
有効なHPE7-A04テスト解答HP HPE7-A04試験PDF問題を試そう
HP HPE7-A04認定リアル2024年最新の模擬試験合格させます
HP HPE7-A04 認定試験の出題範囲:
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
質問 # 13
What Fiber Optic standard supports up to 400 Gbps
- A. QSFP28
- B. QSFP+
- C. QSFP-DD
- D. No standard supports that bandwidth
正解:C
質問 # 14
In a Spine and Leaf Design with the following specs:
* 8400 100G Spine Switches
* 8360 48-P 10G RJ45 Leaf Switches
* 100G DAC connections between Spine and Leafs
Spine Switches = 8400 with 12 QSFP28 ports (F-B airflow)
Each Spine Switch uses:
* 1 x 100G QSFP28 5M DACs to each Leaf switch
Each Leaf Switch uses:
* 1 x 100G QSFP28 5M DACs to each Spine switch
* 2 x 100G 1M DAC for ISL
* 1 x 10G RJ45 for Keep alive
Each Spine switch can support up to 48 available 100G QSFP28 interfaces.
What is the scalability for this solution?
- A. Solution can scale to 6 total racks using the same subscription rates.
- B. Solution can scale to 48 total racks using the same subscription rates.
- C. Solution can scale to 12 total racks using the same subscription rates.
- D. Solution can scale to 24 total racks using the same subscription rates.
正解:D
質問 # 15
What is recommended for the routing protocol setup on leaf VSX pairs?
- A. Do not configure the routing protocol to run directly between the leaf VSX members
- B. Add a dedicated VLAN to the VSX ISL, assign it a /31 subnet, and run the routing protocol on it
- C. Have the VSX members connect to each spine switch on an L3 VSX LAG and become neighbors with each other and the spine on its subnet
- D. Configure the leaf VSX members to establish neighbor relationships with each other over one of the server subnets
正解:B
質問 # 16
In Routing design for a two-tier topology between the data center and other parts of the network, select the best option from below
- A. You should not use VSX LAGs for these connections
- B. Set up each link as an L3 interface or routed-only port (ROP)
- C. Don't use Layer 3 links
- D. Establish point-to-point links using individual /29 subnets
正解:B
質問 # 17
In L3 Spine and Leaf design, which answer is correct?
- A. Leaf switches connect to other leaf switches
- B. Each spine switch connects to all other spine switches in a full mesh
- C. Leaf switches connect to only one spine switch
- D. Each leaf switch connects to each spine switch
正解:D
質問 # 18
In defining availability requirements for applications and services, the applications that directly impact health and safety are called
- A. Life-Critical Applications
- B. Team-Critical Applications
- C. Business-Critical Applications
- D. Mission-Critical Applications
正解:A
質問 # 19
How many SFP28 port-groups do Aruba 8325 CX switches have?
- A. One port-group of 48 ports
- B. 4 port-groups of 8 ports each
- C. 4 port-groups of 12 ports
- D. 12 port-groups of 4 ports each
正解:C
質問 # 20
You created a formal proposal and quote for a customer's data center network refresh. What is some other support information that you should include? (Select two)
- A. A list of VLANs that you plan to configure on the switches
- B. A list of IP addresses that you plan to configure on the switches
- C. No need to include any of these as the proposal is not the place to educate the customer on them
- D. HPE Aruba networking recommends including a block diagram with proposals
正解:A、D
質問 # 21
You are designing an overlay solution for two Data Centers based on the Aruba CX platform. Each Data Center has two rooms and each room is its own fabric. What is used for EVPN advertisements between data center rooms?
- A. Not supported design
- B. Static Routing
- C. iBGP
- D. eBGP
正解:D
質問 # 22
ERPS (Ethernet Ring Protection Switching):
- A. Prevents broadcast storms and implements fast-traffic switchover on a network where there are loops
- B. Is not supported on CX 8400 switch series
- C. Does not prevent broadcast storms but implements fast-traffic switchover on a network where there are loops
- D. Is not supported on CX 6400 switch series
正解:A
質問 # 23
You are designing an overlay solution for two Data Centers based on the Aruba CX platform. Each Data Center has two rooms and each room is its own fabric. What is the underlay routing protocol run within each room?
- A. OSPF
- B. eBGP
- C. IS-IS
- D. iBGP
正解:A
質問 # 24
You are adding EVPN VXLAN to an L3 spine and leaf topology that uses OSPF for the underlay. You plan to use a single BGP AS. Which design for EVPN neighbors is correct?
- A. Leaf switches should establish iBGP sessions with spine switches on their actual P2P link IP addresses.Route reflectors are not required
- B. At least one spine switch should act as route reflector and specify the leaf switches' unique loopback IPs as route reflector clients
- C. The border leaf switches should act as route reflectors and specify the leaf switches' VXLAN loopback IPs as route reflector clients
- D. Leaf switches should establish iBGP sessions with other leaf switches using their VXLAN loopback IPs. Route reflectors are not required
正解:B
質問 # 25
You are designing a Data Center with Spine Leaf architecture. Spine Switches are 8400 with 12 QSFP28 ports (F-B airflow) and leaf switches are 8360 switches stacked with VSX in each rack. The Customer sent you the following Specifications Each Spine Switch uses:
* 1 x 100G QSFP28 5M DACs to each Leaf switch Each Leaf Switch uses:
* 1 x 100G QSFP28 5M DACs to each Spine switch
* 2 x 100G 1M DAC for ISL
* 1 x 25G SFP28 DAC for Keep alive
What is the scalability in this design?
- A. Solution can scale to 48 total racks using the same subscription rates.
- B. Solution can scale to 36 total racks using the same subscription rates.
- C. Solution can scale to 12 total racks using the same subscription rates.
- D. Solution can scale to 24 total racks using the same subscription rates.
正解:D
質問 # 26
What is the maximum number of spines (when using 2 uplink ports for VSX) for CX 8325-48Y8C with Leaf- to-spine port speed 40 or 100 Gbps?
- A. 0
- B. 1
- C. 2
- D. 3
正解:A
質問 # 27
You want to implement distributed firewall policies that micro-segment VM-to-VM traffic, including within the VLAN and same host. The VMs should be able to send traffic on permitted TCP ports, but other traffic should be dropped (hosts are isolated). What are two requirements? (Select two.)
- A. VLAN 10 is converted to a PVLAN on the switch only. The VMs are placed in an isolatedVLAN
- B. SVI 10 on the switch has IP local ARP proxy enabled on it
- C. The VMware host is configured to implement a local firewall
- D. VLAN 10 is converted to a PVLAN on the switch and VMware hosts. The VMs are placed in an isolated VLAN
正解:B、D
質問 # 28
......
HPE7-A04試験問題と有効なHPE7-A04問題集PDF:https://jp.fast2test.com/HPE7-A04-premium-file.html