無料更新されたEMC D-NWG-FN-23テストエンジン問題には52問あります
ベストな問題集を使おうEMC Networking D-NWG-FN-23専門試験問題
質問 # 13
What are the correct steps to configure a static LAG on a Dell Networking OS10 switch?
- A. interface port-channel 4 no shutdown
interface range ethernet 1/1/14-1/1/15 channel-group 4 mode on - B. interface port-channel 4 channel-group 4 mode on
interface range ethernet 1/1/14-1/1/15 channel-group 4 mode passive - C. interface port-channel 4 no shutdown
interface range ethernet 1/1/14-1/1/15 channel-group 4 mode active - D. interface port-channel 4 channel-group 4 mode passive
interface range ethernet 1/1/14-1/1/15 channel-group 4 mode on
正解：A
質問 # 14
A network administrator is designing a Layer 2 topology and requires separate spanning-tree roots to avoid having a given port blocked for all instances. Which spanning-tree protocols will meet this need?
- A. STP & RSTP
- B. STP & RSTP-PV
- C. RSTP & MSTP
- D. RSTP-PV & MSTP
正解：D
質問 # 15
In a PIM Sparse Mode (PIM-SM) based multicast topology, what function does the Rendezvous Point provide?
- A. The root node of the source tree topology is used to provide routing between the source and receiver.
- B. The node is used to provide IGMP snooping across a layer 3 boundary.
- C. The root node of the shared tree topology is used to provide routing between the source and receiver.
- D. The node is used to provide IGMP snooping on a layer 2 shared segment.
正解：C
質問 # 16
An administrator is implementing VLT in OS10. What type of port-channel must they configure for the VLTi?
- A. Administrator needs to configure a LACP Port-Channel.
- B. Administrator needs to configure a static Port-Channel.
- C. Trunking and one (1) native VLAN need to be defined on the port-channel.
- D. None, a port-channel is created automatically during VLT discovery.
正解：D
質問 # 17
A customer has disabled LLDP on the management interface of the switch. What is the proper command to re- enable it?
- A. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp transmit OS10(conf-if-ma-1/1/1)#lldp receive
- B. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp med enable OS10(conf-if-ma-1/1/1)#lldp timer 10
- C. OS10(config)# lldp enable OS10(config)#lldp transmit OS10(config)#lldp receive
- D. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp tly-select OS10(conf-if-ma-1/1/1)#lldp dot1tlv
正解：A
質問 # 18
Match the QoS terms to their descriptions.
正解：
解説：
質問 # 19
A customer reports they can no longer access their services and a network administrator has been assigned to investigate. A UFD disabled error status appears on all ports. What caused the issue?
- A. Spanning tree Loop-guard was implemented on the uplink-state group.
- B. Both a port channel and its members were assigned to an uplink-state group.
- C. There was no issue; this is normal behavior.
- D. One of the upstream interfaces is an uplink-state group went down.
正解：A
質問 # 20
How does a DHCP Client make a request to a DHCP server following an offer?
- A. ACK
- B. Multicast
- C. Broadcast
- D. Unicast
正解：D
質問 # 21
What is an advantage of UFD?
- A. Reduces connectivity loss.
- B. Prevents the loss of upstream connectivity.
- C. Detects the loss of downstream connectivity.
- D. Reduces network complexity.
正解：B
質問 # 22
Two OS10 switches reside within a VLT domain with statically configured primary-priorities. The current primary peer, switch OS10-A, has a priority of 100, while the secondary peer, OS10-B, has a priority of 200.
If OS10-A reboots and comes back online, what roles will the VLT peers be assigned?
- A. OS10-A will be secondary and OS10-B will be primary.
- B. OS10-A will be secondary and OS10-B will be master.
- C. OS10-A will be standby and OS10-B will be primary.
- D. OS10-A will be primary and OS10-B will be secondary.
正解：A
質問 # 23
What is the function of the authentication service?
- A. Validates switch order
- B. Determines which services the user is enabled to access
- C. Determines switch management commands
- D. Validates the user identity
正解：D
質問 # 24
When creating an alias in OS10 what is the maximum number of variable input parameters that can be defined?
- A. 0
- B. 1
- C. 2
- D. 3
正解：B
質問 # 25
What is the default PIM-SSM IP range?
- A. 224.0.0.0/4
- B. 232.0.0.0/4
- C. 224.0.0.0/24
- D. 232.0.0.0/8
正解：D
質問 # 26
When configuring VRRP in tandem with VLT, what is the default VRRP mode?
- A. active-standby
- B. active-active
- C. master-backup
- D. primary-standby
正解：C
質問 # 27
Which configuration supports tagged frames on VLAN 20 and untagged frames on VLAN 5?
- A. interface ethernet 1/1/9
switchport trunk mode allowed vlan 20 switchport access vlan 5 no shutdown - B. interface ethernet 1/1/9 switchport trunk allowed vlan 20 switchport access vlan 5 switchport mode trunk
- C. interface ethernet 1/1/9 switchport mode trunk switchport trunk allowed vlan 20 switchport access vlan 5
- D. interface ethernet 1/1/9
switchport trunk mode allowed vlan 20 switchport access mode vlan 5 no shutdown
正解：C
質問 # 28
Refer to the exhibit.
What is the VRRP state of OS10-A after a router with a default VRRP admin priority with VRID100 comes online?
- A. primary-state
- B. standby-state
- C. master-state
- D. backup-state
正解：C
質問 # 29
Refer to the exhibit.
No static routing has been configured. For iBGP loopback-based peering, which statement is correct?
- A. It is not necessary for the routing table on S1 to have an entry for the loopback network of S3.
- B. For iBGP peering, physical interface addresses must be used.
- C. S1 should have the Loopback network of S3 in its routing table for loopback-based peering.
- D. A static route on S1 to 144.254.32.1/32 will eliminate the need for loopback-based peering with S3.
正解：C
質問 # 30
Which LSA types are used in a single area OSPF topology?
- A. 1 and 7
- B. 1, 2 and 5
- C. 2, 3 and 5
- D. 4, 5 and 7
正解：B
質問 # 31
How are ACLs processed?
- A. Randomly
- B. Sequentially
- C. FIFO
- D. LIFO
正解：B
質問 # 32
Refer to the exhibit.
The output shown is from which command?
- A. S3(config-router-ospf-1)# show ip ospf statistics
- B. S3(config-router-ospf-1)# show ip ospf topology
- C. S3(config-router-ospf-1)# show ip ospf lsa
- D. S3(config-router-ospf-1)# show ip ospf database
正解：D
質問 # 33
......
EMC D-NWG-FN-23 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
| トピック 5 |
|
100%の合格率を試そう！更新されたのはD-NWG-FN-23試験問題 [2024年更新]：https://jp.fast2test.com/D-NWG-FN-23-premium-file.html