2025年最新のINSTC_V8問題集にはCabling Installation認証済み試験問題と解答 [Q38-Q61]

Share

2025年最新のINSTC_V8問題集にはCabling Installation認証済み試験問題と解答

実際に出ると確認されたINSTC_V8試験問題集と解答でINSTC_V8無料更新

質問 # 38
What method of transmission is used to transmit signals during a telephone call?

  • A. Simplex
  • B. Half-duplex
  • C. Full duplex

正解:C


質問 # 39
Which of the following may provide a demarcation point between the service provider and the customer premises cabling?

  • A. Work area
  • B. Telecommunications room
  • C. Telecommunications enclosure
  • D. Entrance facility

正解:D


質問 # 40
According to BICSI guidelines, which of the following best describes the maximum pulling tension recommended for a 4-pair UTP cable during installation (without using special pulling grips)?

  • A. 66 kg (145 lb)
  • B. 11 kg (25 lb)
  • C. 22 kg (50 lb)
  • D. 44 kg (100 lb)

正解:C


質問 # 41
Which of the following is permissible if the available firestop assembly is NOT capable of properly restoring the necessary fire rating?

  • A. Obtain written assistance from the manufacturer
  • B. Move the installation to another location
  • C. Substitute products from another assembly
  • D. Add more of the product to increase the rating

正解:A


質問 # 42
What is the maximum permissible amount of untwisting for category 5e cable and higher?

  • A. 38 mm (1.5")
  • B. 75 mm (3")
  • C. 12.7 mm (0.5")
  • D. 25 mm (1")

正解:C


質問 # 43
What is the minimum number of consolidation points that should serve an open office furniture cluster?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

正解:D


質問 # 44
What type of coaxial cable is used for video backbone distribution?

  • A. RG 58
  • B. Series 11
  • C. RG 59
  • D. Series 6

正解:B


質問 # 45
Which of the following fire ratings refers to the time period that a fire-rated assembly can resist flame passage?

  • A. T rating
  • B. W rating
  • C. F rating
  • D. L rating

正解:C


質問 # 46
You are installing a new equipment rack in a Telecommunications Room (TR). Which grounding practice aligns BEST with BICSI Installer 2 guidelines?

  • A. Connecting the rack directly to the nearest water pipe for grounding
  • B. Grounding the rack to the building's structural steel using a #8 AWG copper conductor
  • C. Bonding the rack to the telecommunications grounding busbar with a listed bonding conductor of appropriate size
  • D. Relying on the rack's anchor bolts into the concrete floor for grounding

正解:C


質問 # 47
When installing optical fiber cable in a cable tray with a 15 cm (6 in) inside depth, which of the following support practices is MOST appropriate to adhere to bend radius requirements?

  • A. Tie-wrap the cables tightly at every 30 cm (12 in).
  • B. Use Velcro straps and secure them at 2 m (6 ft) intervals.
  • C. Maintain at least twice the manufacturer's recommended bend radius by using fittings or supports at each transition point.
  • D. Place cables loosely along the tray without ties.

正解:C


質問 # 48
Which pair of a 100-ohm balanced twisted pair patch cable has a white-brown tip and a brown-white ring?

  • A. Pair 3
  • B. Pair 4
  • C. Pair 2
  • D. Pair 1

正解:B


質問 # 49
Which of the refers to a rule or set of rules intended to endure safety during the installation and use of materials, components, fixtures, systems, premises and related subjects?

  • A. Regulation
  • B. Code
  • C. Standard
  • D. Directive

正解:B


質問 # 50
Which of the following combinations is used to identify the tip conductors in Pair 1 of a 4-pair cable?

  • A. White-Orange
  • B. White-Blue
  • C. Brown-White
  • D. Green-White

正解:B


質問 # 51
When labeling patch panels, which of the following is MOST aligned with TIA-606 and BICSI best practices?

  • A. Use building zone references, omitting port identifiers
  • B. Only label the left-most and right-most ports
  • C. Assign labels based on random color coding for each port
  • D. Label each port sequentially by row (e.g., 1-24, then 25-48, etc.)

正解:D


質問 # 52
Which of the following terms describes the unwanted signal coupling from a disturbing pair of a 4-pair cable channel to a disturbed pair of another 4-pair channel?

  • A. ACRF - attenuation to crosstalk ratio far end
  • B. AXT - alien crosstalk
  • C. NEXT - Near end crosstalk

正解:B


質問 # 53
Which statement is TRUE about support systems for horizontal cabling according to BICSI and TIA/EIA standards?

  • A. Cable supports must be placed at intervals not exceeding 1.5 m (5 ft).
  • B. J-hooks are generally prohibited except in buildings over four stories.
  • C. Lashing cables to electrical conduits is acceptable in open ceilings.
  • D. The support system must integrate with the building's water piping.

正解:A


質問 # 54
What is the maximum number of work areas that a CP should serve?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

正解:B


質問 # 55
A third 90-degree bend may be permitted in a conduit run if one of the bends is located within ____ of the cable feed end?

  • A. 300 mm (12")
  • B. 375 mm (15")
  • C. 483mm (19")
  • D. 450 mm (18")

正解:A


質問 # 56
How long does it take someone to form a first impression?

  • A. 5 to 10 minutes
  • B. 1 to 2 minutes
  • C. 30 minutes to 1 hour
  • D. 10 to 15 seconds

正解:D


質問 # 57
Which of the following types of construction protects the optical fiber by supporting each strand of glass with a buffer coating extruded over the base optical fiber's 250 um acrylate coating?

  • A. Tight buffered
  • B. Loose tube
  • C. Single stranded
  • D. Ribbon

正解:A


質問 # 58
Which type of optical fiber cable should be color coded with a RED outer cable sheath?

  • A. Polarization maintain SM optical fiber
  • B. MM optical fiber with 50 um core diameter (laser-optimized)
  • C. MM optical fiber with 50 um core diameter
  • D. Dispersion-shifted SM optical fiber

正解:D


質問 # 59
Which term describes using an LC connector on a fiber cable for the main cable plant side, and SC connector for the equipment side, in the same patch panel adapter?

  • A. Mode mixing
  • B. Hybrid adapter coupling
  • C. Transitional attenuation
  • D. Duplex bridging

正解:B


質問 # 60
If a conduit run between two pull boxes has two 90-degree bends and measures 23 m (75 ft) total in length, what is the BEST way to comply with BICSI recommendations if you need to add a third 90-degree bend?

  • A. Replace the entire run with larger conduit
  • B. Add an appropriately placed pull box or intermediate point
  • C. Use a flexible metallic conduit for the final bend
  • D. Lubricate the conduit heavily and pull the cable in one continuous run

正解:B


質問 # 61
......

実際問題を使ってINSTC_V8問題集で100%無料INSTC_V8試験問題集:https://jp.fast2test.com/INSTC_V8-premium-file.html

INSTC_V8試験問題集、テストエンジン練習テスト問題:https://drive.google.com/open?id=1PO4fftSTe5MijPpQn1reDOoGN-bwh-Y5


弊社を連絡する

我々は12時間以内ですべてのお問い合わせを答えます。

我々の働いている時間: ( GMT 0:00-15:00 )
月曜日から土曜日まで

サポート: 現在連絡 

English Deutsch 繁体中文 한국어