[2023年04月] 今すぐダウンロード！リアルA10 Networks A10-System-Administration試験問題集テストエンジン試験問題
最新A10-System-Administrationテスト問題集を試そう！最新A10 Networks試験合格させます
質問 # 14
Device 1 is the vMaster in a virtual chassis. Select the command set that adds an IP address to VE interface
200 on device 3?
- A. interface ve 200 device 3 ip address 198.162.4.1 /24
- B. vcs device-context device 3 interface ve 200 ip address 198.162.4.1 /24
- C. interface device-context 3 interface ve 200 ip address 198.162.4.1 /24
- D. interface ve 3/200 ip address 198.162.4.1 /24
正解：D
質問 # 15
How are aVCS changes that are performed on the vMaster pushed to the vBlades?
- A. HA Sync needs to be done
- B. aVCS reload has to be performed
- C. Automatically
- D. VRRP-A should be failed over
正解：C
質問 # 16
Which of the following statements are true about Application Delivery Partitions?
1) The same virtual ethernet interface can be used by multiple private partitions
2) An untagged ethernet interface is visible only within the partition in which it is configured
- A. 1 is true; 2 is false
- B. 1 is false; 2 is true
- C. 1 and 2 are both true
- D. 1 and 2 are both false
正解：B
質問 # 17
In the following configuration:
Where network 3.0.0.x on each device is on a VE interface dedicated to aVCS traffic, what must you do to ensure that command "device-context x" always succeeds?
- A. Configure vcs floating-ip on network 3.0.0.0 /24.
- B. Verify the interface is untagged on each device.
- C. Apply acl "permit 3.0.0.0 /24" on that interface for each device.
- D. Enable management service ssh on that interface for each device.
正解：A
質問 # 18
When private partitions are created on a device where VRRP-A is enabled, which statement is true?
- A. VRID 0 is configured with its default settings.
- B. No VRIDs are configured on a private partition until explicitly configured.
- C. VRID 0 is configured with settings identical to VRID 0 on the shared partition.
- D. All VRIDs on the shared partition are replicated on the private partitions.
- E. VRRP-A is not available on private partitions.
正解：A
質問 # 19
Which statement describes the following configuration?
ACOS(config)# smtp 10.10.10.5
ACOS(config)# logging email emergency
ACOS(config)# logging email-address [email protected]
- A. The ACOS device is configured to send log messages by email.
- B. The ACOS device is configured to act as SMTP server to forward logging messages for other devices.
- C. The ACOS administrator's email is [email protected] where SNMP traps will be sent.
- D. Send logs related to 10.10.10.5 to email address [email protected].
正解：A
質問 # 20
Which statement correctly describes the result of the following commands?
ACOS(config)#logging host 192.168.216.45
ACOs(config)#end
ACOS#active-partition p1
Currently active partition: p1
ACOS[p1](config)#logging host 2.2.2.2
ACOS[p1](config)#logging host partition shared
- A. System logs generated from partition "p1" will be sent to logging server "2.2.2.2", as well as to the shared logging server's "192.168.216.45".
- B. System logs generated from partition "p1" will be sent to the shared logging server's "192.168.216.45".
- C. System logs generated from partition "p1" will be sent to logging server "2.2.2.2", and only warning severity log messages are sent to the shared logging server's "192.168.216.45".
- D. System logs generated from partition "p1" will be sent to logging server "2.2.2.2".
正解：A
質問 # 21
Given the following VRID 2 configuration, which device will host the VRID after the three devices at the same time?
- A. The VRID will be hosted on all three devices at the same time.
- B. Device 1
- C. Device 3
- D. Device 2
- E. VCS will randomly assign the VRID to a device based on the uptime of the device.
正解：B
質問 # 22
When vBlade A issues a "vcs vmaster-take-over 200" command, which statement is true?
- A. If an administrator on vBlade B were to simultaneously issue command vcs vmaster-take-over 210, vBlade B would become the vMaster.
- B. Any subsequent vmaster-take-over command within the chassis with a parameter smaller than 201 is ignored.
- C. The command is ignored when the current vMaster is in vMaster maintenance mode.
- D. The 200 priority is compared to the current vmaster's default vrid priority to determine which device controls the chassis.
正解：D
質問 # 23
In a VRRP-A topology that contains four devices, select the number of devices on which a single VRID can be simultaneously active?
- A. 0
- B. 1
- C. 2
- D. 3
正解：B
質問 # 24
You upgraded the boot image and changed the boot pointer to the new image using bootimage command.
Which of the following operations will load the new image?
- A. restore
- B. reload
- C. shutdown -r
- D. reboot
- E. restart
- F. system-reset
正解：D
質問 # 25
You are planning an Active-Active-Active VRRP-A three-device deployment that, upon failover of any device, distributes the load from a single device to both standby devices simultaneously. How many VRIDs are required?
- A. 0
- B. 1
- C. 2
- D. 3
- E. 4
- F. VRID Default is enough
正解：A
質問 # 26
......
A10 Networks A10-System-Administration（A10認定プロフェッショナルシステム管理4）試験は、A10 Networksソリューションの管理と設定におけるスキルと知識を検証したいネットワークプロフェッショナルやシステム管理者向けの認定試験です。この試験は、A10 Networksテクノロジーに取り組んだ経験を持ち、専門知識と資格を向上させたいプロフェッショナルを対象としています。
A10システム管理試験は、A10 Networksの高度なアプリケーションデリバリーコントローラー（ADC）技術、管理および監視ツール、セキュリティ機能、およびトラブルシューティング技術など、さまざまなトピックをカバーしています。候補者は、ネットワークの概念とプロトコルについての深い理解とともに、A10 Networksのハードウェアおよびソフトウェア製品の経験を持っていることが期待されています。
あなたを必ず合格させるA10-System-Administration問題集PDF2023年最新のに更新された32問あります：https://jp.fast2test.com/A10-System-Administration-premium-file.html