合格目指せHPE0-V15試験最新のHPE0-V15試験問題集PDF 2022年更新
HPE0-V15試験問題集、365日更新無料サンプル
質問 49
Match the customer requirement to the appropriate HPE storage solution.
正解:
解説:
Reference:
https://h20195.www2.hpe.com/v2/GetPDF.aspx/4AA5-6078ENW.pdf https://assets.ext.hpe.com/is/content/hpedam/a50002410enw
質問 50
A customer is experiencing read cache hit ratios well below 80 percent on an HPE Nimble HF40 array Data is constantly being ejected from the Nimble array's First In First Out cache What should you recommend?
- A. Enable InfoSlght's Al-based cache optimization setting
- B. Turn off deduplication on affected volumes
- C. Turn on deduplication on affected volumes.
- D. Upgrade the SSD bundle to add more capacity.
正解: B
質問 51
A customer needs to integrate a new digital video surveillance solution into their existing environment and available network ports. The solution needs to include redundant hypervisor servers and a redundant SAN with a shared Fibre Channel attached storage array.
You plan to propose the following configuration:
2 HPE DL380 Gen10 servers with dual processors, 384 GB of memory, dual port 10 Gb NIC, and High Performance Fan Kit
1 HPE MSA 2050 Dual Controller Storage Array with 24x 1.8 TB 10 K SAS drives and 96x 7.2K NL drives
4 VMware vSphere Standard licenses
1 VMware vCenter Server Foundation licenses
5 year 24x7x4 support for all equipment
What must be added to the configuration to provide a complete solution? (Choose two.)
- A. 2 Aruba 8320 switches
- B. 2 HPE FlexFabric 5710 switches
- C. 2 HPE 10/25 Gb 2-port 622FLR-SFP28 CNA
- D. 2 HPE StoreFabric SN1200E 16 Gb Dual Port FC HBAs
- E. 2 HPE SN3000B switches
正解: D,E
質問 52
Match the Networking Product Family to the appropriate use case:
正解:
解説:
質問 53
Refer to the exhibit.
You observed some high temperature alerts on a switch shown in the middle rack of the exhibit. The cooling in the data center is following best practices for the layout in the exhibit. The switch is an HPE 5945 series switch, and all the fans are operating normally. The switch is racked so that its ports face the rear of the rack. The administrator noticed the fan modules have red handles.
What should the administrator do to resolve the issue?
- A. Add additional fan modules to the switch.
- B. Change the fan direction with the fan preferred direction command.
- C. Replace the fan modules with port-to-power fan modules.
- D. Replace the fan modules with power-to-port fan modules.
正解: B
質問 54
Which web service uses baste CRUD operations performed on resources using HTTP Post, Get. Put. Delete, and Patch?
- A. cURL
- B. REST
- C. CORBA
- D. SOAP
正解: B
質問 55
A customer needs to add storage capacity to a host In a remote branch office. They have limited IT resources, so the solution requires ease of integration at a low price point Which HPE Storage family best meets these needs?
- A. HPE NimbIe Storage
- B. HPE D3000 Enclosure
- C. HPE MSA Storage Array
- D. HPE 3PAR StoreServ
正解: C
質問 56
A system administrator is performing the BIOS/Platform configuration of a DL380 Gen10 servers You notice the amber health LED.
The health status of which solution components can be verified with embedded UEFI Diagnostics? {Select two.)
- A. FC HBA
- B. Power Supplies
- C. Primera node
- D. iLONAND
- E. Processor
正解: D,E
質問 57
Which HPE Proliant server should you recommend for a home office environment where the server will be located in the same office as the user?
- A. HPE DL20
- B. HPEXL170r
- C. HPE ML110
- D. HPE MicroServer
正解: C
質問 58
A customer is moving a server from a co-location facility back into their existing data center to comply with new internal policies on data management Due to budget constraints, the customer cannot purchase any additional switches and will need to use an existing end-of-row design with HPE FlexFabric switches While the server will be installed six racks away from the switches, the total cable run with cable management Is expected to be 35 m.
Which component should be selected when designing the 10 Gbps connectivity option for the server?
- A. QSFP28 Active Optical Cable
- B. SFP+ Active Optical Cable
- C. SFP+ 10G LC SR Transceiver
- D. SFP+ Direct Attach Copper Cable
- E. QSFP+ Active Optical Cable
正解: A
質問 59
You configured a port on an HPE FiexFabric 5900 series switch that is connected to a VMware ESXi server to support multiple VLANs interface Ten-GigabitEthernet 1/0/11 description server ESXiOl-ethl port link-type trunk port trunk permit vlan 50 port trunk permit vlan 2 port trunk pvid vlan 50 Given the configuration above, what should happen to any untagged traffic coming from the VMware ESXI host?
- A. It will be transmitted in vlan 50.
- B. It will be transmitted in vlan 1.
- C. It will be transmitted in vlan 2
- D. It will be dropped
正解: D
質問 60
A customer is facing high and unpredictable latency on an HPE ProLiant DL380 Gen10 server equipped with P408i-a controller Which tool can display an Array Diagnostic Report?
- A. HPE InfoSight
- B. HPE OneView
- C. Smart Storage Administrator
- D. UEFl Embedded Diagnostics
正解: C
質問 61
You need to create a dynamic bridge-aggregation group on a FlexFabric switch to ensure the ports are automatically configured with the applicable bridge-aggregation interface configuration Drag the steps on the left Into their appropriate order in the answer area on the right.
正解:
解説:
1 - Create the bridge-aggregation interface
2 - Set the link-aggregation mode within the bridge-aggregation interface
3 - Add the desired physical interfaces to the link-aggregation group
4 - Configure the bridge-aggregation interface with the desired VLANs within the bridge-aggregation interface
質問 62
Read the question, and then refer to the exhibit.
<Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.
The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.
What must you do to resolve this issue?
- A. Permit VLAN 20 on the interface.
- B. Configure the interface as an IRF port.
- C. Configure the PVID of the interface to be VLAN 20.
- D. Configure the interface as an access port.
正解: A
質問 63
A local state college is implementing a new VDI cluster to support computer and testing labs. They have the following requirements:
Three VMware ESXi Hosts, each with one AMD processor, 1 TB of RAM, 16 Gbps FC Dual Port HBA.
HPE Nimble AF20 with 17 TB usable capacity.
Integration into an existing HPE FlexFabric 5710 and HPE SN3000B Fibre Channel SAN switches.
The solution must fit in 7U of rack space. If the customer needs more capacity in the future, they will use scale-out growth.
Which server model should you recommend to this client?
- A. HPE DL380
- B. HPE DL385
- C. HPE DL360
- D. HPE DL325
正解: A
質問 64
A customer wants to optimize the performance of its storage array by moving data residing in one class of disks to a more appropriate class of disks based on data access patterns without manual intervention.
Which HPE storage technology/feature will meet the customer requirement when the data is stored on an HPE Primera storage?
- A. This is not supported
- B. Nothing needs to be done since this is part of the OS
- C. Enable Automated Tiering on the Storage Pool level
- D. Activate SSD read cache on volume level
正解: A
解説:
https://experistg.com/wp-content/uploads/2019/12/HPE-Primera-Technical-Whitepaper.pdf
質問 65
Refer to the exhibit.
Drag the correct protocols from the left to the appropriate area on the topology on the right.
正解:
解説:
質問 66
When configuring a single ProLiant Gen10 server, which embedded tool can be used to deploy a reliable and consistent configuration?
- A. Smart Update Manager
- B. HPE OneView
- C. Intelligent Provisioning
- D. HPE iLO Amplifier Pack
正解: C
質問 67
A customer needs to deploy an application on a newly-installed HPE ProLiant server, but they report that the server is not online. They call you for remote support. The IP address on the production network cannot be reached. You are evaluating the probable root causes of this issue.
According to the troubleshooting methodology, what are next two steps? (Select two)
- A. Run insight Diagnostics on the Server
- B. Use OneView to see f the server firmware is up-to-date
- C. Log in to iLO to see if the server hardware and NIC are online and configured correctly.
- D. Use Microsoft Remote Desktop or VNC to check the server's NIC and IP address configuration
- E. Remote console into the ToR switch to check the server's port configuration.
正解: A,C
質問 68
A client needs a data center network for a highly-virtualized server environment. They have the following requirements
* 25 Gb connectivity from the servers to the top-of-rack switches
* support for iSCSl storage
* lowest possible latency between their VM farms, which are contained In separate cabinets and connected to different top-of-rack switches within the data center
* support for Python script interpretation and open APIs
Which networking product line and architecture should you recommend?
- A. HPE FlexFabicc configured in a traditional two-tier architecture with 5950 switches at the core and 5940 access switches configured using IRF stacks per cabinet
- B. ArubaOS-Swrtch configured in a spine/leaf architecture with 5406R switches at the spine and 2930M leaf switches
- C. ArubaOS-CX configured in spine/leaf architecture with 8325 switches at the spine and leaf
- D. ArubaOS-CX configured in a spine/leaf architecture with 8325 switches at the spine and 8320 leaf switches utilizing VSX between cabinets
正解: B
質問 69
You are reviewing a series of MSA2052 storage designs for a customer's remote locations. Their largest remote site requires the highest possible level of internal data protection with at least 20 TB of storage. Which disk drive design is adequate for this site?
- A. 14 HPE MSA 2 TB drives, configured with RAID1
- B. 8 HPE MSA 2 TB drives, configured with RAID5
- C. 10 HPE MSA 2 TB drives, configured with RAID0
- D. 12 HPE MSA 2 TB drives, configured with RAID6
正解: D
質問 70
......
HP HPE0-V15 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
| トピック 5 |
|
| トピック 6 |
|
HPE0-V15問題集、あなたを合格させる認証試験：https://jp.fast2test.com/HPE0-V15-premium-file.html
まもなくセール終了！リアルHPE0-V15のPDF解答を使おう：https://drive.google.com/open?id=1FivAZaz_aM2dEPeYuLLaW876IjsKVnKF