最新版を今すぐ試そう！[2025年02月] 試験準備には欠かさない！MTCNA問題集
有能な受験者がシミュレーション済みのMTCNA試験PDF問題を試そう
質問 # 26
To block communications between wireless clients connected to the same access point interface, you should set
- A. 'default-forwarding=no'
- B. 'max-station-count=1'
- C. 'default-authentication=no' and 'default-forwarding=no'
- D. 'default-authentication=no'
正解：A
質問 # 27
What PPP protocol provides dynamic addressing, authentication, and multilink?
- A. NCP
- B. HDLC
- C. LCP
- D. X.25
正解：C
質問 # 28
In which situations can Netinstall NOT be used to install a RouterBOARD?
- A. The router is connected only to a wireless network
- B. You do not know the password of the router
- C. The router does not have an operating system
- D. The router is connected only to a secondary Ethernet port
正解：A、D
質問 # 29
What command is used to create a backup configuration?
- A. copy running backup
- B. config mem
- C. copy running-config startup-config
- D. wr mem
正解：C
質問 # 30
Which command is used to determine if an IP access list is enabled on a particular interface?
- A. show interface
- B. show interface access-lists
- C. show ip interface
- D. show access-lists
正解：A
質問 # 31
How many wireless clients can connect, when wireless card is configured to mode=bridge?
- A. 0
- B. 1
- C. 2
- D. 3
正解：D
質問 # 32
What does the command routerA(config)#line cons 0 allow you to perform next?
- A. Shut down the router.
- B. Set your console password.
- C. Set the Telnet password.
- D. Disable console connections.
正解：B
質問 # 33
What is the main reason the OSI model was created?
- A. So different networks could communicate.
- B. To create a layered model larger than the DoD model.
- C. So application developers can change only one layer's protocols at a time.
- D. So Cisco could use the model.
正解：A
質問 # 34
You can not use OSPF and RIP routing protocols simultaneously on the RouterOS.
- A. FALSE
- B. TRUE
正解：A
質問 # 35
Which of the following protocols / port s are used for SNMP. (Simple Network Management Protocol)
- A. TCP 162
- B. UDP 161
- C. TCP 123
- D. TCP 25
- E. TCP 161
- F. UDP 162
正解：B、F
質問 # 36
When adding a static route, you must always ensure that you add both the gateway and the interface.
- A. False
- B. True
正解：A
質問 # 37
Which of the protocols below is used by Netinstall?
- A. dhcp
- B. rarp
- C. bootp
- D. arp
正解：C
質問 # 38
Which of the following describe the DHCP Discover message?
It uses FF:FF:FF:FF:FF:FF as a layer 2 broadcast.
It uses UDP as the Transport layer protocol.
It uses TCP as the Transport layer protocol.
It does not use a layer 2 destination address.
- A. 4 only
- B. 3 and 4
- C. 1 and 2
- D. 1 only
正解：C
質問 # 39
If a packet comes to a router and starts a new, previously unseen connection, which connection state would be applied to it?
- A. established
- B. new
- C. unknown
- D. no connection state would be applied to such packet
- E. invalid
正解：B
質問 # 40
Which of the following protocols / port s are used for SNMP. (Simple Network Managemnt Protocol)
- A. TCP 162
- B. UDP 161
- C. TCP 123
- D. TCP 25
- E. TCP 161
- F. UDP 162
正解：B、F
質問 # 41
Where can you monitor (see addresses and ports) real-time connections which are processed by the router?
- A. Queue Tree
- B. Firewall Connection Tracking
- C. Firewall Counters
- D. Tool Torch
正解：B、D
質問 # 42
Why is it useful to set a Radio Name on the radio interface?
- A. To identify a station in a list of connected clients
- B. To identify a station in Neighbor discovery
- C. To identify a station in the Access List:
正解：C
質問 # 43
What is necessary for PPPoE client configuration?
- A. Interface (on which PPPoE client is going to work)
- B. Static IP address on PPPoE client interface
- C. ip firewall nat masquerade rule
正解：A
質問 # 44
There are two routes in the routing table:
0 dst-addr=10.1.1.0/24 gateway=5.5.5.5
1 dst-addr=10.1.1.4/30 gateway=5.6.6.6
Which gateway will be used to get to the IP address 10.1.1.6?
- A. the required route is not in the routing table
- B. both - half of the traffic will be routed through one gateway, half through the other
- C. 5.6.6.6
- D. 5.5.5.5
正解：C
質問 # 45
......
検証済み材料を使うならまずMTCNAテストエンジンを試そう：https://jp.fast2test.com/MTCNA-premium-file.html
合格するに必要な問題集はMTCNA試験：https://drive.google.com/open?id=1dWxabnEjePQfPkPT0Yvs0UQE5Vy3D71C