A customer has a single-partition Power 720 running IBM i. They would like to install some additional adapters and implement 5 additional partitions. In addition to installing the adapters and configuring an HMC, what else is necessary?

• A. Create a new partition and profile for the original LPAR with only the resources the partition
  needs. Create partitions and profiles forth additional partitions.
  Delete the original partition.
  Suspend the existing partition.
• B. Configure the new partitions.
  Activate the new profiles to remove "required" features of the existing partition.
• C. Modify the profile of the existing partition and concurrently enable it.
  Resume the existing partition.
  Create partitions and profiles for the additional LPARs.
• D. Modify the existing partition profile to not "use all resources in system" and own only what it
  needs. Reactivate the profile.
  Create partitions and profiles for the additional partitions.

An optical drive is owned by a VIO Server and shared between multiple IBM i partitions as virtual optical devices.
An administrator wants to use the virtual optical device on an IBM i partition, but WRKHDWRSC *STG shows that the virtual IOP is "Inoperative."
After verifying that the device is correctly allocated to the partition, what action should be taken?

• A. In SST, IPL the virtual IOP and vary on the device
• B. On the HMC, modify the host partition profile so that the vSCSI adapter is configured for "Any client partition can connect".
• C. On the HMC, select the vSCSI adapter and, under the Advanced option, select the option to Recover the Adapter.
• D. Vary off the device on the partition which is currently using the optical drive.

In order to suspend an IBM i partition1 which hardware resources need to be virtualized?

• A. All disk resources
• B. All resources
• C. All SCSI resources
• D. All networking resources

A customer would like to implement a client Linux partition on their Power Systems server. There are no available physical network ports on the system.
In addition to configuring the virtual Ethernet adapters in a hosting IBM i partition, what must be configured to allow the client Linux partition to access the network?

• A. Link aggregation
• B. Promiscuous mode
• C. Schowler routes
• D. Network address translation

A customer is implementing a new POWER7 system that will run along with an older POWER5 system.
A new HMC has been purchased for the POWER7 system.
The older 7310-CR3 HMC for the POWER5 system will remain in service.
The customer wants the older 7310-CR3 provide back up to the new HMC.
What must be done prior to implementing the customer's requirements?

• A. Consult the HMC / Firmware Supported Combinations chart to obtain the proper firmware/HMC
  code levelsimplementthe firmware updates on the POWER5 and 7310-CR3 HMC first,
  Connectthe 7310-CR3 to the POWER7 system.
• B. Connect the new HMC to the POWER7 system and to the LAN.
  Use the "Transmit Service Information"dialog on the new HMC to update the 7310-CR3 with the
  new HMC code and firmware for the FSP.
  Update the firmware on the POWER5 system and connect the new HMC.
• C. Ensurethe POWER7 ESP is running in "Dual Mode"with the"Activated Level"setto supportthe
  POWER7 system and the "Deferred Level"set to support the POWER5 system.
  Connect the 731 O-CR3 with the "Deferred Level"password.
• D. Upgrade the POWER5 system firmware to the same fix pack level that the POWER7 system is
  running. Upgrade the 7310-CR3 to the latest version of HMC code.
  Connect both systems normally to the 7310-CR3