売れ筋トップクラスのCTS-I最新試験問題2025年最新のAVIXA試験練習
AVIXA Certification問題集でCTS-I試験は完全版問題で試験学習ガイド
質問 # 48
A customer has recently added a second wireless microphone to an existing system. The customer now complains that the sound quality from both microphones has degraded. Of the following, which is the MOST LIKELY cause for the problem?
Response:
- A. The new wireless microphone shares a similar frequency as the old wireless microphone.
- B. The new wireless microphone is from a different manufacturer
- C. The old wireless microphone battery is dying.
- D. The existing wireless microphone is too old to be used with the new wireless microphone.
正解：A
質問 # 49
When working with fiber-optic cable, what is a major concern?
Response:
- A. Improper handling can lead to injury.
- B. It bends easily.
- C. It takes too much time.
- D. It is highly susceptible to loss of signal quality over distance.
正解：A
質問 # 50
Which mounting hardware will provide the MOST support when mounting a camera bracket to sheetrock/plasterboard not located near a wall stud?
Response:
- A. Self tapping screws
- B. Masonry bolts
- C. Plastic wall anchors / wall plugs
- D. Snap toggles / hollow wall anchors
正解：D
質問 # 51
What type of connector is shown in the following image?
Response:
- A. VGA
- B. XLR
- C. BNC
- D. RCA
正解：B
質問 # 52
When a customer adds a newer model display to an existing digital AV system what will impact the system the most and should be reviewed?
Response:
- A. The firmware version in the existing monitors should be updated
- B. The new display should have the exact same connections as the existing monitors
- C. The EDID table of the system should be reviewed and updated if necessary
- D. The color balance of the existing monitors should be redone
正解：B
質問 # 53
The picture below illustrates:
Response:
- A. A properly prepared connection for an RJ-45 termination
- B. A poorly prepared termination point for a DB-9 connection
- C. A poorly stripped cable for use with an G type connector
- D. A properly stripped cable for a linear compression BNC connector
正解：D
質問 # 54
How would a commissioning technician establish substantial completion/practical completion?
Response:
- A. Generate a list of all damaged equipment, setting up the DSP
- B. Generate a punch or defects list, getting architects to sign off on repairs
- C. Complete a request for changes form, filing an RFQ
- D. Complete all preliminary tests, confirm systems installation and readiness for final test
正解：D
質問 # 55
What does 1000Base-T refer to?
Response:
- A. IP speed of 100 Mbps
- B. Ethernet speed of 1 Gbps
- C. IP speed of 1 Gbps
- D. Ethernet speed of 100 Mbps
正解：B
質問 # 56
What type of termination technique is used for a BNC connector?
Response:
- A. Solder
- B. Insulation displacement
- C. Crimp
- D. Stab and twist
正解：C
質問 # 57
What are the limitations of a Wi-Fi network for streaming live HD video?
Select all that apply.
Response:
- A. Restrictions on range
- B. Expensive infrastructure
- C. Lower bandwidth than wired connections
- D. Potential RF interference
正解：A、C、D
質問 # 58
In the event of a change in the placement of air-conditioning ducts in a boardroom, which of the following documents should the AV integrator submit first?
Response:
- A. Request for information (RFI)
- B. Request for change (RFC)
- C. Punch list
- D. Change order (CO)
正解：A
質問 # 59
What assumptions should you make about an audio system when there is no audio output?
(Choose all that apply.)
Response:
- A. The gain on the main audio amplifier may be wound down to zero
- B. The user is a complete idiot and did not switch the microphone on.
- C. Make no assumptions at all and select a troubleshooting strategy
- D. The mixing desk channel for the microphone is switched to line input mode.
正解：C
質問 # 60
What document is used to account for lost time due to other trades during a project Response:
- A. Punch list
- B. Daily Progress report
- C. Submittals
- D. RFI
正解：B
質問 # 61
Before starting work in a finished space, it is recommended that the AV technician:
Response:
- A. Stack all the chairs in a corner of the room and move the tables
- B. Vacuum the room as to not get the new equipment dirty
- C. Turn on the air conditioner
- D. Document all existing conditions/damage within the room with pictures
正解：D
質問 # 62
Which statement accurately describes what you should do when de-installing existing equipment?
Response:
- A. Remove the connecting cables
- B. Smash the hardware so that data cannot be stolen
- C. Dispose of equipment right away
- D. Call an electronic waste recycling contractor
正解：A
質問 # 63
When working as a subcontractor to the electrical contractor who do you submit change orders to?
Response:
- A. The architect
- B. The owner
- C. The general contractor
- D. The project manager
正解：D
質問 # 64
At the end of the project, once installation and verification are complete, acceptance of the completed system is documented in a commissioning report and typically signed by:
Response:
- A. The contractor and/or the head of the technical staff
- B. The systems engineer and/or the head of the legal department
- C. The owner and/or the general contractor
- D. The head technician and/or the building architect
正解：C
質問 # 65
......
最善な方法で問題集を使おう！練習テストならこれAVIXA CTS-I：https://jp.fast2test.com/CTS-I-premium-file.html
CTS-I問題集を無料提供しております！試験問題と解答：https://drive.google.com/open?id=1qOOahx_sEeMjFqL12BWK_64LfsXjZWCR