リリースNetwork Appliance NS0-194更新された問題PDF
NS0-194問題集と練習テスト（190試験問題)
質問 26
You want to set up a FabricPool between an ONTAP cluster and Google Cloud Storage.
In this scenario, which two components are required to accomplish this task? (Choose two.)
- A. an Express Route
- B. a Certificate Authority (CA) certificate
- C. a service account access key
- D. intercluster LIFs
正解: B,D
解説:
Explanation/Reference: https://www.netapp.com/pdf.html?item=/media/17239-tr4598pdf.pdf
質問 27
A customer cannot create a new volume from OnCommand System Manager.
Which two clustered Data ONTAP daemons would be at fault in this scenario? (Choose two.)
- A. mqwd
- B. secd
- C. vldb
- D. bcomd
正解: B,D
質問 28
Which two statements describe ONTAP NVRAM? (Choose two.)
- A. ONTAP NVRAM is battery backed.
- B. ONTAP NVRAM is used as write cache.
- C. ONTAP NVRAM stores uncommitted writes.
- D. ONTAP NVRAM is used as read cache.
正解: B,C
解説:
Explanation/Reference: https://kb.netapp.com/Advice_and_Troubleshooting/Data_Storage_Software/ONTAP_OS/FAQ
%3A_Consistency_Point
質問 29
When a write from a SAN host is received, the information is written within a storage controller before going to RAID.
In this scenario, which two main components are used? (Choose two.)
- A. Flash Pool
- B. NVRAM
- C. system memory
- D. Flex Cache
正解: B,C
質問 30
After a storage administrator turned off IP fast path, all the NFS clients lost connectivity to the storage controller.
Which statement describes what happened in this scenario?
- A. All clients are in the local broadcast domain.
- B. The ARP cache Ss flushed when IP fast path disabled.
- C. No default gateway is configured.
- D. The NFS clients are using NFS over UDP.
正解: D
質問 31
You want to monitor and generate reports on a customer's IT infrastructure, including virtual and cloud-based components, even though the customer has not purchased or installed any ONTAP software.
In this scenario, which NetApp tool would be used to accomplish this task?
- A. OnCommand Unified Manager
- B. OnCommand System Manager
- C. OnCommand Workflow Automation
- D. OnCommand Insight
正解: D
質問 32 
In the AFF A200 shown in the exhibit, which port is a CNA port?
- A. e0c/0c
- B. |0|0|
- C. e0a
- D. 0a
正解: A
解説:
Explanation/Reference: https://docs.netapp.com/platstor/topic/com.netapp.doc.hw-2700-install-setup/GUID-FE4BD3C8-
3DB4-438A-A5CE-FEEF74AE8BAF.html
質問 33
You are planning to move to a newer clustered Data ONTAP version.
Which two resources should you review prior to the move? (Choose two.)
- A. IMT
- B. System Administration Guide for Cluster Administrators
- C. Software Setup Guide
- D. Upgrade Advisor
正解: A,D
質問 34
A customer asks what is the correct way to configure an ONTAP system for multi-tenancy. The customer wants to serve data and also protect data using SnapMirror from tenant A using network A and from tenant B using network B.
In this scenario, which statement is correct?
- A. Each node can only communicate with tenant A or tenant B, but not with both at the same time.
- B. The customer must set up two different IPspaces for the two tenants.
- C. This setup can only work if tenant A and tenant B use a shared network infrastructure.
- D. The customer must use different VLANs for the two tenants.
正解: C
質問 35
Which NetApp HCI component communicates with activeiq.solidfire.com and the Cloud Data Services portal?
- A. the NetApp Element software vSphere plug-in
- B. the NetApp Trident software
- C. the management node (mNode)
- D. the NetApp Element software Management Interface
正解: C
質問 36
Which two conditions would prevent a normal giveback operation? (Choose two.)
- A. The presence of a failed IOM module
- B. Active SnapMirror transfer
- C. The presence of failed disks
- D. Connected NFsv3 sessions
正解: A,C
質問 37
You have installed and configured SnapDrive for Windows on a Windows server. Using SnapDrive, you successfully created two LUNs that are connected to the same storage controller using iSCSI.
You later realize that Snap Drive is no longer enumerating one of the disks. In this scenario, what would be a symptom of this problem?
- A. The SnapDrive service account user is a local administrator on the Windows server.
- B. The disk does not appear In Disk Management.
- C. The SnapDrive service is not running.
- D. There is a Snapshot copy mounted to the Windows server in a (busy,LUN) state.
正解: D
質問 38
Referring to the exhibit.
A customer contacts you and asks for assistance in determining which ports can be used for a new broadcast domain on a clustered Data ONTAP 8.3.2 system.
The system is serving LUNs using the FC protocol and is in production.
However, for Ethernet traffic, it is not yet in production. The customer provides you the output of the network port show command.
Referring to the exhibit, which ports will be eligible to create a new broadcast domain without impacting production storage virtual machines (SVMs) serving FC LUNs?
- A. any port in the Default broadcast domain on node1 and node2
- B. any port in the cluster broadcast domain on node1 and node2
- C. any port on node2
- D. any port on model
正解: A
質問 39
You received the "CLUSTER ERROR: DISK/SHELF COUNT MISMATCH" AutoSupport message from an ONTAP cluster.
When analyzing this message, which two should be inspected? (Choose two.)
- A. drive paths
- B. drive firmware
- C. SAS cabling
- D. IOM firmware
正解: A,B
質問 40
A customer mentions that their Windows users cannot access clustered Data ONTAP 8.3.1 CIFS shares. The users see "access denied" on the Windows side.
Host name resolution is working and properly resolves IP to host name and host name to IP and the customer can ping using host name and IP. In this scenario, which statement describes the problem?
- A. The time on the controller is skewed by more than five minutes.
- B. iSCSI has been enabled on the SVM.
- C. NTP is not enabled on the clustered Data ONTAP 8.3.1 cluster.
- D. There is no proper route to the storage virtual machine (SVM) running the CIFS server.
正解: C
質問 41
When troubleshooting the delivery failure of an AutoSupport notification, you enter the autosupport history show command.
In this scenario, what information would you expect the command output to show? (Choose two.)
- A. size of the AutoSupport notification
- B. time of the last upgrade
- C. status of the delivery
- D. IP address of the destination
正解: B,C
質問 42
You observe cyclic redundancy check (CRC) errors on a network port from a node in the cluster.
Which two components would you consider reseating or replacing before you perform actions on the physical port where the errors are reported from the node? (Choose two.)
- A. cable
- B. SFP
- C. up-stream switch
- D. cluster interconnect switch
正解: A,C
質問 43
Which CIFS server configuration determines the domain controllers that a CIFS server uses?
- A. site membership
- B. enabled SMB versions
- C. trusted domains
- D. discovery mode
正解: A
質問 44
You receive the error shown below on a FAS2750 HA pair.
Mon Jun 24 00:27:30 UTC [NetappA: scsi_cmdblk_strthr_admin:
scsi.cmd.checkCondition:error]: Unknown device 0a.00.99: Check Condition: CDB
0x12: Sense Data SCSI:hardware error - (0x4 - 0x44 0x0 0x0) (0).
The system is cabled as shown in the exhibit.
What should you do to clear the error?
- A. Replace the controller of controller A.
- B. Replace the controller of controller B.
- C. Replace the cable connected to controller A's 0a port.
- D. Re-cable the system per the FAS2750 installation guide.
正解: A
質問 45
Exhibit:
You are provided output from the sysconfig -a and sysconfig -r commands of a MetroCluster cluster for disk switch 1:15.45 SN#J9YG1U3L, as shown In the exhibit.
Which two statements are true in this scenario? (Choose two.)
- A. The disk is located in switch3.
- B. The disk is located at the file3 site.
- C. The disk is located at the file2 site.
- D. The disk is in shelf 2 bay 13.
正解: B,D
質問 46
You have a FAS2240 system using Data ONTAP 8.2.1 7-Mode with CIFS share "cifs" on an NTFS security-style volume.
Which two permissions would be modified using Windows Explorer? (Choose two.)
- A. cluster permissions
- B. file permissions
- C. share permissions
- D. folder permissions
正解: A,C
質問 47
A customer has replaced both interconnect cables on a FAS3240 HA pair with IOXM because they were damaged. After replacing the cables, the customer receives the error shown below.
"HA interconnect port 1 of this appliance seems to be connected to port 2 on the partner appliance." In this scenario what is the cause of this error?
- A. The interconnect cables must not be replaced while the controllers are up and running.
- B. The interconnects are cross-cabled, you must connect c0a with c0a and c0b with c0b.
- C. You must issue the if config down . . . command followed by the if config up ... command for both ports, on both controllers, after replacing the cables.
- D. c0a and c0b are 10Gbit Ethernet ports which must not be used for the interconnect.
正解: B
質問 48
Exhibit:
Your customer has recently migrated from their FAS3140 system running Data ONTAP 7.3.7 to a FAS2552 system running Data ONTAP 8.2.3 7-Mode through the head upgrade process.
They are no longer receiving the weekly AutoSupport notifications and want to know why. The exhibit shows the AutoSupport options from the nodes that have the same settings.
In this scenario, which solution is correct?
- A. There is no reason on the FAS2552 side why the customer should not receive the AutoSupport notifications. They should investigate their mail server to troubleshoot this issue.
- B. In Data ONTAP 8.2, weekly AutoSupport notifications are no longer sent to all recipients to reduce the mail load. The customer should add their e-mail address to the autosupport. partner. to option.
- C. In Data ONTAP 8.2, the protocol for AutoSupport is changed to HTTPS by default, so the customer must have an HTTPS destination for the AutoSupport data.
- D. In Data ONTAP 8.2, weekly AutoSupport notifications are no longer sent to the autosupport.to recipient, but only to autosupport.partner.to and to autosupport.support.to. The customer needs to add their e-mail address to one of these options.
正解: D
質問 49
You are asked to replicate 15 of 20 volumes and the network configuration of your storage virtual machine to your other data center.
In this scenario, which NetApp technology should you use?
- A. SVM peering
- B. SnapMirror Synchronous
- C. SVM DR
- D. MetroCluster
正解: B
解説:
Explanation/Reference: https://www.netapp.com/pdf.html?item=/media/19369-tr-4832.pdf
質問 50
......
Network Appliance NS0-194 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
NS0-194試験問題集合格させるのは更新されたのは2022年年最新の認証済み試験問題：https://jp.fast2test.com/NS0-194-premium-file.html
ガイド（2022年最新）実際のNetwork Appliance NS0-194試験問題：https://drive.google.com/open?id=1zQJ-L1U2njuoUIafxmZF6TbTWHgopO46