[2023年最新] 高合格率な最新無料350-401試験問題集アンサーを使おう
350-401知能問題集PDF！Cisco 350-401試験問セット
Cisco 350-401 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
| トピック 5 |
|
| トピック 6 |
|
| トピック 7 |
|
| トピック 8 |
|
| トピック 9 |
|
| トピック 10 |
|
| トピック 11 |
|
| トピック 12 |
|
質問 61
Refer to the exhibit.
An engineer configures monitoring on SW1 network engineer configures operation. What does the output confirm?
- A. SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15.
- B. RSPAN session 1 is incompletely configured for monitoring
- C. RSPAN session 1 monitors activity on VLAN 50 of a remote switch
- D. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.
正解: B
解説:
SW1 has been configured with the following commands:
SW1(config)#monitor session 1 source remote vlan 50 SW1(config)#monitor session 2 source interface fa0/14 SW1(config)#monitor session 2 destination interface fa0/15 The session 1 on SW1 was configured for Remote SPAN (RSPAN) while session 2 was configured for local SPAN. For RSPAN we need to configure the destination port to complete the configuration.
Note: In fact we cannot create such a session like session 1 because if we only configure -Source RSPAN VLAN 50 (with the command -monitor session 1 source remote vlan 50) then we will receive a -Type: Remote Source Session (not -Remote Destination Session).
質問 62
Which technology is used to provide Layer 2 and Layer 3 logical networks in the Cisco SD-Access architecture?
- A. easy virtual network
- B. underlay network
- C. VPN routing/forwarding
- D. overlay network
正解: D
解説:
質問 63
Refer to the exhibit.
What are two effect of this configuration? (Choose two.)
- A. Inside source addresses are translated to the 209.165.201.0/27 subnet.
- B. The 10.1.1.0/27 subnet is assigned as the inside global address range.
- C. The 209.165.201.0/27 subnet is assigned as the outside local address range.
- D. It establishes a one-to-one NAT translation.
- E. The 10.1.1.0/27 subnet is assigned as the inside local addresses.
正解: A,E
質問 64
Which JSON syntax is valid?
- A. Option B
- B. Option D
- C. Option C
- D. Option A
正解: C
解説:
Explanation
This JSON can be written as follows:
{
'switch': {
'name': 'dist1',
'interfaces': ['gig1', 'gig2', 'gig3']
}
}
質問 65
What it the purpose of the LISP routing and addressing architecture?
- A. It creates head-end replication used to deliver broadcast and multicast frames to the entire network.
- B. It allows multiple instances of a routing table to co-exist within the same router.
- C. It allows LISP to be applied as a network virtualization overlay though encapsulation.
- D. It creates two entries for each network node, one for its identity and another for its location on the network.
正解: D
質問 66 
Refer to the exhibit Drag and drop the snippets into the RESTCONF request to form the request that returns this response Not all options are used
正解:
解説:
質問 67
Refer to the exhibit.
The WLC administrator sees that the controller to which a roaming client associates has Mobility Role Anchor configured under Clients > Detail. Which type of roaming is supported?
- A. Layer 3 intercontroller
- B. Layer 2 intercontroller
- C. Indirect
- D. Intracontroller
正解: A
質問 68
How is the TCAM on a Catalyst switch used when VRF-Lite is configured?
- A. Each configured routing protocol receives its own Layer 3 TCAM
- B. Each configured VRF receives its own Layer 3 TCAM
- C. Layer 3 TCAM is not used in VRF-Lite configurations
- D. All configured VRFs share the Layer 3 TCAM
正解: D
質問 69
Drag and drop the characteristics from the left onto the correct infrastructure deployment types on the right.
正解:
解説:
質問 70
Drag and drop the DHCP messages that are exchanged between a client and an AP into the order they are exchanged on the right.
正解:
解説:
質問 71
Drag and drop the DHCP messages that are exchanged between a client and an AP into the order they are exchanged on the right.
正解:
解説:
質問 72
Refer to the exhibit.
A network engineer must simplify the IPsec configuration by enabling IPsec over GRE using IPsec profiles. Which two configuration changes accomplish this? (Choose two).
- A. Create an IPsec profile, associate the transform-set. and apply the profile to the tunnel interface.
- B. Apply the crypto map to the tunnel interface and change the tunnel mode to tunnel mode ipsec ipv4.
- C. Remove the crypto map and modify the ACL to allow traffic between 10.10.0.0/24 to 10.20.0.0/24.
- D. Remove all configuration related to crypto map from R1 and R2 and eliminate the ACL |>]
- E. Create an IPsec profile, associate the transform-set ACL. and apply the profile to the tunnel interface
正解: B,D
質問 73
Drag and drop me automation characteristics from the left onto the appropriate tools on the right.
正解:
解説:
質問 74
Drag and drop the threat defense solutions from the left onto their descriptions on the right.
正解:
解説:
Explanation
質問 75
Drag and drop the LIPS components on the left to the correct description on the right.
正解:
解説:
* Map server
* EID
* ETR
質問 76
Drag and drop the REST API authentication method from the left to the description on the right.
正解:
解説:
Explanation
質問 77
Refer to this output. What is the logging severity level?
R1#Feb 14 37:15:12:429: %LINEPROTO-5-UPDOWN Line protocol on interface
GigabitEthernet0/1. Change state to up
- A. Notification
- B. Critical
- C. Emergency
- D. Alert
正解: A
解説:
Syslog levels are listed below:
Number "5" in "%LINEPROTO-5- UPDOWN" is the severity level of this message so in this case it is "notification".
質問 78
Refer to the exhibit.
An engineer must ensure that all traffic leaving AS 200 will choose Link 2 as an entry point. Assuming that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers, which configuration accomplish task?
- A. Option B
- B. Option C
- C. Option D
- D. Option A
正解: D
解説:
Explanation
R3 advertises BGP updates to R1 with multiple AS 100 so R3 believes the path to reach AS 200 via R3 is farther than R2 so R3 will choose R2 to forward traffic to AS 200.
質問 79
Refer to the exhibit.
An engineer must deny HTTP traffic from host A to host B while allowing all other communication between the hosts. Which command set accomplishes this task?
- A. Option B
- B. Option C
- C. Option D
- D. Option A
正解: D
解説:
In this case we need to configure a VLAN access-map to deny HTTP traffic and apply it to VLAN 10. To do it, first create an access-list, by which interesting traffic will be matched. The principle of VLAN access-map config is similar to the route-map principle.
After this we'll create a vlan access-map, which has two main parameters: action and match. Match: by this parameter the interesting traffic is matched and here RACL or MAC ACL can be applied as well. Action: what to do with matched traffic. Two main parameters exist: Drop and Forward. In case of Drop, matched traffic will be dropped, and in case of forward, matched traffic will be allowed.
A good reference and example can be found at https://www.networkstraining.com/vlan-access-map-example-configuration/
質問 80
Drag and drop the Qos mechanisms from the left to the correct descriptions on the right
正解:
解説:
質問 81 
Refer to the exhibit. R1 is able to ping the R3 fa0/1 interface. Why do the extended pings fail?
- A. R3 is missing a return route to 10.99.69.0/30
- B. The DF bit has been set
- C. The maximum packet size accepted by the command is 1476 bytes.
- D. R2 and R3 do not have an OSPF adjacency
正解: B
解説:
Explanation
If the DF bit is set, routers cannot fragment packets. From the output below, we learn that the maximum MTU of R2 is 1492 bytes while we sent ping with 1500 bytes. Therefore these ICMP packets were dropped.
Note: Record option displays the address(es) of the hops (up to nine) the packet goes through.
質問 82
Which two southbound interfaces originate from Cisco DMA Center and terminate at fabric underlay switches? (Choose two)
- A. UDP 6007: NetFlow
- B. UDP 162: SNMP
- C. UDP 67: DHCP
- D. TCP 23: Telnet
- E. ICMP: Discovery
正解: A,E
質問 83
......
Cisco 350-401問題集PDFを使ってベストオプションを目指そう：https://jp.fast2test.com/350-401-premium-file.html
2023年最新の350-401サンプル問題は頼もしい350-401テストエンジン：https://drive.google.com/open?id=1spv4gmEwzLzZyRL-dMAVbHMlyBb8J5tJ