最新 [2022年02月] 効果的な学習法でFast2testの問題集でNS0-176テストを合格せよ [Q60-Q77]

最新 [2022年02月] 効果的な学習法でFast2testの問題集でNS0-176テストを合格せよ

実績のある受験者のシミュレーションされたNS0-176試験PDF問題を試そう

質問 60
An administrator has a FlexPod solution configured for Microsoft Hyper-V 2012 R2. The hypervisor will be using CIFS shares for Cluster Shared Volume (CSV) datastores. A storage virtual machine (SVM) is configured, and a CIFS share is created for use.
When attempting to add the CSV datastore to the CIFS share, an error occurs and the datastore is not created.
Which three steps should the administrator perform to solve the problem? (Choose three.)

A. Configure the export policy with the Hyper-V host IP address.
B. Create multiple LIFs for CIFS Hyper-V traffic to enable ALUA.
C. Configure the ~-smb3-enabled~ parameter on the SVM.
D. Enable the "Continuous Availability" setting on the CIFS share.
E. Configure the "Enable Oplocks" setting on the CIFS share.

正解: A,C,E

質問 61
Which two statements about HA pairs in a NetApp cluster are true? (Choose two.)

A. In the event of a storage failover, the surviving node provides read/write access to the partner's disks until the failed node becomes available again.
B. Non-disruptive aggregate relocation can be performed between HA pairs without a takeover and giveback.
C. In the event of a storage failover, the surviving node always takes over the partner's data LIFs.
D. HA pairs in the same chassis are not connected to each other through an HA interconnect.

正解: A,C

質問 62
An administrator has a FlexPod solution with VMware vSphere 6.0. The VMware environment is using FCoE for storage connectivity for datastores.
Virtual machines running Windows Server 2012 R2 and RHEL have a requirement to use RDM LUNs for virtual machine storage. The administrator created an RDM LUN for a Windows 2012 R2 virtual machine and is currently creating an initiator group to map the LUN.
In this situation, which operating system should the administrator select for the initiator group?

A. Linux
B. Open VMS
C. Windows
D. VMware

正解: C

質問 63
Which type of pools do you need to create vHBA templates?

A. WWNN
B. MAC
C. WWPN
D. IQN

正解: C

質問 64
Which of the following tools is designed to inventory existing VMware vSphere, Linux, and Microsoft Windows Server versions in a customer environment?

A. Microsoft Assessment and Planning (MAP) Toolkit
B. Cisco UCS Central
C. Cisco Resource Comparison Tool
D. Cisco UCS Sizer for Enterprise Applications

正解: A

質問 65
Under which tab in UCS Manager would you create a boot policy?

A. Servers
B. LAN
C. SAN
D. Equipment

正解: A

質問 66
You want to verify that you have configured Multipath HA correctly for all of the attached disk shelves on a NetApp cluster.
Which two commands would you execute from the cluster CLI prompt to accomplish this task? (Choose two.)

A. node run -node * -command disk show
B. node run -node * sysconfig -a
C. sysconfig -a
D. node run -node * storage show disk -p

正解: C,D

質問 67
You are deploying a new virtual machine (VM). Your customer requires that the VM cannot reserve space on the VMFS filesystem, and the VM can only consume blocks when data is written to disk from and within the VM/Guest OS.
Which virtual disk should you create to meet these requirements?

A. Thick Provision Lazy Zeroed
B. Thick Provision Eager Zeroed
C. Independent Nonpersistent
D. Thin Provision

正解: D

質問 68
Which four items are required in order to create a Gold Master Boot LUN to automate the provisioning of Hyper-V hosts using the built-in LUN cloning capabilities of NetApp storage? (Choose four.)

A. SysPrep of the server operating system
B. Creation of a LUN for the Gold Master Boot LUN
C. Configuration of the Server OS and hotfix installation
D. Create additional virtual fibre channel (vfc) interfaces for the Nexus 5500
E. Creation of a service profile and zoning for Gold Master Boot LUN
F. Create a new interface group on the NetApp Cluster

正解: A,B,C,E

質問 69
Which two are required for single-wire management for Cisco UCS C-Series? (Choose two)

A. VIC 1240
B. UCS Manager 2.1 or higher
C. Redundant Nexus 2232PP FEX
D. 10 GB LOM
E. FI 6200 family only
F. VIC 1225

正解: B,F

質問 70
When creating a virtual machine in VMware vSphere 5.x, which type of virtual disk should be provisioned if you would like to fully pre-allocate storage with the highest chance of being contiguous?

A. Thick Provision Lazy Zeroed
B. Thin Provision
C. Thick Provision Eager Zeroed
D. Full Provision

正解: C

質問 71
Which two are characteristics of a Fibre Channel SAN data LIF? (Choose two.)

A. It can be associated with a WWPN.
B. It is associated with the administrative Vserver.
C. It can be associated with an IP address.
D. It is associated with the management LIF.
E. It can be associated with an Ethernet port or VLAN interface.
F. It can be associated with a Fibre Channel port.
G. It can be associated with an interface group (ifgrp).

正解: A,F

質問 72
When installing an instance of VMware ESXi on a UCS B-Series server, where should an ISO image be loaded?

A. The UCS vCenter Plugin must be used
B. From the UCS Manager select KVM Console, Select the Virtual Media tab, and select Add Image
C. Only physical install disks are supported on UCS B-Series servers
D. ISO images should not be used

正解: B

質問 73
A server administrator calls you complaining that an uplink on both UCS Fabric Interconnects went down. Each Fabric Interconnect has a vPC to the Nexus 500 switches.
After logging in to the switches, you notice that all vPC member ports on the secondary vPC peer switch are down. The vPC peer keepalive is still operational.
What is the problem in this scenario?

A. Both UCS Fabric Interconnects rebooted.
B. The vPC feature is disabled.
C. A new VLAN was added to the UCS vPC member ports.
D. The vPC peer link is down.

正解: D

質問 74
Your company has acquired a new NetApp EF600 storage array with a 25 Gbps HIC.
In this scenario, which FlexPod-supported protocol should be used to connect to this array?

A. iSCSI
B. NFS
C. FC
D. SMB

正解: A

質問 75
A customer with several large Cisco MDS 9718 switches wants to reduce the number of total zones and the number of commands required to add devices, while still adhering to best practices.
In this scenario, which two configurations should be implemented? (Choose two.)

A. Use the zone copy command to migrate existing zones.
B. Use the zone convert command to migrate existing zones.
C. Enable SMART Zoning for new VSANs.
D. Disable SMART Zoning for new VSANs.

正解: B,C

質問 76
You are asked to install the Virtual Supervisor Module (VSM) software on a Nexus 1000v switch.
Which two sources would you use to install this software? (Choose two.)