CWDP-304試験問題集、CWDP-304練習テスト問題 [Q24-Q45]

CWDP-304試験問題集、CWDP-304練習テスト問題

PDF問題（2025年最新）実際のCWNP CWDP-304試験問題

質問 # 24
For an antenna 35 dBi of gain is needed. What antenna type should be used to achieve this gain?
Response:

A. Yagi
B. Dish
C. Horn
D. 4 dipole

正解：B

質問 # 25
Before performing a pre-deployment passive RF survey of a new deployment using survey mapping software, which of the following must be performed?

A. Checking client DTPC settings
B. Scaling the map
C. Selecting antennas
D. Determining AP transmit power

正解：B

質問 # 26
Name the audience type not addressed in this chapter for HLDs.
Response:

A. Operations
B. Engineering
C. Executives
D. Designers

正解：A

質問 # 27
Your new customer is concerned about maintaining privacy for their proprietary information when you conduct information gathering for their WLAN design. Which document can you use to directly address their concern?

A. Hold Harmless
B. NDA
C. SoW
D. BoM

正解：B

質問 # 28
What advantages are provided by per-user PSKs when compared with ESS-wide PSKs?(Choose all that apply.) Response:

A. Per-user PSKs are standardized and certified by the Wi-Fi Alliance.
B. Per-user PSKs allow easier user-based access control with WPA/WPA2-Personal security.
C. Per-user PSKs are more secure than ESS-wide PSKs because they support mutual authentication.
D. Per-user PSKs are easier to manage if a PSK is compromised or an employee leaves a company.

正解：D

質問 # 29
After designing a WLAN infrastructure using predictive design software. What's the best way to validate the predictive design in the physical space before deployment, if time and budget allow for it?
Response:

A. Perform an AP-on-a-Stick survey using AP locations based upon the predictive design to confirm each AP's placement.
B. Deploy all of the APs as they're shown in the predictive design and perform a passive site survey.
C. Deploy all of the APs as they're shown in the predictive design and perform an active site survey.
D. Use a client device positioned where the APs will be installed and measure the signal from the client device.

正解：D

質問 # 30
After designing a WLAN infrastructure using predictive design software. What's the best way to validate the predictive design in the physical space before deployment, if time and budget allow for it?

A. Use a client device positioned where the APs will be installed and measure the signal from the client device.
B. Deploy all of the APs as they're shown in the predictive design and perform a passive site survey.
C. Deploy all of the APs as they're shown in the predictive design and perform an active site survey.
D. Perform an AP-on-a-Stick survey using AP locations based upon the predictive design to confirm each AP's placement.

正解：D

質問 # 31
What are some advantages of designing guest access with all guest users tunneled directly into the DMZ?
Response:

A. The border firewall configuration will not require any additional rules to pass guest traffic to the DMZ controller
B. Minimizes configuration requirements for segmentation and filtering of guest traffic across internal LAN
C. Allows a single SSID with different authentication/encryption models to be used for all WLAN services for corporate users and guests
D. Enhances performance of web proxy servers in the DMZ for guest Internet traffic

正解：B

質問 # 32
What are some significant drawbacks that are present with WPA/WPA2-Enterprise that are not present with WPA/WPA2-Personal?(Choose all that apply.) Response:

A. WPA/WPA2-Enterprise often requires additional backend infrastructure components that are not required with WPA/WPA2-Personal.
B. WPA/WPA2-Enterprise always requires X.509 certificates for server authentication.
C. WPA/WPA2-Enterprise does not provide a way to perform per-user authorization and access control.
D. WPA/WPA2-Enterprise often requires more administrative overhead for configuration than WPA
/WPA2-Personal.
E. WPA/WPA2-Enterprise does not support the use of usernames/passwords for client authentication.

正解：A、D

質問 # 33
After deploying a 5 GHz-only WLAN infrastructure in the USA, using 20 MHz channel-widths and all 25 available channels, one of the managers of the company brings his 802.11n tablet to the office to test the Guest SSID. While testing, there were several spots where we would get poor RSSI (below -80dBM) or none at all. You checked the WLAN infrastructure and all APs are up and running and you've validated coverage after deployment. What is causing this issue?

A. His tablet doesn't support the 5 GHz band
B. His tablet doesn't support MU-MIMO
C. His tablet does not support one or more of the 5 GHz channels
D. His tablet only supports a 40 MHz channel-width

正解：B

質問 # 34
When designing a new WLAN infrastructure you also need to be aware of now the network is physically deployed and now the network is logically configured What are two documents that are helpful In this case?

A. Network Diagrams and Network Closet Locations
B. Blueprints and Network Closet Locations
C. Bill of Materials and Blueprints
D. Hold Harmless and Network Diagrams

正解：A

質問 # 35
Your customer requires a security solution in which client credentials are used and the authentication server must have a certificate with optional client certificate use. Which EAP method would be the best fit for their requirement?

A. LEAP
B. EAP-TTLS
C. EAP-TLS
D. EAP-FAST

正解：C

質問 # 36
You are validating association capabilities from clients to an 802.1X/EAP secure SSID. The RADIUS server's IP address is 10.100.50.25 and the default RADIUS authentication port is used. When testing them, none of the clients are able to associate to the SSID. Troubleshooting the WLAN infrastructure, you found out that the server is up and the RADIUS service is up as well, but the authenticator is not able to communicate properly with the server. What's your next troubleshooting step?

A. Verify that the shared secret between the authenticator and the RADIUS server is correct
B. Reboot the clients
C. Reboot the server
D. Restart the RADIUS service

正解：A

質問 # 37
During your first pre-deployment meeting with the deployment team, you hand out the full design documentation to all of them. What's your primary goal during this meeting?

A. To justify the budget.
B. To discuss AP functionality.
C. To explain design decisions and ensure understanding of design documents.
D. To explain how Wi-Fi works.

正解：C

質問 # 38
When live video streaming solutions that transmit simultaneously to more than one recipient are used, what special capability should be considered and configured in all affected WLAN implementations?

A. Secure TCP
B. IPSec
C. IPv6
D. Multicasting

正解：D

質問 # 39
When deploying APs outdoors, what additional component needs to be used that is not needed indoors?

A. Ethernet cables
B. Antennas
C. PoE
D. NEMA enclosures

正解：D

質問 # 40
When analyzing published competitive tests by equipment vendors, what items are the tests usually lacking?
(Choose all that apply.)
Response:

A. Client devices and configurations
B. Detailed configurations of each vendor's equipment
C. Detailed test methodology
D. Audit by a third party

正解：A、B、C

質問 # 41
What statements are true regarding jitter and latency?(Choose all that apply.) Response:

A. Latency is a measurement of the time required to transmit two subsequent frames.
B. Latency is a measurement of the time delay experienced in the delivery of a frame.
C. Jitter is a measurement of the variance of the number of frames received from an application for a specific time interval.
D. Jitter is a measurement of average latency based on a sample of >100 frames.
E. Jitter is a measurement of latency variability from one frame to another.

正解：A、E

質問 # 42
You have initiated a site survey to be performed and the team has been onsite and is halfway through gathering the necessary data.
The project sponsor just asked you to make sure the WLAN supports radio frequency identification (RFID) location tracking. How would you possibly characterize this situation?
Response:

A. Any WLAN will support location tracking.
B. The 802.3af RTLS standard should be incorporated into the AP configuration.
C. The power requirements on the UPS need to be evaluated.
D. Scope creep has occurred.
E. The 802.11g standard incorporates location tracking.

正解：D

質問 # 43
When creating a long-distance bridge link, it is important to know the channels in use by other networks on both ends of the link and within a reasonable range It is not as Important to know the channels in use in the middle area of the link. Why is this the case?

A. Your RF LoS will always be far above any interference in the middle because the signal travels up and then back down to the remote 802.11 receiver
B. Interference happens at the receiver
C. The signals in the middle of the link will increase the amplitude of your signal as it passes through them
D. interference happens at the transmitter

正解：A

質問 # 44
As a device starts to shift to lower PHY rates, what factors usually influence a device decision to shift to lower PHY rates?(Choose all that apply.) Response: