. What happens when User1 roams the wireless network and eventually their session is handled by AP3?
- A. The AP3's A-AAC remains on C2, and the user's A-UAC switches to C2.
- B. The AP3's A-AAC remains on C2, and the user's A-UAC remains on C1.
- C. The AP3's A-AAC switches to C1, and the user's A-UAC switches to C2.
- D. The AP3's A-AAC switches to C1, and the user's A-UAC remains on C1.
正解: B
解説:
Explanation
質問 69
An administrator deploys an Aruba wireless solution comprised of:
-a pair of Mobility Masters (MMs)
-multiple Mobility Controllers (MCs) and virtual Mobility Controllers (VMCs)
-an AirWave server
-a ClearPass server
The Aruba Mobility solution runs ArubaOS 8.X.
Which component in this environment globally defines and deploys VLANs for wireless users?
- A. Mobility Controller or Virtual Mobility Controller
- B. AirWave server
- C. Mobility Master
- D. ClearPass server
正解: C
解説:
Explanation
https://www.arubanetworks.com/products/networking/gateways-and-controllers/mobility-master/
質問 70
Refer to the exhibit.
An administrator wants to verify the operation of MultiZone in a network. The administrator uses the command show ap debug multizone to generate the output shown in the exhibit.
Based on the output, which statement is true?
- A. The primary zone has limited the data zoneto one WLAN.
- B. Zone 1 is the primary zone, and zone 0 is the data zone.
- C. The MultiZone APs are in a cluster.
- D. The maximum VAPs in the MultiZone is 15.
正解: A
質問 71
An AP connects to a controller. Then, the AP loses power and reboots.
Which parameters will the AP remember and use from its initial connection? (Selecttwo.)
- A. Mobility Master IP
- B. AirWave server name
- C. Server IP
- D. AP group
- E. AP IP address and subnet mask
正解: D,E
質問 72
An administrator manages an Aruba wireless solution, deployed in a company with locations across the world.
In one country, the local government organization that controls wireless transmissions increases the maximum EIRP allowed for certain channels.
Which component does the administrator need to update on the Mobility Master (MM) to accommodatethis change?
- A. the AP Group configuration
- B. the AP system profile
- C. the regulatory-cert file
- D. the Controller port configuration
正解: B
質問 73
An administrator implements a per-port tunneled node configuration for an Aruba Mobility Controller (MC) that runs ArubaOS 8.x. The controller performs both MAC and 802.1X authentication.
What must the administrator specify on the controller to allow for 802.1X authentication to succeed?
- A. Enable L2 Authentication Fail Through in the AAA profile.
- B. Define MAC addresses in the local database for the 802.1X users.
- C. Define External RADIUS servers in the AAA profile.
- D. Enable server roles in the AAA profile.
正解: A
質問 74
An administrator supports Aruba Mobility Controllers (MCs) managed by a Mobility Master (MM) in a non- cluster deployment. The administrator performs these tasks on the MM for the MCs:
* Enables L3 IP mobility for the respective VAPs on the MCs
* Creates a L3 domain and places the MCs in the domain
However, roaming does not work when users roam from an AP connected to one controller in the domain to an AP connected to a different controller in the domain.
What must the administrator do to fix this problem?
- A. Configure the same VLANs on the Mobility Controllers in the L3 domain.
- B. Re-provision the APs associated with the Mobility Controllers.
- C. Enable L3 IP Mobility globally on the Mobility Controllers.
- D. Create a home-agent-to-foreign-agent mapping table.
正解: D
質問 75
Which Aruba AP mode constantly scans the radioenvironment to gather IDS and RF information?
- A. Mesh Portal
- B. Spectrum AP
- C. Air Monitor
- D. RAP
正解: C
質問 76
Refer to the exhibit.
An administrator wants to verify the operation of MultiZone in a network. The administrator uses the command show ap debug multizoneto generate the output shown in the exhibit.
Based on the output, which statement is true?
- A. Zone 1 is the primary zone, and zone 0 is the data zone.
- B. The primary zone has limited the data zone to one WLAN.
- C. The MultiZone APs are in a cluster.
- D. The maximum VAPs in the MultiZone is 15.
正解: B
質問 77
An administrator has a cluster ofAruba Mobility Controllers (MCs). The administrator wants to manually reboot one of the controllers.
Before rebooting, which command should the administrator use to move the APs?
- A. lc-cluster move ap
- B. active-ap-rebalance
- C. active-ap-lb
- D. apmove
正解: A
質問 78
A VIA client tries to initially connect to corporate office controller through an intermediate firewall. However, the VPN connection fails. The administrator examines the firewall rules and determines that rules for UDP
4500 and UDP 500 are configured.
Which additional protocol must be allowed in the firewall rules to resolve this connection failure?
- A. UDP 4500
- B. TCP 993
- C. UDP 8200
- D. TCP 389
正解: A
質問 79
......
試験問題集でHPE6-A71練習無料最新のHP練習テスト：https://jp.fast2test.com/HPE6-A71-premium-file.html
HPE6-A71試験問題、リアルHPE6-A71練習問題集：https://drive.google.com/open?id=1T2yRaA6l8roX6Ss4N9OZ2ax_GRKq1FZA