検証済みHPE6-A69問題集と解答100%合格はここにFast2test
合格させるHPE6-A69試験一発合格保証2023問題集！
質問 36
(Scenarios may contain multiple errors which may or may not impact the solution) Refer to the Exhibit.
An engineer has attempted to configure two pairs of switches m the referenced configuration it Is required to implement Multi-Chassis Link Aggregation for each pair of switches The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows
The configuration includes:
There is an error message stating "mismatched group speed" What should you add to the configuration to correct the error?
- A. "speed 40-full" under interfaces 1/1/49 and 1/1/50
- B. "speed 10-full" under interfaces 1/1/12 and 1/1/13
- C. "allow-unsupported-transceiver
- D. "system Interface-group 1 speed I0g"
正解: B
質問 37
Refer to the exhibit.
A customer has implemented this ArubaOS-CX solution. NetEdit is not present. After a while, the secondary node of the VSX-cluster fails. What is the correct procedure to replace the failed node as quickly as possible?
- A. Replace the failed unit, connect the correct cables, boot up the new node and wait for VSX to synchronize configuration and firmware.
- B. Replace the failed unit, boot up the new node without connecting cables, upgrade firmware, and restore and save config Shutdown all ports, reconnect the correct cables, and enable all ports
- C. Replace the failed unit, connect the correct cables, boot up the new node in recovery mode, upgrade firmware and restore, and save config Then, reboot and wait for VSX to synchronize.
- D. Replace the failed unit, boot up the new node without connecting cables, upgrade firmware and configure as secondary vsx node connect iSl and wart for VSX to synchronize After successful recovery, reconnect the remaining cables.
正解: D
質問 38
ArubaOS-CX 8325 VSX configuration has a Tailed ISL link between the switches with keepalive status established. While troubleshooting the condition, what is the expected behavior of the VSX traffic flow in the current condition?
- A. VSX peer is seen as down
- B. VSX protection state is OK
- C. VSX nodes Keep forwarding traffic over its interfaces
- D. vsx tables are n sync
- E. VSX tables are out of sync
正解: C
質問 39
Before designing a new network solution for a customer with between 2398 and 5264 employees, you should gamer Information from the customer about their wired network needs.
What are valid questions to determine their wired network needs? (Select two.)
- A. What is the current cabling deployed in the location?
- B. How experienced is your networking team?
- C. How much do you plan to spend in the new wired network?
- D. Do you plan to add new customer services?
- E. What are the current device capabilities and topology?
正解: A,C
質問 40
An administrator warns to start a REST API session with an Aruba-OS CX switch Which HTTP method should the Administrator use to start a session?
- A. GET
- B. PUT
- C. LOGIN
- D. POST
正解: D
質問 41
What are the requirements for managing a switch using Aruba NetEdit? (Select two)
- A. HTTPS service must be restricted to the management VRF
- B. The switch user account mat NetEdit uses should have a password.
- C. Telnet must be disabled on the switch
- D. REST access-mode must be set to read-write.
正解: C,D
質問 42
The customer has a requirement for creating security filtering for IPv4 and IPv6 traffic passing through an ArubaOS-CX 6400 switch. Which statement Is true about access-list on the selected switch model?
- A. Separate IPv4 and IPv6 ACLs need to be created for inbound and outbound traffic
- B. Routed interfaces can have only inbound ACLs
- C. IPv4 and IPv6 entries can be used in one ACL with separate rules
- D. Only one inbound or outbound ACL can be bound to an interface.
正解: B
質問 43
When applying me following access-Iist to an ArubaOS-CX 6300 switch:
How does this ACL behave on the selected switch? (Select two.)
- A. The snmp-trap traffic to MANAGEMENT-SERVERS is logged to the event togs.
- B. The tftp traffic to MANAGEMENT-SERVERS group is not logged to the event logs.
- C. The denied tcp traffic to the MANAGEMENT-SERVERS group is not logged to event logs
- D. The denied tcp traffic to the MANAGEMENT-SERVERS group is logged to event logs.
- E. The mp traffic to MANAGEMENT-SERVERS group is logged to me event logs
正解: B,C
質問 44
You have created an OSPF neighbor configuration with ArubaOS-CX 8320 VSX and a third-party switch The OSPF peering falls. In the event togs you see the following entries.
2020-10-28:03:14 20.371489|hpe-routlng|LOG_WARN|AMM|1/5jOSPFV2|OSPFV2iOSPF 268698624 Packet received with unexpected authentication type
2020-10-28:03:14.20.371503|hpe-routing|LOG_WARN|AMM|1/5|OSPFV2|OSPFV2|Expected authentication type = 0 Which statement is true about the above events?
- A. The third-party switch should be configured with key chain authentication
- B. The third-party switch should be configured with MD5 authentication
- C. The ArubaOS-CX switch does not expect authentication with OSPF.
- D. The ArubaOS-CX switch requires plain-text authentication with OSPF.
正解: A
質問 45
(Scenarios may contain multiple errors which may or may not impact the solution ) Refer to the exhibit.
An engineer has attempted to configure two pairs of switches in the referenced configuration It is required to implement VSX at the aggregation layer The pons of the ArubaOS-CX 8325 switches used for Agg01 and Agg02 are populated as follows:
The configuration of switch AGG01 includes
The VSX cluster is not forming. Which modification should you make to resolve the error condition?
- A. Modify the system interface-group 4 speed tOg command change "25g" to "10g"
- B. Modify the keepalive peer 192.168 20.2 source 192 168.20 1 command, changing "vrf KA" to "vrf mgmt"
- C. Edit the vsx-sync command, adding "keep-alive"
- D. Modify the vsx definition, changing "inter-switch-link lag 2" to" inter-switch-link lag 256"
正解: A
質問 46
Which MAC address is valid for use as a VSX System-MAC address?
- A. 01:00:5E40:10.01
- B. 0A:00:00.00.00
- C. FF:00:00:00:00:00
- D. AB:00:04:00:FF:00
正解: B
質問 47
A client connected to Aruba CX 6300 on Port vt/2 Is having issues connecting to a remote destination 10 100
10 62 port 443. How should you get session-specific diagnostic information about this connection?
- A. Use diag utilities tcpdump desttnation-ip 10 10010.62 to capture the session
- B. Use diag utilities tcpdump destination-prefix 10 100 10.62/32 to capture the session
- C. Run tcpdump -interface "1/1/2" host 10.100 10.62 to capture the session
- D. Enter diag-mode and execute tcpdump ip.addr==10.100.10.62.
正解: B
質問 48
Refer to the exhibit.
Aruba CX 6300 switch has routes in three different VRFs as per the example above. The user needs to leak routes between VRF Secure and VRF Dev. and also between VRF default and VRF Dev The customer Is not able to establish routing between directly connected networks 10.100.50.0/24 and
10.102.26.0/24 Which statement is true regarding the routing troubleshooting?
- A. Route leaking is supported between non-default VRFs only
- B. Multi-protocol BGP routing needs to be defined for route leaking
- C. Route leaking between default and non-default VRFs is supported with Aruba CX 8400.
- D. Route Distinguisher needs to be set to 1 for default VRF.
正解: B
質問 49
Which statement is true regarding IP-SLA?
- A. ArubaOS-CX supports Doth SLA configuration through CU and by agents through the NAE.
- B. The default and minimum probe interval for voip SLA is 180 seconds
- C. ArubaOS-CX supports on-demand as well as forever tests.
- D. ArubaOS-CX supports forever tests
正解: D
質問 50
You have designed a new wired solution for a customer that uses gateways and Dynamic Segmentation Which statements about User-Based Tunneling are true? (Select two)
- A. In U8T, the switch performs user authentication.
- B. In UBT, the Aruba Gateway assigns the Primary user role
- C. in UBT, the Aruba Gateway performs user authentication
- D. in UBT, the switch sends user role Information to Aruba Gateway
- E. UBT is supported only with Aruba Gateway standalone
正解: C,E
質問 51
Which statement is true about NAE scripts'?
- A. The Health Monitor is the only script installed on the system by default.
- B. The System Resource Monitor and Health Monitor a/e the only scripts installed on the system by default
- C. The System Resource Monitor is the only script Installed on the system by default.
- D. No script is installed on the system by default.
正解: C
質問 52
Which statement is true regarding remote mirroring?
- A. Per session multiple destination addresses can be configured
- B. The same source/destination address can be used in multiple sessions.
- C. The ArubaOS-CX switch supports a maximum of two mirroring sessions
- D. When mirroring destination is tunnel, a DSCP value can be set on the tunnel
正解: A
質問 53
The rate-limiting QoS feature can be implemented on all ArubaOS-CX platforms However, some features are platform dependent. Which statements are true'' (Select two.)
- A. Multicast and broadcast rate limits cannot be applied at the same time on the same Interface
- B. Broadcast-rate limiting is supported on all ArubaOS-CX platforms
- C. Unknown unicast rate limiting is supported on all ArubaOS-CX platforms
- D. ICMP-Rate limiting is supported on all ArubaOS-CX platforms.
正解: A,D
質問 54
The customer is considering Implemented the following VSX configuration that will host an Aruba mobility cluster servicing 9000 dual stack employee devices.
The client's default gateways will be hosted on the VSX stack. The customer is seeking advice about how to ensure ArubaOS-CX VSX best practices have been applied.
What advice can you offer the customer? (Select two)
- A. The Keepalive interface should be changed to interface LAG2 so there is redundancy through the mobility cluster.
- B. Agg-1 and Agg-2's hardware forwarding table profile should be changed to "L3-agg''.
- C. The ISL Bandwidth should be upgraded
- D. The vsx linkup-delay timer is unnecessarily high; it should be reduced to prevent excessive delay of packet forwarding when a VSX peer joins an existing master.
- E. The keepalive subnet is misconfigured, it has an inappropriate address on Agg-1.
- F. The -system-mac' of Agg-1 should be changed to an unused address from the unicast private address range
正解: B,E
質問 55
......
HP HPE6-A69 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
| トピック 5 |
|
HPE6-A69問題集完全版解答試験学習ガイド：https://jp.fast2test.com/HPE6-A69-premium-file.html
リアルHPE6-A69は100%カバー率でリアル試験解答を試そう：https://drive.google.com/open?id=1SaTK4Jt8SzKCo2ilUdw2x-kk7XJXYfL4