最新の[2025年03月11日] 実際に出る検証済みの300-630問題集
合格させるCisco 300-630試験更新されたのは120問があります
質問 # 31
An engineer created a Cisco ACI environment in which multiple tenants reuse the same contract. The requirement is to prevent inter-tenant communication. Which action meets this requirement?
- A. Create the contract in the common tenant with the scope set to Global
- B. Create the contract in the user tenant with the scope set to Global and exported to other tenants
- C. Create the contract in the common tenant with the scope set to Tenant
- D. Create the contract in the user tenant with the scope set to VRF and exported to other tenants
正解：D
解説：
To prevent inter-tenant communication while reusing the same contract, the contract should be created in the user tenant with the scope set to VRF and then exported to other tenants. This approach allows the contract to be shared across tenants while maintaining the isolation of each tenant's VRF. By setting the scope to VRF, the contract's policies apply only within the context of the specified VRF, thus preventing communication between tenants5678.
References := Implementing Cisco Application Centric Infrastructure Official Cert Guide
質問 # 32 
Refer to the exhibit. A customer implements Cisco ACI Multi-Site with default MTU settings between two sites.
Which configuration should be applied on the interface Eth1/10 on the ISN-1 device?
- A.
- B.
- C.
- D.
正解：A
解説：
Section: Multisite
質問 # 33
An organization expands a Cisco ACI Multi-Pod from two to six pods and must ensure that the control plane scales. What should be configured in the IPN to ensure that BUM traffic is forwarded efficiently across the IPN?
- A. MP-BGP
- B. spine headend replication
- C. BIDIR-PIM
- D. MSDP
正解：C
解説：
Section: Multipod
Explanation/Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric- infrastructure/white-paper-c11-737855.html
質問 # 34
Which protocol is used to exchange the MAC/IP address information for endpoints between spine switches in different pods in a Cisco Multi-Pod solution?
- A. BGP VPNv4
- B. GRE
- C. MP-BGP EVPN
- D. IS-IS
正解：C
質問 # 35
What is a characteristic of a stretched bridge domain solution between Cisco ACI sites with Layer
2 flood disabled?
- A. The application profile that is associated to the bridge domain have local significance in each site.
- B. IP mobility is ensured between sites for disaster recovery.
- C. The tenant and VRF that associated to the bridge domain have local significance in each site.
- D. Headend replication is used for BUM traffic between sites.
正解：B
質問 # 36
Refer to the exhibit.
An engineer extends a Cisco ACI Multi-Pod setup to a Cisco ACI Multi-Site implementation. Which action allows the interconnection?
- A. Configure BIDIR-PIM in the IPN and ISN
- B. Filter the advertisement of the Site 2 TEP pool into the IPN
- C. Use dedicated uplinks on Site 1 spines for ISN connections
- D. Connect all spines to the IPN and ISN
正解：A
解説：
When extending a Cisco ACI Multi-Pod setup to a Multi-Site implementation, configuring BIDIR-PIM in both the IPN (Inter-Pod Network) and ISN (Inter-Site Network) is necessary. This allows for efficient multicast traffic routing between multiple pods and sites.
References: = Implementing Cisco Application Centric Infrastructure Official Cert Guide
質問 # 37
Drag and drop the tenant implementation designs from the left onto the outcomes of the design when a greenfield Cisco ACI fabric is deployed on the right.
正解：
解説：
質問 # 38
Which firewall connection allows for the integration of service nodes in transparent mode with a Cisco ACI Multi-Pod setup?
- A. active-active mode across pods
- B. active-standby mode across pods
- C. active-standby mode per pods for communication between endpoints and external networks
- D. active-active mode per pods for communication between internal endpoints
正解：B
解説：
The integration of service nodes in transparent mode with a Cisco ACI Multi-Pod setup is achieved by using an active-standby firewall mode stretched across pods. This configuration ensures that the standby node takes over if the active node fails, providing high availability and seamless operation. References := Cisco ACI Multi-Pod and Service Node Integration White Paper
質問 # 39
An organization expands a Cisco ACI Multi-Pod from two to six pods and must ensure that the control plane scales. What should be configured in the IPN to ensure that BUM traffic is forwarded efficiently across the IPN?
- A. MP-BGP
- B. spine headend replication
- C. BIDIR-PIM
- D. MSDP
正解：B
解説：
In a Cisco ACI Multi-Pod environment that is expanding, spine headend replication should be configured to ensure efficient forwarding of BUM (Broadcast, Unknown unicast, Multicast) traffic across the IPN (Inter-Pod Network). This configuration optimizes the control plane scaling and ensures that BUM traffic is handled effectively, maintaining network performance and stability.
References: Implementing Cisco Application Centric Infrastructure Official Cert Guide
質問 # 40
Refer to the exhibit.
A network engineer configures a Layer 4 to Layer 7 device for an outside routed firewall that is connected to POD-1 inside a Cisco ACI fabric that consists of two pods. All traffic from POD-1 or POD-2 that uses the L3Out should pass through the routed firewall. Which Function Type must be implemented in the service graph for POD-2 to use L3Out?
- A. GoTo
- B. GoThrough
- C. L1
- D. L2
正解：D
質問 # 41
Refer to the exhibit.
Server S1 is connected to Cisco ACI using two NIC interfaces. NIC1 is an active interface and NIC2 is a standby interface. NIC2 uses its MAC address to send traffic to the Cisco ACI fabric when NIC1 is offline.
The requirement is to update the IP address to use the MAC address of NIC2. Which action accomplishes this goal?
- A. Activate IP Data Plane Learning.
- B. Set L2 Unknown Unicat to Proxy.
- C. Enable GARP EP Move Detection
- D. Clear remote MAC entries.
正解：C
質問 # 42
What are two PBR characteristics of the Cisco ACI Active-Active Across Pods deployment mode in Cisco ACI Multi-Pod design? (Choose two.)
- A. Traffic is dynamically redirected to the firewall that owns the connection.
- B. This mode causes the traffic to flow asymmetrically
- C. Deployment occurs in transparent mode.
- D. The connection state is unsynchronized.
- E. Deployment occurs in go-to mode only.
正解：B、C
質問 # 43
A leaf receives unicast traffic that is destined to an unknown source, and spine proxy is enabled in the corresponding bridge domain. Drag and drop the Cisco ACI forwarding operations from the left into the order the operation occurs on the right.
正解：
解説：
Explanation:
Table Description automatically generated
質問 # 44
Refer to the exhibit. What must be configured to allow the PBR node (LB-int) to monitor the availability of the endpoint that is in the EPG server?
- A. Unicast Route disabled for client and server bridge domains
- B. PBR node tracking
- C. Endpoint Dataplane Learning
- D. Direct Connect in the service graph template
正解：D
解説：
https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric- infrastructure/white-paper-c11-739971.html
質問 # 45
What is a characteristic of application-centric design in Cisco ACI?
- A. EPGs represent different application tiers.
- B. It simplifies gradual migration from a traditional network.
- C. A bridge domain has only one subnet.
- D. One-to-one mapping between EPGs and bridge domains Is enforced.
正解：A
解説：
An application-centric design in Cisco ACI focuses on the application requirements and interactions between different application components. In this design, EPGs (Endpoint Groups) represent different application tiers, such as web, application, and database tiers. This approach allows for a more flexible and scalable network configuration that aligns with the application architecture, enabling policies to be applied based on the application's needs rather than the network topology. References := Implementing Cisco Application Centric Infrastructure Official Cert Guide
質問 # 46
An engineer must implement a full mesh Cisco ACI Multi-Site architecture. Which action must be taken on each spine to accomplish this goal?
- A. Configure Overlay Unicast TEP
- B. Configure BGP-EVPN Router-ID
- C. Configure Multi-Pod Data-Plane TEP
- D. Configure Overlay Multicast TEP
正解：B
解説：
https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric- infrastructure/white-paper-c11-739609.html
質問 # 47
Refer to the exhibit.
Which three actions should be taken to implement the vPC in the Cisco ACI fabric? (Choose three.)
- A. Select a common vPC interface policy group
- B. Select common interface profiles
- C. Select common switch profiles
- D. Select individual interface profiles
- E. Select individual switch profiles
正解：A、C、D
質問 # 48
......
今すぐ試そう2025年最新の無料更新されたCisco 300-630試験問題と解答：https://jp.fast2test.com/300-630-premium-file.html
300-630問題集PDFとテストエンジン試験問題：https://drive.google.com/open?id=1BGWOS2oveoc2t51s5nm4MmeouKthUrWI