Which CLI command is used to restart a software process?

• A. reboot
• B. reload
• C. commit
• D. restart

Which two statements are true regarding BGP path MTU discovery? (Choose two.)

• A. BGP path MTU discovery can be enabled only for IBGP sessions.
• B. BGP path MTU discovery must be configured on every router along the path.
• C. BGP path MTU discovery provides the most efficient use of link bandwidth.
• D. BGP path MTU discovery alleviates fragmentation problems.

-- Exhibit -[edit] user@R1# run show interfaces ge-1/1/2 terse Interface Admin Link Proto Local Remote ge-1/1/2 up up ge-1/1/2.0 up up aenet --> ae0.0
[edit] user@R1# run show interfaces ge-1/1/3 terse Interface Admin Link Proto Local Remote ge-1/1/3 up up ge-1/1/3.0 up up aenet --> ae0.0
[edit]
user@R1# run show interfaces ae0 terse
Interface Admin Link Proto Local Remote
ae0 up down
ae0.0 up down bridge
[edit]
user@R1# show interfaces ae0
aggregated-ether-options {
lacp {
periodic slow;
system-priority 200;
}
}
unit 0 {
family bridge {
interface-mode trunk;
vlan-id-list 100;
}
}
**************************************************************************
[edit]
user@R2# run show interfaces ge-1/1/2 terse
Interface Admin Link Proto Local Remote
ge-1/1/2 up up
ge-1/1/2.0 up up aenet --> ae0.0
[edit]
user@R2# run show interfaces ge-1/1/3 terse
Interface Admin Link Proto Local Remote
ge-1/1/3 up up
ge-1/1/3.0 up up aenet --> ae0.0
[edit]
user@R2# run show interfaces ae0 terse
Interface Admin Link Proto Local Remote
ae0 up down
ae0.0 up down bridge
[edit]
user@R2# show interfaces ae0
aggregated-ether-options {
lacp {
periodic fast;
system-priority 100;
}
}
unit 0 {
family bridge {
interface-mode trunk;
vlan-id-list 100;
}
}
-- Exhibit --
You have configured a LAG and are now enabling LACP on the ae0 interface. You have configured and committed the configuration as shown in the exhibit. However, the exhibit also shows that the ae0 interface is now in the up/down state.
What must you do to resolve this problem?

• A. Configure R1's LACP configuration as active.
• B. Configure both routers' ae0 LACP configuration to periodic fast.
• C. Change the LACP system-priority of R1 to 300.
• D. Configure R2's LACP configuration as passive.

Click the Exhibit button.
-- Exhibit -user@R1> show route 2.2.2.2
user@R1> show route forwarding-table destination 2.2.2.2
Routing table: default.inet Internet: Destination Type RtRef Next hop Type Index NhRef Netif 2.2.2.2/32 user 1 17.1.1.2 ucst 642 9 xe-1/1/0.0
-- Exhibit -
Referring to the exhibit, which statement is true about transit traffic sent to 2.2.2.2?

• A. R1 will reject the packet.
• B. R1 will redirect the packet to the Routing Engine.
• C. R1 will discard the packet.
• D. R1 will forward the packet.